P3491 Cylinder 12 Deactivation/Intake Valve Control Circuit Low
What it means
The computer is watching the cylinder 12 deactivation/intake valve control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 12.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the cylinder 12 deactivation/intake valve control circuit for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- Fuel-saving cylinder shutoff may be disabled
- Possible misfire, rough running or ticking noise
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonControl wire to the cylinder 12 deactivation solenoid shorted to ground
- CommonFailed cylinder 12 deactivation solenoid
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Fix any shorted wiring first; if the wiring tests good, replace the cylinder 12 deactivation solenoid.
Common questions
What does P3491 mean?
The computer is watching the cylinder 12 deactivation/intake valve control circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. Cylinder deactivation shuts off some cylinders while cruising to save fuel, and this circuit controls cylinder 12.
Can I drive with code P3491?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P3491?
Common possibilities to test include: control wire to the cylinder 12 deactivation solenoid shorted to ground; failed cylinder 12 deactivation solenoid; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.