Home › Code lookup › P3425
Powertrain code · Engine

P3425 Cylinder 4 Deactivation/Intake Valve Control Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer is watching the cylinder 4 deactivation/intake valve control circuit and sees what looks like a broken or disconnected circuit. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 4.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the cylinder 4 deactivation/intake valve control circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and resistance of the part with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Fuel-saving cylinder shutoff may be disabled
  • Possible misfire, rough running or ticking noise

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the cylinder 4 deactivation solenoid
  • CommonBroken or chafed wire in the cylinder 4 deactivation/intake valve control circuit
  • CommonFailed cylinder 4 deactivation solenoid
  • PossibleBlown fuse or failed relay feeding the circuit
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the cylinder 4 deactivation solenoid.

Walk through it step by step: Check engine light on →

Common questions

What does P3425 mean?

The computer is watching the cylinder 4 deactivation/intake valve control circuit and sees what looks like a broken or disconnected circuit. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 4.

Can I drive with code P3425?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P3425?

Common possibilities to test include: unplugged, loose or corroded connector at the cylinder 4 deactivation solenoid; broken or chafed wire in the cylinder 4 deactivation/intake valve control circuit; failed cylinder 4 deactivation solenoid; blown fuse or failed relay feeding the circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.