Your 2007 Acura TSXproblems, repair costs and recalls
What we've documented about the 2007 Acura TSX: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Acura TSX
23 documented issues apply to 2007, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Harsh or late shifts, the engine revving between gears, a check engine light with transmission codes, or the car not wanting to move in Drive.
- Why it happens
- The five-speed automatic in the first-generation TSX can wear internally. Owners report failures roughly between 80,000 and 130,000 miles that needed a rebuild or replacement.
- What to do
- Check the transmission fluid level and condition and have the codes read. Change the fluid with genuine Honda ATF on schedule; if it is already slipping, get a transmission diagnosis before it leaves you stranded.
Power steering hose can leak onto the exhaust (recall)
- What you'll notice
- A burning oil smell, smoke from under the hood, or power steering fluid spots and a whining pump.
- Why it happens
- A power steering hose can crack and drip fluid onto the hot exhaust pipe, which can cause smoke and, in rare cases, a fire under the hood. Honda recalled these cars to replace the hose.
- What to do
- Check your VIN for open recalls. If you see smoke or smell burning oil, pull over, shut the engine off and have the car checked before driving again.
Free under recall 10V-174. Out of recall, owners report paying for a new hose, so ask for a written quote.
Engine can stall from a corroded engine computer (recall)
- What you'll notice
- The engine stalls while driving or will not start, sometimes with a check engine light.
- Why it happens
- Moisture can corrode the engine control unit, which can make the engine shut off without warning. Honda recalled these cars to inspect and replace the unit.
- What to do
- Check your VIN for open recalls. If the engine has stalled while driving, have it checked before driving again.
Free under recall 13V-093. Check the VIN first.
Some replacement accelerator pedals can bind (recall)
- What you'll notice
- The gas pedal is slow to come back up, so the engine does not drop back to idle when you let off.
- Why it happens
- A batch of replacement accelerator pedals sold as service parts could bind. Honda recalled cars that had one of these pedals installed.
- What to do
- If your accelerator pedal has ever been replaced, check your VIN for open recalls. If the pedal sticks, shift to Neutral, brake firmly and pull over.
Free under recall 19E-068. Only cars that had a replacement pedal installed are affected.
Stability control (VSA) or ABS unit failure
- What you'll notice
- The VSA, ABS and brake warning lights stay on, or braking feels uneven.
- Why it happens
- The ABS/VSA control unit and pump (modulator) can fail internally. Owners report it as one of the more expensive TSX repairs.
- What to do
- Have the codes read; low battery voltage or a wheel speed sensor can also set these lights. If the modulator itself has failed, a rebuilt unit can save money.
Steering rack leaking or failing
- What you'll notice
- Power steering fluid dripping near the front, a low fluid reservoir, steering that gets stiff or notchy, or a groan when you turn the wheel.
- Why it happens
- The hydraulic steering rack's internal seals wear out, usually after 75,000 miles or so, and the rack starts leaking or losing assist.
- What to do
- Top up with genuine Honda power steering fluid and have the leak traced. A leaking rack usually needs to be replaced, followed by a wheel alignment.
Rattle for a few seconds after a cold start
- What you'll notice
- A loud grinding or rattling noise from the engine for a second or two right after starting it cold, usually after the car has sat overnight.
- Why it happens
- The variable valve timing (VTC) actuator on the camshaft wears and rattles until oil pressure builds. It is a well-known weak spot on this Honda 2.4L engine.
- What to do
- It is not an emergency, but get it fixed. A worn actuator can lead to timing codes, and shops often check the timing chain and tensioner at the same time.
Timing chain stretch and tensioner wear
- What you'll notice
- A check engine light with camshaft timing codes (such as P0341), a rattle from the front of the engine, or rough running.
- Why it happens
- As the 2.4L engine ages, the timing chain stretches and the tensioner and guides wear, especially if oil changes were stretched out or the oil ran low.
- What to do
- Do not ignore timing codes. Have the chain stretch checked; replacing the chain, guides and tensioner before anything breaks is far cheaper than repairing engine damage.
A/C stops blowing cold
- What you'll notice
- The air conditioning suddenly blows warm air, sometimes after a clicking or grinding noise from the engine bay when the A/C is on.
- Why it happens
- The A/C compressor clutch or the compressor itself fails on many TSXs, and a failed compressor can send debris through the system. Leaking A/C hoses are another common cause.
- What to do
- Have the system checked with gauges before simply adding refrigerant. If the compressor has failed, the dryer and sometimes the condenser should be replaced with it so the new compressor does not fail early.
Rear brake caliper sticks
- What you'll notice
- Grinding or a burning smell from one rear wheel, a wheel that is much hotter than the others after driving, or the car feeling like it is dragging.
- Why it happens
- Rear caliper slide pins or pistons can corrode and seize, so the pad stays pressed against the rotor and wears both out quickly.
- What to do
- Have the rear brakes inspected soon. Replacing the stuck caliper, pads and rotors together, and lubricating the slide pins, fixes it.
Alternator failure
- What you'll notice
- A battery or charging warning light, dim or flickering lights, a dead battery that keeps coming back, or a whining noise from the engine.
- Why it happens
- The alternator is the most-reported part replaced on TSXs in owner surveys. On first-generation cars a leaking power steering pump can also drip onto the alternator and ruin it.
- What to do
- Have the charging system tested before replacing the battery again. If power steering fluid is leaking above the alternator, fix that leak too.
Starter failure
- What you'll notice
- A single click or nothing at all when you turn the key, slow or grinding cranking, or the car starting only some of the time.
- Why it happens
- The starter motor wears out, often past 100,000 miles. It is one of the most-reported repairs on the TSX.
- What to do
- Have the battery and cables tested first. If they are good and the problem keeps happening, replace the starter before it leaves you stranded.
Ignition coil failure and misfire
- What you'll notice
- A flashing or steady check engine light, rough idle, shaking, and loss of power, especially when accelerating.
- Why it happens
- Individual ignition coils wear out with age and heat and stop firing their cylinder.
- What to do
- Avoid hard driving with a flashing check engine light, since it can damage the catalytic converter. Have the misfire codes read and the bad coil replaced; replacing old spark plugs at the same time is common.
Water pump leak or bearing noise
- What you'll notice
- Coolant drips or a sweet smell near the passenger side of the engine, a grinding or whirring noise at idle, or the temperature gauge creeping up.
- Why it happens
- The water pump bearing and seal wear out, usually past 100,000 miles.
- What to do
- Watch the coolant level and temperature gauge. Replace the pump before it fails completely, and replace the accessory belt at the same time.
Power steering pump whine or groan when cold
- What you'll notice
- A whining or moaning noise right after a cold start that fades as the car warms up, often louder when turning the wheel.
- Why it happens
- The power steering pump can pull in air through a worn inlet O-ring, or the pump itself wears. Owners report fixes ranging from a new O-ring and fluid flush to a replacement pump.
- What to do
- Check the fluid level. Ask a shop to try the inexpensive O-ring and fluid flush first; replace the pump only if the noise continues or the steering gets heavy.
Air-fuel ratio sensor failure
- What you'll notice
- A check engine light, sometimes with slightly worse fuel economy or a failed emissions test.
- Why it happens
- The upstream air-fuel ratio (oxygen) sensor ages and gives slow or wrong readings.
- What to do
- Have the code read. Use a genuine or original-equipment sensor, since cheap ones often bring the light back.
Broken engine and transmission mounts
- What you'll notice
- A clunk when shifting into Drive or Reverse or when you accelerate, and more vibration in the cabin at idle.
- Why it happens
- The rubber engine and transmission mounts crack or collapse with age and mileage.
- What to do
- Have the mounts checked while someone shifts between Drive and Reverse with the brake held. Worn mounts are not dangerous right away but they strain other parts.
Front control arm bushings crack
- What you'll notice
- Clunking over bumps, a wandering feel on the highway, a shimmy when braking, or uneven tire wear.
- Why it happens
- The front compliance bushings and other rubber suspension bushings split as they age.
- What to do
- Have the front suspension inspected and get an alignment after any bushing or arm replacement.
Clunk from worn sway bar links
- What you'll notice
- A knock or rattle from the front or rear over small bumps, rough pavement or driveways.
- Why it happens
- The small links and bushings that connect the anti-roll bars to the suspension wear out.
- What to do
- This is a low-cost repair. Have the links checked during your next tire rotation.
Door lock actuator stops working
- What you'll notice
- One door, often the driver's, will not lock or unlock with the remote or switch, or it buzzes when you press the button.
- Why it happens
- The small electric motor in the door lock actuator wears out. Owners report replacing them, sometimes more than once.
- What to do
- Use the key or manual lock in the meantime and have the actuator replaced.
Dashboard or navigation lights go dark
- What you'll notice
- Gauge lights, the navigation screen backlight or switch lights on the center stack go dim or stop working.
- Why it happens
- Bulbs and solder joints on the circuit boards behind the gauges and the navigation controls fail with age.
- What to do
- It is mostly a nuisance. An electronics repair shop can often fix the board for less than a new part.
Clutch pedal clicks or groans
- What you'll notice
- On manual-transmission cars, a click or groan as you press the clutch pedal, often worse in warm weather.
- Why it happens
- Dry plastic pivot parts at the clutch pedal, or a worn clutch master cylinder, make noise as the pedal moves.
- What to do
- Lubricating the pedal pivots often fixes it. If the pedal feels soft or sticks, have the clutch master cylinder checked.
Exhaust leak at the manifold or flex pipe
- What you'll notice
- A ticking or puffing sound from under the hood, louder exhaust, or an exhaust smell.
- Why it happens
- The exhaust manifold, its joints and the flexible pipe crack or rust through with age.
- What to do
- Have the exhaust inspected. Leaks near the engine can let fumes into the cabin, so do not put it off.
Repair prices for your 2007 Acura TSX
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transmission
- Replace power steering rack and align wheels
- Replace pump inlet O-ring and flush fluid, or replace pump
- Replace VTC actuator (cam gear)
- Replace timing chain, guides and tensioner
- Replace A/C compressor, dryer and recharge
- Replace rear caliper, pads and rotors (one axle)
- Replace alternator
- Replace starter motor
- Replace ignition coil (one)
- Replace upstream air-fuel ratio sensor
- Replace water pump and drive belt
- Replace engine/transmission mounts (two)
- Replace front lower control arm compliance bushings
- Replace sway bar end links (pair)
- Replace door lock actuator
- Repair or replace navigation control board or gauge cluster lighting
- Lubricate pedal pivots or replace clutch master cylinder
- Replace VSA/ABS modulator
- Replace exhaust flex pipe or manifold gasket
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace power steering hoseNo charge if your vehicle is included
- Inspect and replace engine control unitNo charge if your vehicle is included
- Replace accelerator pedalNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…