Why is my car A/C blowing warm air?
Your car's A/C cools by pumping refrigerant through a compressor and a radiator-like condenser at the front of the car. Warm air usually means low refrigerant, a compressor that isn't running, poor airflow over the condenser, or a door inside the dash stuck on heat. A few questions will narrow it down.
- If the temperature gauge climbs toward the red, turn off the A/C, pull over safely and turn off the engine.
- If you smell burning or hear grinding from the engine when the A/C is on, turn the A/C off and leave it off until it's checked.
- Don't open or loosen any A/C fittings yourself. The system is under high pressure and refrigerant can cause frostbite and eye injuries.
Are you noticing any of these along with the warm air?
Full guide: every possible outcome
Prefer to read it all? Here's every result this guide can reach.
The engine is overheating. Cooling the engine comes before the A/CStop — don't drive it
What to do now: Turn off the A/C, pull over safely and switch off the engine. Have it towed or call a mobile mechanic.
Why: The A/C condenser and the engine radiator sit together and share the same cooling fans. When the fans or cooling system fail, the A/C turns warm and the engine overheats. Driving an overheating engine can cause serious engine damage.
Possible causes: Cooling fan not working; Low coolant from a leak; Broken or slipping belt.
A shop will usually test: Cooling fan and fan relay test; Cooling system pressure test; Belt inspection.
The A/C compressor or its clutch may be failingGet it checked in the next few days
What to do now: Turn the A/C off and leave it off. If the burning smell, squeal or grinding doesn't stop within a minute or so, pull over safely and switch off the engine. If it stops with the A/C off, have the system checked within a few days.
Why: A compressor that's seizing drags on the belt, which can make it squeal, smell hot, or even break. On many cars that same belt runs the alternator, power steering and water pump, so a seized compressor can become a bigger problem.
Possible causes: Compressor wearing or starting to seize; Worn compressor clutch or bearing; Worn or slipping belt.
A shop will usually test: Compressor and clutch inspection; Belt and tensioner inspection; A/C pressure test.
Not enough air may be flowing over the condenser when you're stoppedBook a check when convenient
What to do now: If the temperature gauge climbs above normal, turn off the A/C, pull over when it's safe and turn off the engine. Otherwise watch the gauge and book an A/C and cooling fan check when convenient.
Why: At speed, air rushes through the condenser and removes heat from the refrigerant. When you stop, the electric cooling fan has to do that job. If the fan is weak or the condenser is blocked, the A/C warms up at idle and cools again once you're moving.
Possible causes: Cooling fan not running or weak; Blocked or damaged condenser; Refrigerant level slightly off.
A shop will usually test: Cooling fan and relay test; A/C pressure test at idle; Condenser inspection.
Ice forming inside the system or a compressor shutting off are common causesBook a check when convenient
What to do now: Turn the A/C off with the fan on high for a few minutes when it goes warm. If it then cools again, mention that to the shop. Book a check when convenient.
Why: When the A/C starts cold and then fades, the part inside the dash that chills the air (the evaporator) may be icing over and blocking airflow, or the compressor may be shutting off as it gets hot. Both are common and fixable.
Possible causes: Evaporator icing up; Compressor clutch gap too wide or overheating; Low or incorrect refrigerant charge.
A shop will usually test: A/C pressure test; Compressor clutch inspection; Evaporator temperature sensor check.
A blend door inside the dash may be stuckBook a check when convenient
What to do now: Try changing the temperature from full hot to full cold on each side and listen for clicking behind the dash. Book a check when convenient.
Why: Cars with separate driver and passenger temperatures use small doors in the dash to mix hot and cold air. If one door's motor fails, that side stays stuck on warm while the other side cools normally.
Possible causes: Blend door motor (actuator) not working; Climate control needs recalibrating; Low refrigerant.
A shop will usually test: Blend door actuator test; Climate control scan; A/C pressure test.
A clogged cabin air filter or a blower problem is a common causeSafe to check yourself first
What to do now: Check the cabin air filter, usually behind the glove box, and replace it if it's dirty.
Why: The A/C may be cooling fine, but if little air comes out, the car still feels warm. A dirty cabin filter is the most common cause and is easy to change on most cars.
Possible causes: Clogged cabin air filter; Failing blower motor or resistor; Iced evaporator.
A shop will usually test: Blower motor and resistor test; Blower fuse and relay check; Evaporator inspection.
The compressor runs, but the system isn't cooling. Low refrigerant or a stuck blend door are common causesBook a check when convenient
What to do now: Set the temperature to full cold and recirculate, then book an A/C check that includes a pressure test and leak check.
Why: A running compressor means the electrical side is working. Warm air then usually means there isn't enough refrigerant to carry heat away, or something inside the dash is mixing in hot air.
Possible causes: Low refrigerant from a slow leak; Blend door stuck on heat; Worn compressor or expansion valve problem.
A shop will usually test: A/C pressure test; Leak detection with dye or an electronic detector; Blend door check.
The compressor isn't turning on. Low refrigerant, a fuse or the clutch are common causesBook a check when convenient
What to do now: Check the A/C fuse and relay in the fuse box (your owner's manual shows which), then book an A/C check.
Why: The A/C has a safety switch that won't let the compressor run if refrigerant pressure is too low. A blown fuse, failed relay or worn compressor clutch can also stop it. Without the compressor running, there's no cooling at all.
Possible causes: Refrigerant too low for the compressor to run; Blown A/C fuse or failed relay; Compressor clutch or pressure switch problem.
A shop will usually test: A/C pressure test; Compressor clutch power and gap check; Pressure switch test; Leak check.
Low refrigerant from a leak is a common causeBook a check when convenient
What to do now: Book an A/C check that includes finding the leak, not just a refill.
Why: When the compressor clicks on and off every few seconds, the system is often sensing pressure that's too low. Refrigerant doesn't get used up, so if it's low, it has usually leaked out somewhere. A pressure test confirms it before anything is added.
Possible causes: Slow leak at a hose, seal or fitting; Leaking condenser; Faulty pressure switch.
A shop will usually test: A/C pressure test; Leak detection with dye or an electronic detector; Evacuate and recharge to the correct amount after repair.
An A/C check is the best next stepBook a check when convenient
What to do now: Make sure the A/C button is on and the temperature is set to full cold, then book an A/C check when convenient.
Why: Most warm-A/C cases come down to low refrigerant, a compressor that isn't running, a fan problem or a stuck door in the dash, and a technician can test for each of them. Because the A/C shares fans and a belt with the engine, keep an eye on the temperature gauge and any burning smell until it's checked.
Possible causes: Low refrigerant; Compressor not running; Cooling fan or blend door problem.
A shop will usually test: A/C pressure test; Compressor and fan check; Leak check.
Related guides
Sources and references: AAA · Kelley Blue Book