C0051 Steering Wheel Position Sensor
What it means
The stability control system has a problem with the sensor that measures which way and how far the steering wheel is turned. Some makers, GM especially, use C0 numbers with their own meanings, so confirm with a make-specific lookup.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Ask whether an alignment or steering work was done recently
- Run the steering angle sensor calibration with a scan tool
- Check the sensor reading with the wheels straight
Signs you may notice
- Stability control or traction control light on
- Stability control may be turned off
- Steering assist features may not work
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSteering angle sensor not calibrated after an alignment or steering repair
- CommonFaulty steering wheel position sensor
- PossibleWorn clock spring or wiring at the steering column
- PossibleWiring or connector fault
Typical repair once the cause is confirmed
Recalibrate the steering angle sensor; replace it if it still reads wrong.
Known on these vehicles
Common questions
What does C0051 mean?
The stability control system has a problem with the sensor that measures which way and how far the steering wheel is turned. Some makers, GM especially, use C0 numbers with their own meanings, so confirm with a make-specific lookup.
Can I drive with code C0051?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes C0051?
Common possibilities to test include: steering angle sensor not calibrated after an alignment or steering repair; faulty steering wheel position sensor; worn clock spring or wiring at the steering column; wiring or connector fault. A shop should confirm the cause before replacing parts.