Home › Symptom guides › Push-button start not working
Won't start

Why won't my push-button start work?

Push-button start depends on three things: the car detecting your key fob, the brake switch telling it your foot is down, and enough battery power to crank. A message on the dash or what happens when you press the button usually points to which one to check first. Answer the questions below to narrow it down.

Stop and get help right away if:
  • If you smell burning plastic or see smoke from the dash or under the hood, stop trying and step away from the car.
  • Don't press Start over and over with the engine cranking for long periods. Give it a minute between tries.
Question 1

What happens when you press Start with your foot on the brake?

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

The key fob battery may be lowSafe to check yourself first

What to do now: Hold the key fob right against the Start button (or put it in the backup spot your owner's manual shows) and press Start with your foot on the brake. Then replace the fob battery.

Why: The car looks for a weak radio signal from your fob. As the fob battery fades, the car stops detecting it from your pocket. Push-button cars have a backup spot where the fob can still be read with a dead battery.

Possible causes: Weak or dead fob battery; Signal interference; Damaged key fob.

A shop will usually test: Key fob signal test; Immobilizer code scan.

Your main key fob may be faulty or have lost its programmingBook a check when convenient

What to do now: Use the spare for now. Replace the main fob's battery first, and if it still isn't detected, book a dealer or locksmith visit to check or reprogram it.

Why: If the spare works, the car's key system is probably working and the problem is more likely in the main fob: a dead battery, internal damage, or a chip that's lost its pairing with the car.

Possible causes: Dead fob battery; Physical or water damage; Lost programming.

A shop will usually test: Key fob signal test; Key reprogramming or replacement.

The car's key detection system or its power may be the problemBook a check when convenient

What to do now: Move phones and chargers away, hold the fob against the Start button and try again. If it still isn't detected, have a dealer or locksmith come to you, or have the car towed to one.

Why: When neither fob is detected but both remotes work, the problem is more likely on the car's side: low car battery voltage, interference, or a faulty antenna or key control module.

Possible causes: Weak car battery; Signal interference; Faulty key antenna or control module.

A shop will usually test: Battery test; Code scan of the keyless and immobilizer systems; Key antenna check.

The car may not be sensing the brake, Park or an unlocked steering wheelSafe to check yourself first

What to do now: Press the brake pedal hard and hold it, move the shifter firmly into Park, then press Start. If the steering wheel is locked, gently turn it left and right while you press Start.

Why: As a safety feature, push-button cars won't crank unless they sense the brake pedal and Park (or the clutch on a manual). A light press or a shifter not fully in Park is a common reason nothing happens.

Possible causes: Brake not pressed firmly enough; Shifter not fully in Park; Steering lock engaged.

A shop will usually test: Brake switch check; Gear-position switch check.

A faulty brake light switch may be blocking the startGet it checked in the next few days

What to do now: Have the brake light circuit checked within the next few days, and don't drive the car until the brake lights work. Drivers behind you get no warning when you brake.

Why: The car uses the brake light switch to know your foot is on the pedal. If none of the brake lights come on, the switch is a common cause, though a fuse or wiring fault can do the same. A shop will usually check the fuse and wiring before replacing the switch. Either way the car won't let you start it, and drivers behind you get no warning when you brake.

Possible causes: Failed brake light switch; Blown brake light fuse; Loose switch or wiring at the pedal.

A shop will usually test: Brake light switch test; Brake light circuit and fuse check.

The starter, a weak battery or the Park switch may be the problemBook a check when convenient

What to do now: Try starting in Neutral with the brake pressed. If that doesn't work, try a jump start. If it still won't crank, have it towed or call a mobile mechanic.

Why: With the key detected and the brake working, the car is ready to crank, but the starter isn't turning the engine. That points to a battery too weak to crank, a gear-position switch not reporting Park, or a failing starter.

Possible causes: Weak battery; Gear-position (Park/Neutral) switch; Failing starter.

A shop will usually test: Battery load test; Starter circuit test; Gear-position switch check.

The car's main battery is probably deadSafe to check yourself first

What to do now: Use the metal key hidden inside your fob to open the driver's door, then jump start the car or use a battery booster.

Why: With no lights and no response, the car has no power to run the key system or the starter. The usual reason is a drained 12-volt battery, which many push-button cars have even if they're hybrid or electric.

Possible causes: Drained or dead 12-volt battery; Loose or corroded battery cable; Blown main fuse.

A shop will usually test: Battery load test; Charging system test; Parasitic draw test if the battery keeps dying.

The battery may be too weak to crank the engineSafe to check yourself first

What to do now: Check that the battery clamps are tight and clean, then try a jump start or a battery booster.

Why: Rapid clicking or flickering lights mean there's enough power to run the dash, but not enough to spin the starter. A weak battery can also cause key-not-detected messages because the key system needs steady voltage.

Possible causes: Weak or discharged battery; Corroded or loose battery terminal; Alternator not charging.

A shop will usually test: Battery load test; Alternator output test; Voltage-drop test on the battery cables.

The key system or fuel delivery may be stopping the engineBook a check when convenient

What to do now: Look for a flashing key or security light, and try the spare fob. If it still won't keep running, have the codes read or call a mobile mechanic.

Why: If the engine cranks or fires and then dies, the button and starter are working. The anti-theft system cutting fuel because it doesn't recognize the key is common, followed by fuel or idle problems.

Possible causes: Immobilizer not recognizing the key; Fuel delivery problem; Idle control or sensor problem.

A shop will usually test: Immobilizer code scan; Fuel pressure test; Code scan.

Related guides

Sources and references: Mazda · AA1Car

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.