P3470 Cylinder 9 Exhaust Valve Control Circuit Performance
What it means
The cylinder 9 exhaust valve control is not responding the way the computer expects. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 9.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the engine oil level and condition first
- Check for misfire codes on the same cylinder
- Command the solenoid with a scan tool and listen or watch for a response
Signs you may notice
- Check engine light on
- Fuel-saving cylinder shutoff may be disabled
- Possible misfire, rough running or ticking noise
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLow or dirty engine oil, or the wrong oil thickness
- CommonSticking cylinder 9 deactivation solenoid or clogged oil screen
- CommonStuck or collapsed deactivating lifter
- PossibleLow engine oil pressure
- PossibleWiring fault at the solenoid
Typical repair once the cause is confirmed
Correct the oil level and type first; if the code returns, replace the solenoid, and in some cases the lifter.
Common questions
What does P3470 mean?
The cylinder 9 exhaust valve control is not responding the way the computer expects. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 9.
Can I drive with code P3470?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P3470?
Common possibilities to test include: low or dirty engine oil, or the wrong oil thickness; sticking cylinder 9 deactivation solenoid or clogged oil screen; stuck or collapsed deactivating lifter; low engine oil pressure. A shop should confirm the cause before replacing parts.