Home › Code lookup › P3490
Powertrain code · Engine

P3490 Cylinder 12 Deactivation/Intake Valve Control Circuit Performance

How urgent? Get it checked in the next few days

What it means

The cylinder 12 deactivation/intake valve control is not responding the way the computer expects. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 12.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the engine oil level and condition first
  2. Check for misfire codes on the same cylinder
  3. Command the solenoid with a scan tool and listen or watch for a response

Signs you may notice

  • Check engine light on
  • Fuel-saving cylinder shutoff may be disabled
  • Possible misfire, rough running or ticking noise

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow or dirty engine oil, or the wrong oil thickness
  • CommonSticking cylinder 12 deactivation solenoid or clogged oil screen
  • CommonStuck or collapsed deactivating lifter
  • PossibleLow engine oil pressure
  • PossibleWiring fault at the solenoid

Typical repair once the cause is confirmed

Correct the oil level and type first; if the code returns, replace the solenoid, and in some cases the lifter.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P3490 mean?

The cylinder 12 deactivation/intake valve control is not responding the way the computer expects. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 12.

Can I drive with code P3490?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P3490?

Common possibilities to test include: low or dirty engine oil, or the wrong oil thickness; sticking cylinder 12 deactivation solenoid or clogged oil screen; stuck or collapsed deactivating lifter; low engine oil pressure. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.