Home › Code lookup › U0233
Network code · Network

U0233 Lost Communication With Side Obstacle Detection Control Module - Right

How urgent? Book a check when convenient

What it means

Other computers in the car have stopped hearing from the right blind spot module. It is part of the driver assistance features.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage first
  2. Check the fuses, power and ground for the right blind spot module
  3. See which modules answer a scan tool to narrow down the break
  4. Inspect network wiring and connectors near the module

Signs you may notice

  • Driver assist feature may be turned off
  • Warning message on the dash

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonThe right blind spot module lost power or ground (blown fuse or bad ground)
  • CommonDamaged, corroded or loose network wiring or connector
  • CommonWeak battery or low system voltage
  • PossibleFailed right blind spot module
  • PossibleAnother module shorting out the network

Typical repair once the cause is confirmed

Restore power, ground or wiring to the right blind spot module; replace the module only after those test good.

Common questions

What does U0233 mean?

Other computers in the car have stopped hearing from the right blind spot module. It is part of the driver assistance features.

Can I drive with code U0233?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes U0233?

Common possibilities to test include: the right blind spot module lost power or ground (blown fuse or bad ground); damaged, corroded or loose network wiring or connector; weak battery or low system voltage; failed right blind spot module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.