Acura ZDXproblems, repair costs and recalls
Problems reported across 2010–2024. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Excessive oil consumption
- What you'll notice
- The oil level drops quickly between changes, sometimes a quart or more every 1,000 to 2,000 miles. The low oil or oil pressure light may come on before the next service is due.
- Why it happens
- Carbon can clog the oil control rings on the pistons of the 3.7L V6, so oil gets past the rings and burns in the cylinders. Acura issued service bulletins and a warranty extension on 2009-2014 vehicles with this engine.
- What to do
- Check the dipstick every fill-up and keep the oil topped up, because running low can ruin the engine. Ask an Acura dealer to run an oil consumption test and check whether any extended coverage applies to your VIN.
Low compression from out-of-round cylinders
- What you'll notice
- Rough running, a misfire, a flashing or steady check engine light, and weak power.
- Why it happens
- Acura issued a bulletin for some 2013 MDX, ZDX and TL engines whose cylinder bores were out of round, which causes low compression. The repair can require a new engine block.
- What to do
- Have a compression test done if a misfire won't go away with new plugs or coils. Ask the dealer whether your engine falls under the bulletin.
Passenger airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. You may have received a recall letter.
- Why it happens
- The Takata passenger front airbag inflator can break apart after years of heat and humidity and spray metal fragments in a crash.
- What to do
- Ask the dealer to confirm the recall applies to your VIN and book the free replacement with an Acura dealer right away.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. You may have received a recall letter.
- Why it happens
- The original driver airbag inflator can absorb moisture and rupture, and some replacement inflators installed under earlier recalls were also defective.
- What to do
- Look up your VIN for open recalls and have the free inflator replacement done, even if an earlier airbag recall was already completed.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Passenger airbag may not open fully (recall)
- What you'll notice
- No warning signs.
- Why it happens
- On some early 2010 ZDX models, the dashboard cover over the passenger airbag was not scored correctly, so the airbag might not deploy fully through it.
- What to do
- Check your VIN for open recalls. The dealer inspects the dashboard cover and replaces it for free if needed.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
ABS releases brake pressure unexpectedly (recall)
- What you'll notice
- While braking, the anti-lock brakes kick in when they shouldn't, and the car takes longer to stop than you expect.
- Why it happens
- A software error in the brake control module on AWD models can activate ABS and release brake pressure. Acura recalled the car in 2024 and expanded the recall in late 2026.
- What to do
- Check your VIN for open recalls and make sure the free brake software update (over the air or at a dealer) has been installed. Leave extra following distance until it is done.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Front stabilizer bar bracket can come loose (recall)
- What you'll notice
- A clunk or rattle from the front passenger side. In the worst case the car loses drive power or shuts down.
- Why it happens
- Bolts on the front passenger stabilizer bar bracket were not tightened properly at the factory. The loose bracket can damage high-voltage cables or battery coolant lines.
- What to do
- Get the free recall inspection now. Dealers tighten the bolts and repair any damaged cables or coolant lines.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Instrument display or backup camera goes blank (recall)
- What you'll notice
- The driver display goes dark, so speed and warning lights are not shown, or the backup camera screen is blank in Reverse.
- Why it happens
- Software errors in the radio control module can black out the instrument panel or the rearview camera image.
- What to do
- Book the free software update at a dealer. Until then, be extra careful backing up and watch your speed by other means if the display fails.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Automatic emergency braking with nothing ahead
- What you'll notice
- The car brakes hard on its own at city or highway speed, or while backing up, even though nothing is in the way.
- Why it happens
- Owners report false activations of the forward collision and automatic braking system. It is the most common complaint filed with NHTSA for this car.
- What to do
- Report each event to the dealer and to NHTSA, and ask about software updates. Keep sensors and the windshield camera area clean.
Brake pedal sinks or Service Brake Assist warning
- What you'll notice
- The brake pedal goes lower than normal, braking feels delayed, or a Service Brake Assist message appears, sometimes with a clicking feel at the pedal.
- Why it happens
- The car uses an electronic brake system blended with regenerative braking. Owners report faults that dealers often cannot reproduce; related brake software has been recalled.
- What to do
- Treat any brake warning seriously. Have the car checked by a dealer, make sure all brake software recalls are done, and don't drive it if the pedal goes to the floor.
Leaking active dampers cause clunks and rough ride
- What you'll notice
- Clunking or thumping over bumps, a bouncy or harsh ride, and less control on rough roads. You may see oily residue on the shocks, though the front units are mounted upside down and often hide the leak.
- Why it happens
- The electronically controlled active dampers (shocks) can lose fluid, especially in cold climates. Acura extended the warranty on front and rear active dampers for 2010-2012 ZDX models, and those extensions have now expired.
- What to do
- Have the dampers inspected if the ride changes or you hear clunks. Worn dampers hurt handling and braking, so replace them in pairs rather than waiting.
Shudder between 20 and 60 mph
- What you'll notice
- A vibration or shudder, like driving over rumble strips, during light acceleration or steady cruising between about 20 and 60 mph.
- Why it happens
- The torque converter lock-up clutch can judder as it engages. Acura released a software update and later bulletins pointing to worn transmission fluid or a faulty torque converter.
- What to do
- Ask a dealer to check for the transmission software update and change the transmission fluid with genuine Acura fluid. If the shudder continues, the torque converter may need replacing.
Front wheel bearing humming or moaning
- What you'll notice
- A humming, droning or moaning sound from the front that rises with speed and may change when you steer left or right.
- Why it happens
- Acura investigated front wheel bearing noise on 2011-2013 MDX and ZDX models. A worn bearing makes noise and gets worse over time.
- What to do
- Have the front bearings checked. A noisy bearing can usually be driven on for a short time, but don't ignore it; a badly worn bearing can overheat or loosen the wheel.
EGR valve failure
- What you'll notice
- Check engine light, sometimes with rough idle, hesitation or pinging when accelerating.
- Why it happens
- The exhaust gas recirculation (EGR) valve and its passages build up carbon until the valve sticks or the flow is blocked.
- What to do
- Have the codes read. Cleaning the EGR passages and replacing the valve usually fixes it. Avoid hard driving if you hear pinging.
Catalytic converter damaged by loose sensor cap
- What you'll notice
- Check engine light for catalyst efficiency, a rattle from the exhaust near the engine, or a failed emissions test.
- Why it happens
- Acura found that a cap on the air-fuel ratio sensor can come loose and damage the warm-up catalytic converter.
- What to do
- If the converter code appears, ask the shop to look at the air-fuel sensor as well as the converter so the new part isn't damaged the same way.
Won't move in Drive or Reverse after sitting overnight
- What you'll notice
- The engine starts, but the car doesn't move when shifted into Drive or Reverse; pressing the gas only revs the engine. Moving the shifter between Park and Drive a few times gets it going.
- Why it happens
- Owners report a delay in transmission engagement after the car sits. The exact cause has not been confirmed by Acura; low fluid pressure on start-up is a common reason for this kind of delay.
- What to do
- Don't rev the engine while it fails to engage. Have the fluid level and condition checked and ask a dealer to scan the transmission for codes and updates.
Rearview camera picture distorted or blank (recall)
- What you'll notice
- The backup camera shows a distorted, frozen or blank image when you shift into Reverse.
- Why it happens
- A faulty rearview camera can fail to send a clear image. Acura recalled the 2024 ZDX to replace the camera; owners report waiting for parts.
- What to do
- Check your VIN for this recall and ask the dealer when the replacement camera will be available. Use mirrors and look over your shoulder when reversing.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Low oil pressure light with correct oil level
- What you'll notice
- The low oil pressure light flickers or comes on even though the dipstick shows the oil is full.
- Why it happens
- Acura published service notes about this warning on 3.7L models. It can come from a sensor or wiring fault, but it can also be an early sign of low oil from consumption.
- What to do
- Pull over and check the oil level right away. If the level is correct and the engine sounds normal, have a shop test actual oil pressure and the sensor before assuming it is a false warning.
Check engine light for evaporative (EVAP) leak
- What you'll notice
- The check engine light comes on with no change in how the car drives. Codes such as P0455 or P0456 point to a fuel vapor leak.
- Why it happens
- A loose or sticky fuel cap is the most common cause; Acura issued a bulletin on it. The EVAP canister vent solenoid can also stop working.
- What to do
- Tighten or replace the fuel cap first, then clear the code. If it returns, have the EVAP system smoke-tested to find the leaking part.
Loud exhaust from sticking muffler valve
- What you'll notice
- The exhaust gets louder over time, especially on a cold start.
- Why it happens
- A dealer traced this to a sticking valve inside the muffler that controls exhaust sound.
- What to do
- Have the muffler checked. It is not a safety issue unless there is an actual leak, but a muffler replacement is the usual fix.
Infotainment, navigation or phone features stop working
- What you'll notice
- The center screen, navigation, hands-free calling or the Acura app stop working, sometimes right after a software update.
- Why it happens
- Software problems in the infotainment system and connected services are a repeated complaint.
- What to do
- Try a restart of the system, then ask the dealer for the latest software. Keep notes of when it fails to help them diagnose it.
Roof antenna cover comes loose
- What you'll notice
- The shark-fin antenna on the roof rattles, lifts or comes off while driving or in a car wash.
- Why it happens
- Owners report the antenna housing separating from the roof.
- What to do
- If it is loose, have it secured before it falls off and lets water in. Ask the dealer to handle it under warranty.
Repair prices for your Acura ZDX
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front or rear active dampers (pair)
- Transmission fluid change and software update
- Replace front wheel hub/bearing assembly (one side)
- Replace oil pressure sensor
- Replace fuel cap or EVAP canister/vent parts
- Replace EGR valve and clean passages
- Replace catalytic converter
- Transmission fluid change and diagnosis
- Replace muffler assembly
- Dealer diagnosis and software update
- Brake system diagnosis
- Electrical diagnosis and software update
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger airbag inflatorNo charge if your vehicle is included
- Replace driver airbag inflatorNo charge if your vehicle is included
- Inspect/replace dashboard coverNo charge if your vehicle is included
- Brake control module software updateNo charge if your vehicle is included
- Tighten bracket bolts; repair damaged cables or coolant linesNo charge if your vehicle is included
- Radio control module software updateNo charge if your vehicle is included
- Replace rearview cameraNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.