Home › Symptom guides › Car pulls to one side
Shaking

Why does my car pull to one side?

A car that pulls to one side usually has a tire, alignment or brake problem on one side that the other side doesn't. A slow drift that's been there for months is a different story from a pull that started suddenly. Answer the questions below to find the likely cause and how soon to deal with it.

Stop and get help right away if:
  • If the pull started suddenly with a bang, a thump or a corner sitting lower, pull over and don't drive it further.
  • If you smell burning or see smoke from a wheel, pull over, stop and let it cool. Don't touch the wheel.
  • If you have to fight the steering wheel to stay in your lane, slow down and get off the road safely.
Question 1

When does the car pull?

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

A flat or very low tire is likely pulling the carStop — don't drive it

What to do now: Pull over somewhere safe and stop. Put on the spare or call roadside assistance.

Why: A tire that's lost a lot of air drags on that side and pulls the car toward it. Driving on it can destroy the tire, damage the wheel and make the car harder to control.

Possible causes: Puncture from a nail or screw; Damage from a pothole or curb; Leaking valve stem or wheel rim.

A shop will usually test: Tire leak inspection and repair or replacement; Wheel inspection for damage; TPMS sensor check.

A suspension or steering part may have brokenStop — don't drive it

What to do now: Pull over safely and stop. Have the car towed or call a mobile mechanic to look at it where it is.

Why: A sudden hard pull with a bang, or a corner that sits low, can point to a broken coil spring, a broken or bent control arm, or a failed ball joint. These parts hold the wheel in place, so a failure can affect steering and braking.

Possible causes: Broken coil spring; Bent or broken control arm or tie rod; Failed ball joint.

A shop will usually test: Suspension and steering inspection on a lift; Spring, control arm and ball joint check; Alignment after repairs.

A brake may be sticking on that sideStop — don't drive it

What to do now: Pull over somewhere safe and let the brakes cool. Don't touch the wheel. Don't drive further until the brakes are checked. Have it towed or call a mobile mechanic.

Why: When a brake caliper or hose doesn't release fully, that wheel keeps braking lightly. The car pulls toward that side, the wheel gets very hot, and the brakes can overheat and stop working as well as they should. A shop will usually check the slide pins, piston and hose before deciding what to replace.

Possible causes: Sticking brake caliper; Collapsed brake hose; Parking brake not fully releasing.

A shop will usually test: Brake caliper and slide pin inspection; Brake hose check; Check each wheel spins freely on a lift.

A hit to a wheel may have knocked the alignment out or bent a partGet it checked in the next few days

What to do now: Have the alignment and front suspension inspected within the next few days. Drive gently until then. If you have to fight the steering wheel to stay in your lane, don't drive it; have it towed.

Why: A pothole, curb or accident can shift the alignment or bend a tie rod, control arm or wheel. Even a small bend can make the car pull and wear the tires quickly. If a part is bent, an alignment alone won't fix it, so a good shop will check for bent parts as part of the alignment.

Possible causes: Alignment knocked out; Bent tie rod or control arm; Damaged tire or bent wheel.

A shop will usually test: Alignment check with before-and-after readings; Steering and suspension parts inspection for bends; Wheel and tire inspection.

A pull when braking usually means one brake is working harder than the otherGet it checked in the next few days

What to do now: Have the brakes inspected within the next few days. Until then, brake early and gently, and leave extra following distance.

Why: When the brakes on one side grip harder or the other side grips less, the car turns toward the stronger side every time you stop. It can come from a sticking caliper, contaminated pads or a worn suspension part that shifts under braking.

Possible causes: Sticking or seized brake caliper; Brake pads contaminated with oil or brake fluid; Worn control arm bushings.

A shop will usually test: Brake inspection of both sides; Caliper and brake hose check; Suspension bushing inspection.

Pulling only under acceleration points to the drivetrain or its mountsBook a check when convenient

What to do now: Book an inspection of the engine mounts, axles and front suspension bushings.

Why: On front-wheel-drive cars, power going to the front wheels can tug the steering to one side, especially under hard acceleration. Worn mounts or bushings let parts shift under load and make this much stronger.

Possible causes: Worn engine or transmission mounts; Worn control arm bushings; Mismatched tires on the front.

A shop will usually test: Engine and transmission mount inspection; Suspension bushing inspection; Alignment check.

This may be the slope of the road, not the carSafe to check yourself first

What to do now: Test on a flat, empty parking lot. Drive straight slowly and loosen your grip on the wheel for a moment. If the car stays straight there, the road slope is a possible cause.

Why: Most roads are built slightly higher in the middle so rain drains off. That slope gently pushes cars toward the edge. A mild drift that only happens on some roads is often just that.

Possible causes: Road crown (slope); Slightly low tire; Alignment slightly off.

A shop will usually test: Alignment check.

A low tire may be why it's pullingSafe to check yourself first

What to do now: Inflate all four tires to the pressure on the driver's door jamb sticker, then see if the pull goes away.

Why: A tire with less air has more drag and a slightly smaller rolling size, so the car pulls toward that side. It's the simplest cause to rule out and the cheapest to fix.

Possible causes: Low tire pressure on one side; Slow leak; Alignment off as well.

A shop will usually test: Tire leak inspection; Alignment check.

A new or rotated tire may be causing the pullBook a check when convenient

What to do now: Go back to the tire shop and ask them to swap the two front tires side to side and check the alignment.

Why: Some tires are built slightly unevenly inside, which makes them roll toward one side. This is called tire pull or radial pull. It shows up right after tires are installed or moved, and swapping the front tires is a simple way to check for it.

Possible causes: Tire with built-in pull (radial pull); Mismatched front tires; Alignment off.

A shop will usually test: Swap front tires side to side and road test; Alignment check; Tire inspection.

Worn steering or suspension parts may be letting a wheel shiftGet it checked in the next few days

What to do now: Have the steering and front suspension inspected within the next few days. Drive gently until then.

Why: When tie rods, ball joints or bushings wear, the wheel can move out of position as you drive. That causes a pull that may come and go, along with clunks and uneven tire wear. A shop will usually check each joint for play on a lift before deciding which part needs replacing.

Possible causes: Worn control arm bushings; Worn tie rod ends; Worn ball joints.

A shop will usually test: Steering and suspension inspection on a lift; Tie rod and ball joint play check; Alignment after repairs.

Wheel alignment is a common cause of a steady pullBook a check when convenient

What to do now: Check all four tire pressures first. If they're correct, book an alignment check.

Why: Alignment is the angle of the wheels. It slowly drifts out with normal wear, bumps and potholes, and when the angles differ side to side the car pulls. Uneven tire wear and an off-center steering wheel often come along with it.

Possible causes: Alignment out of spec; Low or uneven tire pressure; Worn suspension parts.

A shop will usually test: Alignment check with printed before-and-after readings; Suspension inspection; Tire inspection.

Related guides

Sources and references: National Highway Traffic Safety Administration (NHTSA)

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.