Home › Code lookup › P2311
Powertrain code · Ignition

P2311 Ignition Coil "D" Secondary Circuit

How urgent? Otherwise: Get it checked in the next few days

What it means

Ignition coil D isn't producing a proper high-voltage spark, or the spark is leaking away before it reaches the spark plug.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the spark plug and coil boot for wear, cracks or oil
  2. Swap the coil with another cylinder to see if the misfire follows it

Signs you may notice

  • Check engine light on
  • Engine misfire, shaking or rough running
  • Loss of power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing ignition coil D
  • CommonWorn spark plug or wide plug gap
  • PossibleCracked coil boot or plug wire
  • PossibleOil or water in the spark plug well

Typical repair once the cause is confirmed

Replace the worn spark plug and/or ignition coil.

Repair costInsufficient verified pricing for this vehicle and repair
Replace ignition coil. Prepare an itemized shop request.
Walk through it step by step: Engine sputters or misfires →

Common questions

What does P2311 mean?

Ignition coil D isn't producing a proper high-voltage spark, or the spark is leaking away before it reaches the spark plug.

Can I drive with code P2311?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2311?

Common possibilities to test include: failing ignition coil d; worn spark plug or wide plug gap; cracked coil boot or plug wire; oil or water in the spark plug well. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.