Is my car leaking brake fluid?
Brake fluid is clear to yellowish when new and turns amber or brown with age. It feels slick, like light oil, and has little smell. Because your brakes depend on it, a real brake fluid leak means the car shouldn't be driven, so we'll start with how the brakes feel.
- If the brake pedal sinks toward the floor, don't drive the car.
- If the pedal sinks while you're driving, pump it, apply the parking brake gradually and steer to a safe stop.
- If the red BRAKE light stays on with the parking brake released, don't drive the car.
How does the brake pedal feel?
Press it firmly with the engine running and the car in Park. A healthy pedal stops high and feels firm.
Full guide: every possible outcome
Prefer to read it all? Here's every result this guide can reach.
The brakes may be losing pressure. Don't drive the carStop — don't drive it
What to do now: Don't drive it. Have the car towed or call a mobile mechanic.
Why: A soft or sinking pedal means the brake system can't hold pressure, because fluid is escaping or air has gotten in. Together with a leak, this means braking could fail. The car isn't safe to use until it's repaired.
Possible causes: Leak at a caliper, wheel cylinder, line or hose; Master cylinder problem; Air in the brake lines.
A shop will usually test: Brake system leak inspection; Master cylinder test; Brake line, hose and caliper inspection; Brake bleed and pedal test after repair.
The red brake light with a leak can point to low brake fluidStop — don't drive it
What to do now: Don't drive it. Have the car towed or call a mobile mechanic.
Why: The red brake light comes on when the parking brake is set or when the fluid in the reservoir drops too low. With a leak, low fluid is the likely reason, and the next stage can be a pedal that sinks to the floor.
Possible causes: Low fluid from a leak; Very worn brake pads; Faulty fluid level sensor or parking brake switch.
A shop will usually test: Brake fluid level and leak inspection; Brake pad thickness check; Warning light circuit check.
A brake caliper or wheel cylinder may be leakingStop — don't drive it
What to do now: Don't drive it. Have the car towed or call a mobile mechanic.
Why: Each wheel has a caliper, or a wheel cylinder on drum brakes, that uses brake fluid to press the pads or shoes. A leak there drains fluid and can coat the pads, so that wheel brakes poorly. The pedal can go soft with little warning.
Possible causes: Caliper piston seal leaking; Leaking wheel cylinder (drum brakes); Loose bleeder screw or brake hose fitting.
A shop will usually test: Caliper and wheel cylinder inspection; Brake hose and fitting check; Pad or shoe contamination check; Brake bleed after repair.
A brake line or hose may be leakingStop — don't drive it
What to do now: Don't drive it. Have the car towed or call a mobile mechanic.
Why: Brake lines carry fluid under high pressure to each wheel. Steel lines rust from road salt, and rubber hoses crack with age. A leaking line can burst when you brake hard, causing a sudden loss of braking.
Possible causes: Rusted steel brake line; Cracked or worn rubber brake hose; Loose fitting.
A shop will usually test: Full brake line and hose inspection on a lift; Line replacement and brake bleed; Pedal test after repair.
The master cylinder or its reservoir may be leakingStop — don't drive it
What to do now: Don't drive it. Have the car towed or call a mobile mechanic.
Why: The master cylinder turns your foot pressure into brake fluid pressure. If it leaks outside or its seals fail inside, the pedal can sink and braking power drops. Brake fluid also eats paint, so bubbled or peeling paint below it is a clue.
Possible causes: Leaking master cylinder seal or line fitting; Cracked reservoir or loose cap; Spill from an earlier top-up.
A shop will usually test: Master cylinder and reservoir inspection; Pedal hold test; Brake line fitting check.
Fluid under the pedals could be from the brake or clutch systemStop — don't drive it
What to do now: Don't drive it until it's checked. Have it towed or call a mobile mechanic.
Why: The brake master cylinder, and on manual cars the clutch master cylinder, sit just in front of the pedals. A leak there can run back toward the pedal area. Both use brake fluid, and many cars share one reservoir, so either leak can lead to low brake fluid.
Possible causes: Leaking clutch master cylinder (manual cars); Leaking brake master cylinder or pushrod seal; Water or coolant.
A shop will usually test: Brake and clutch master cylinder inspection; Fluid identification; Pedal hold test.
Low brake fluid with no obvious cause should be treated as a leakStop — don't drive it
What to do now: Don't drive it until a technician has checked the brakes. Have it towed or call a mobile mechanic.
Why: The brake system is sealed, and the fluid level only drops slightly as pads wear. At or below MIN means very worn pads or fluid escaping somewhere you can't see, and braking can fail if it keeps dropping.
Possible causes: Hidden leak at a caliper, line or hose; Very worn brake pads; Master cylinder leaking into the brake booster.
A shop will usually test: Brake system leak inspection; Brake pad thickness check; Master cylinder and booster check.
The fluid you found may not be brake fluid, but have the brakes checkedGet it checked in the next few days
What to do now: Have the brakes inspected within the next few days so a shop can identify the fluid and confirm the brakes aren't leaking. Check the reservoir again before each drive until then.
Why: A full reservoir and a firm pedal are good signs, but they don't prove there's no leak. A slow leak can take time to lower the level. Other fluids near the wheels, like shock absorber oil or axle grease, can also look similar.
Possible causes: Leaking shock absorber or strut; Torn CV axle boot; Power steering or other fluid.
A shop will usually test: Fluid identification and leak inspection; Shock, strut and axle boot inspection; Brake inspection to rule out a leak.
The level may be dropping as the brake pads wear, but a leak needs to be ruled outGet it checked in the next few days
What to do now: Have the brakes inspected within the next few days. A shop will usually check pad thickness and look for leaks before deciding whether it's just pad wear. Don't top it up to MAX yourself before the inspection, as the level helps them judge.
Why: As brake pads wear thinner, the brake pistons sit further out and hold more fluid, so the reservoir level drops slowly over many months. That can be normal. A sudden drop, or any dampness near the wheels, is not, and from here it isn't possible to tell the two apart.
Possible causes: Brake pad wear; Slow leak not yet visible.
A shop will usually test: Brake pad thickness check; Brake leak inspection; Brake fluid condition test.
Treat it as a brake leak until someone checksStop — don't drive it
What to do now: Don't drive it until a technician has checked the brakes. A mobile mechanic can come to you, or have it towed.
Why: Without knowing whether the brake fluid is low or the warning light is on, it isn't possible to rule out a brake leak. Because brakes can fail suddenly when fluid runs low, it's safer to have them checked before using the car.
Possible causes: Brake fluid leak; Another fluid near the wheels.
A shop will usually test: Brake fluid level and leak inspection; Pedal test; Fluid identification.
Related guides
Sources and references: AAA · National Highway Traffic Safety Administration (NHTSA)