Your 2005 Audi A4problems, repair costs and recalls
What we've documented about the 2005 Audi A4: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Audi A4
6 documented issues apply to 2005, most serious first.
Oil sludge in the 1.8T engine
- What you'll notice
- An oil pressure warning, ticking or knocking noises, or sudden engine damage on a car that seemed fine.
- Why it happens
- The small oil supply and turbo heat break down oil quickly. With long change intervals or the wrong oil, sludge builds up and can block the oil pickup.
- What to do
- Stop the engine if the oil light comes on. Use the full synthetic oil Audi specifies, change it often, and have the pickup screen checked on a car with unknown history.
Multitronic CVT failure on front-drive models
- What you'll notice
- Jerking or shudder when pulling away, hesitation, slipping, rolling back on hills, or the gear display flashing and the car going into limp mode.
- Why it happens
- The continuously variable transmission used on front-wheel-drive A4s can develop clutch and control unit faults, especially at higher mileage.
- What to do
- Have early shudder checked by an Audi specialist. A fluid service and software can help; a failing unit may need its control module or a rebuild. Avoid long trips if the display flashes.
Aftermarket water pump pulley can crack and take out the timing belt
- What you'll notice
- A rattle or grinding at the front of the engine, coolant loss, then the engine quits and will not restart.
- Why it happens
- One brand of replacement water pump used a pulley that can crack; when it breaks up it throws the timing belt, and these engines bend valves when the belt goes.
- What to do
- If a non-original water pump was fitted at a belt service, have the brand checked right away; a thrown belt here means major engine damage.
Ignition coil failures
- What you'll notice
- A flashing or steady check engine light, misfires, shaking at idle, and rough cold starts.
- Why it happens
- The individual coils that sit on top of each spark plug wear out from heat. When one fails, others often follow.
- What to do
- Have misfire codes read soon. Many owners replace all coils and the spark plugs together. A flashing check engine light means ease off and get it in quickly.
Crankcase ventilation (PCV) valve and hoses fail
- What you'll notice
- Rough idle, whistling from the engine, lean-running codes, higher oil use, or puffs of blue smoke under hard acceleration.
- Why it happens
- Heat makes the PCV valve and its rubber hoses crack or tear, creating a vacuum leak and letting crankcase pressure push oil where it should not go.
- What to do
- Have the PCV system smoke-tested and the failed parts replaced. It is a common and fairly simple repair.
Camshaft lobe and cam follower wear
- What you'll notice
- Fuel pressure or misfire codes, a check engine light, hesitation, and loss of power.
- Why it happens
- The small follower that drives the high-pressure fuel pump wears through, and the camshaft lobe under it then wears down.
- What to do
- Have the cam follower inspected at regular intervals and replaced when worn. Catching it early saves the camshaft and fuel pump.
Repair prices for your 2005 Audi A4
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Drop oil pan, clean pickup screen and change oil
- Replace ignition coils and spark plugs
- Replace PCV valve and breather hoses
- Replace Multitronic CVT with a rebuilt unit
- Replace high-pressure fuel pump cam follower
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…