Home › Code lookup › U0232
Network code · Network

U0232 Lost Communication With Side Obstacle Detection Control Module - Left

How urgent? Book a check when convenient

What it means

Other computers in the car have stopped hearing from the left blind spot module. It is part of the driver assistance features.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the left blind spot module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Driver assist feature may be turned off
  • Warning message on the dash

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonThe left blind spot module lost power or ground (blown fuse or bad ground)
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed left blind spot module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the left blind spot module; replace the module only after those test good.

Common questions

What does U0232 mean?

Other computers in the car have stopped hearing from the left blind spot module. It is part of the driver assistance features.

Can I drive with code U0232?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes U0232?

Common possibilities to test include: the left blind spot module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed left blind spot module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.