Home › Symptom guides › Engine overheating
Running hot

Why is my engine overheating?

An overheating engine is one of the few problems where minutes matter. Driving while it's in the red can warp or crack expensive engine parts. Answer the questions below to see how urgent it is, the likely causes, and what to check once the engine has cooled.

Stop and get help right away if:
  • If the gauge is in the red, a red temperature light is on, or steam is coming from under the hood, pull over safely and turn the engine off.
  • Never open the radiator cap or coolant tank cap on a hot engine. Hot coolant under pressure can spray out and cause serious burns.
  • If the oil pressure light comes on too, or the engine starts knocking, shut it off right away.
  • If you see flames or smoke with a burning smell, get everyone out and away from the car and call for help.
Question 1

How hot is it running right now (or the last time it happened)?

On most cars the needle sits near the middle once the engine is warm. Some cars have only a light: red usually means hot, blue means still cold.

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

The engine may be overheating. Stop as soon as it's safeStop — don't drive it

What to do now: Pull over somewhere safe, turn the engine off and let it cool for at least 30 minutes. Then call for a tow or a mobile mechanic rather than restarting it.

Why: A gauge in the red or steam from the engine usually means it can no longer get rid of heat fast enough. Every extra minute of running can warp the cylinder head or blow the head gasket, turning a simple hose or fan repair into a major engine repair.

Possible causes: Low coolant from a leak; Cooling fan not working; Water pump, thermostat or burst hose; Head gasket failure.

A shop will usually test: Cooling system pressure test; Cooling fan and fan relay test; Combustion gas (block) test for a head gasket leak; Thermostat and water pump inspection.

Check the coolant level before driving againStop — don't drive it

What to do now: Don't drive it again until you've checked the coolant. With the engine fully cold, look at the overflow tank. If it's below MIN, top it up to the MAX line with the coolant type listed in your owner's manual, and have the cooling system checked before relying on the car.

Why: Low coolant is one of the most common reasons an engine runs hot, and it's easy to check safely once the engine is cold. The level tells you whether you're dealing with a leak or a problem with the fan, thermostat or pump.

Possible causes: Low coolant; Cooling fan problem; Thermostat or water pump.

A shop will usually test: Cooling system pressure test; Cooling fan test; Code scan for temperature sensor and fan codes.

Coolant may be leaking out, so the engine can't stay coolStop — don't drive it

What to do now: Don't drive it until the leak has been checked. Once the engine is cold you can top up the overflow tank to MAX with the right coolant, but since it has already run hot, have a mobile mechanic look at it or have it towed.

Why: The cooling system is sealed, so coolant usually only goes down when it's escaping somewhere. Once enough is lost, the engine can't move heat to the radiator and the temperature climbs. Fixing the leak early often means a hose, clamp or radiator repair rather than engine damage. A pressure test usually shows where it's coming from.

Possible causes: Leaking radiator hose or clamp; Leaking radiator; Leaking water pump; Worn radiator or tank cap.

A shop will usually test: Cooling system pressure test; Radiator cap pressure test; UV dye leak check.

Possible head gasket leak: coolant may be getting into the engineStop — don't drive it

What to do now: Don't drive it. Have it towed or have a mobile mechanic test it.

Why: Sweet-smelling white exhaust smoke, milky oil, or bubbles in the coolant tank all suggest coolant and combustion gases are mixing inside the engine. Driving on it can spread the damage, but catching it early often keeps the repair smaller. A shop will usually run a combustion gas test and a pressure test before recommending head work.

Possible causes: Blown head gasket; Warped or cracked cylinder head; Leaking oil cooler or intake gasket.

A shop will usually test: Combustion gas (block) test on the coolant; Cooling system pressure test; Cylinder leak-down test; Oil analysis for coolant.

Coolant may be escaping somewhere you can't seeStop — don't drive it

What to do now: Don't drive it until the cooling system has been pressure-tested. Not seeing a leak doesn't mean the coolant is safe to top up and forget. Once the engine is cold you can top up the tank, but have a mobile mechanic test it or have it towed.

Why: Some leaks only happen when the system is hot and under pressure, and the coolant evaporates before it can drip. Others leak inside the car or inside the engine. A pressure test usually shows where it's going.

Possible causes: Small leak that evaporates when hot; Leaking heater core; Internal leak (head gasket).

A shop will usually test: Cooling system pressure test; UV dye leak check; Combustion gas (block) test.

The radiator fan may not be doing its jobGet it checked in the next few days

What to do now: Until the cooling fan has been checked, only drive if you can avoid idling and stop-and-go traffic, and watch the temperature gauge the whole time. Get it checked within the next few days.

Why: At speed, air rushes through the radiator by itself. When you're stopped, the fan has to pull that air through. Running hot only in traffic and cooling off once moving is a classic sign that the fan isn't working properly. A shop will usually check the fuse, relay and wiring before replacing the fan motor.

Possible causes: Failed electric fan motor; Fan relay, fuse or wiring fault; Worn fan clutch (belt-driven fans).

A shop will usually test: Cooling fan motor and relay test; Code scan for fan circuit codes; Fan clutch inspection.

The radiator or coolant flow may not be keeping up under loadGet it checked in the next few days

What to do now: Avoid towing, long climbs and high speeds, and get the cooling system checked within the next few days.

Why: Under heavy load the engine makes the most heat, so a cooling system that's only partly working shows up first on hills, on the highway, or when towing. Common culprits restrict how much coolant flows or how much heat the radiator can release.

Possible causes: Partly clogged radiator; Thermostat not opening fully; Weak water pump.

A shop will usually test: Radiator flow and temperature check; Thermostat test; Water pump inspection.

Coolant may not be circulating: thermostat, water pump or trapped airStop — don't drive it

What to do now: Don't drive it until it's checked. Have it towed or have a mobile mechanic come to you.

Why: If the engine heats up within minutes, or the heater blows cold while the gauge is high, hot coolant isn't moving through the engine and heater the way it should. That will overheat the engine again on almost any drive.

Possible causes: Thermostat stuck closed; Failed water pump; Air trapped in the cooling system.

A shop will usually test: Thermostat test; Water pump inspection; Cooling system bleed; Hose temperature comparison with an infrared thermometer.

It may be a faulty temperature sensor or gauge, not real overheatingGet it checked in the next few days

What to do now: Get the temperature sensor and gauge checked within the next few days. Until a shop confirms the engine isn't really overheating, treat any high reading as real: watch for steam, smells or a heater that turns cold, and pull over if the needle reaches the red.

Why: A real overheating engine usually shows other signs, like steam, a sweet smell or a heater that turns cold. A needle that jumps around while everything else seems normal often means the sensor or its wiring is sending a bad signal. A shop can compare it with the real temperature.

Possible causes: Faulty coolant temperature sensor; Loose or corroded sensor wiring; Low coolant around the sensor.

A shop will usually test: Code scan and live temperature data; Infrared temperature check of the engine; Sensor and wiring test.

Treat it as possible overheating until it's checkedGet it checked in the next few days

What to do now: Before driving again, check the coolant level with the engine cold. Then have the cooling system checked within the next few days.

Why: Without clear signs it's hard to say whether the engine is truly overheating. Checking the coolant and getting a quick cooling system test is the safest way to avoid serious engine damage.

Possible causes: Low coolant; Cooling fan problem; Thermostat or sensor fault.

A shop will usually test: Cooling system pressure test; Code scan and live temperature data; Cooling fan test.

Related guides

Sources and references: AAA

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.