Home › Symptom guides › Blue or gray smoke from exhaust
Leak, smell or smoke

Why is blue smoke coming from my exhaust?

Blue or blue-gray smoke from the tailpipe usually means engine oil is getting into the cylinders and burning. When you see it and how fast the oil level drops help show how serious it is. Answer the questions below to see possible causes and what to do next.

Stop and get help right away if:
  • If the oil pressure light comes on or the engine starts knocking, pull over and turn off the engine right away.
  • If heavy smoke is coming from under the hood rather than the tailpipe, pull over, turn off the engine and step away.
  • If the check engine light is flashing and the engine shakes, don't keep driving.
Question 1

When do you see the blue or gray smoke?

Have someone watch the tailpipe while you start the car and then press the gas, or check in a mirror. Blue smoke is easiest to see in sunlight.

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

The engine is burning a lot of oil and may be damagedStop — don't drive it

What to do now: Pull over and turn off the engine. Don't drive it any further. Have it towed to a shop.

Why: Heavy blue smoke with an oil light, knocking or rough running means the engine is losing oil fast or has internal damage. Running an engine low on oil can destroy it within minutes.

Possible causes: Engine very low on oil; Major internal engine damage; Failed turbocharger (turbo engines).

A shop will usually test: Oil level and pressure check; Compression and leak-down test; Turbocharger inspection on turbo engines; Code scan.

Worn valve stem seals are a common causeBook a check when convenient

What to do now: Check the oil level every couple of weeks and top it up as needed. Book a check when convenient.

Why: Valve stem seals keep oil from running down into the cylinders. When they harden with age, oil can seep past while the car sits, then burn off in a puff of smoke on startup. It's common on higher-mileage engines and usually gets worse slowly. A compression or leak-down test helps the shop tell seals from rings.

Possible causes: Worn valve stem seals or valve guides; Faulty PCV valve; Worn piston rings.

A shop will usually test: Compression test; Leak-down test; PCV valve check.

Oil may be getting past worn piston ringsBook a check when convenient

What to do now: Check the oil level weekly and top it up so it never runs low. Book an engine check when convenient.

Why: Piston rings seal the gap between the pistons and the cylinder walls. When they wear or stick, oil gets into the combustion chamber and burns, especially under load when you press the gas. Some engines are known for this.

Possible causes: Worn or stuck piston rings; Faulty PCV valve; Leaking turbocharger seals.

A shop will usually test: Oil consumption test; Compression and leak-down test; PCV system check.

The turbocharger may be leaking oilGet it checked in the next few days

What to do now: Check the oil level and top it up if needed. Have the turbo inspected within a few days, and avoid hard acceleration until then.

Why: A turbocharger spins very fast and is lubricated by engine oil. When its seals or bearings wear, oil leaks into the intake or exhaust and burns, mostly when the turbo is working hard. A failing turbo can get worse suddenly.

Possible causes: Worn turbocharger seals or bearings; Blocked turbo oil drain or PCV problem; Worn piston rings.

A shop will usually test: Turbocharger shaft play inspection; Intake and intercooler check for oil; PCV system check; Code scan; A shop will usually check the PCV system and turbo oil drain before replacing the turbo.

There may be too much oil, or some was spilled during the oil changeSafe to check yourself first

What to do now: Check the oil level on level ground with the engine off. If it's well over the full mark, have the extra drained before you drive it.

Why: Too much oil can get whipped up by the spinning crankshaft and pushed into the intake, where it burns. Oil spilled on the engine or exhaust during a change can also smoke for a short while. Both are usually simple to sort out once the cause is confirmed.

Possible causes: Oil overfilled; Oil spilled during the change; Oil filter or drain plug leaking onto the exhaust.

A shop will usually test: Oil level correction; Filter and drain plug leak check.

The engine is dangerously low on oilStop — don't drive it

What to do now: Don't drive it, and don't start the engine with the oil this low. If the oil light was on or the engine knocked, have it towed instead of starting it.

Why: An engine that's burning oil can use it faster than you'd expect. Once the level is very low, the engine's moving parts can lose lubrication and wear out or seize quickly.

Possible causes: Heavy oil burning; Oil leak; Missed oil changes.

A shop will usually test: Oil leak inspection; Oil consumption test; Engine noise and oil pressure check.

The engine is burning oil and needs to be checkedGet it checked in the next few days

What to do now: Top up the oil to the full mark and have the engine checked within a few days. Check the oil before every longer drive until then.

Why: Smoke all the time plus a dropping oil level means oil is reaching the cylinders steadily. The engine can run low on oil without warning, and burning oil also wears out spark plugs and the catalytic converter over time.

Possible causes: Worn piston rings; Worn valve stem seals or guides; PCV valve or turbocharger problem.

A shop will usually test: Compression and leak-down test; PCV system check; Oil consumption test; Spark plug inspection.

A small amount of oil burning or a PCV problem are possible causesBook a check when convenient

What to do now: Keep checking the oil level every week or two, and book a check when convenient.

Why: If the oil level stays steady, the engine isn't burning much yet. A sticking PCV valve can pull a little oil into the intake, and early seal wear can cause light smoke before oil use becomes noticeable.

Possible causes: PCV valve sticking; Early valve seal or ring wear; Oil leak onto the exhaust; Transmission fluid being burned (some older automatics).

A shop will usually test: PCV valve check; Oil leak inspection; Compression test.

Related guides

Sources and references: Firestone Complete Auto Care · SlashGear

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.