Audi e-tronproblems, repair costs and recalls
Problems reported across 2019–2024. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
26 documented issues across all years, most serious first.
High-voltage battery modules can overheat (recall)
- What you'll notice
- Usually no warning at all. Some owners see a battery warning, lose range, or are told by the dealer to limit charging to 80% until the repair is done. In rare cases a module can overheat, smoke or catch fire.
- Why it happens
- Some cells in certain high-voltage battery modules slowly discharge themselves, which can lead to overheating. Audi recalled 2019-2022 e-tron and e-tron Sportback models, added monitoring software and replaces bad modules.
- What to do
- Ask an Audi dealer to check your VIN for open recalls. Until the work is done, follow Audi's charging limit and park outside if the dealer tells you to. The repair is free.
Free at Audi dealers. Parts shortages have delayed some repairs.
Coolant leaks into front electric motor
- What you'll notice
- An 'electrical system malfunction' or drive-system warning appears, power drops, and the car may coast to a stop or refuse to move. Some owners notice the coolant level falling beforehand.
- Why it happens
- Coolant from the cooling circuit can seep past a seal into the front electric motor, shorting it out. Owners report the motor and related parts being replaced, sometimes for weeks.
- What to do
- If the warning appears, pull over safely and have the car towed to an Audi dealer. Ask whether it is covered by the 8-year/100,000-mile high-voltage warranty or the new-car warranty.
Sudden loss of drive power with electrical malfunction warning
- What you'll notice
- While driving, warnings such as 'Electrical system malfunction - stop safely' appear, and the car loses power, goes into a limp mode or shuts down, sometimes at highway speed or in an intersection.
- Why it happens
- Faults in the drive motors, the main drive controller or the high-voltage system trigger a safety shutdown. Owners report front motors, controllers and other high-voltage parts being replaced.
- What to do
- Get safely off the road and turn on your hazards. Have the car towed to a dealer and ask for all stored fault codes to be read and any software updates to be installed.
Brake pedal can come loose from the brake booster (recall)
- What you'll notice
- Usually no warning. If the fastener fails, the brake pedal can separate from the brake booster and the brakes will not work when you press the pedal.
- Why it happens
- The fastener that joins the brake pedal to the brake booster may not have been assembled correctly at the factory.
- What to do
- Check your VIN for open recalls and book the free inspection and repair at an Audi dealer as soon as possible.
240-volt portable charging cable can overheat (recall)
- What you'll notice
- When charging at home with the compact 240-volt cord plugged into a wall outlet, the plug, outlet or cable can get hot, smell burnt or melt, especially when charging to 100%.
- Why it happens
- With some home outlets, the plug end of the 240-volt portable charging cable can overheat under a long, full charge.
- What to do
- Stop using the 240-volt portable cord until Audi gives you the replacement cable with a temperature sensor. Use the 120-volt cord, a wall-mounted charger or public chargers instead.
Water can enter battery through charging socket seal (recall)
- What you'll notice
- No warning before failure. Water can get past the charge port seal into the high-voltage battery area, which can lead to a short circuit, warning messages or a fire.
- Why it happens
- A faulty seal at the charging socket could let moisture into the high-voltage battery system.
- What to do
- Make sure the recall was done on your car. Dealers install a new seal and replace damaged parts for free.
Brake booster weld defect reduces braking assist (recall)
- What you'll notice
- Brake and stability warnings light up, the pedal may feel harder, and ABS and stability control may stop working.
- Why it happens
- A poorly welded rotor and shaft inside the electric brake booster can separate.
- What to do
- Check your VIN for this recall and have the dealer replace the brake booster for free. If the warning lights come on, drive carefully to a dealer or have the car towed.
Brake booster corrosion can disable ABS and stability control (recall)
- What you'll notice
- Warnings for ABS, stability control or brakes appear, and the speedometer display may stop working. Brake assist may be reduced.
- Why it happens
- Corrosion inside the brake booster can cause it to fail, taking the ABS, stability control and brake assist with it.
- What to do
- Have the free recall done at an Audi dealer, which replaces the brake booster.
Battery module controller (SX6) failure
- What you'll notice
- High-voltage battery warnings, the car won't charge or drive, and the dealer says battery control modules on top of the battery must be replaced.
- Why it happens
- The control units mounted on the high-voltage battery fail. An owner linked it to coolant getting into high-voltage parts; outside warranty it is very costly.
- What to do
- Check whether you are still within the 8-year/100,000-mile high-voltage warranty before paying for the repair.
Brake line connection can leak fluid (recall)
- What you'll notice
- Brake fluid leak, a brake warning light, or a softer brake pedal and longer stops.
- Why it happens
- A brake line fitting may have been overtightened at the factory and can fail.
- What to do
- Check for this recall on 2024 Q8 e-tron models. The dealer inspects and replaces the line for free.
Dead 12-volt battery, car won't wake up or start
- What you'll notice
- The car won't unlock, the screens stay dark, or it won't go into Ready mode. It may happen after the car sits, or after DC fast charging.
- Why it happens
- The small 12-volt battery runs the car's computers. It can run down from modules that stay awake, software faults, or a charging fault, and Audi has issued service bulletins on drained 12-volt batteries and no-starts.
- What to do
- Try a jump start or a 12-volt battery charger. If it keeps happening, have the dealer test the 12-volt battery and check for software updates and bulletins about battery drain.
Car won't charge or charge port won't release the cable
- What you'll notice
- Charging won't start or stops part way, the charge flap won't open or close, or the cable stays locked in the port.
- Why it happens
- Problems with the charge port, its locking actuator, the charge flap or the charging software. Audi has released bulletins and software for charging faults and for checking charge socket parts.
- What to do
- Try another charger and make sure the car is unlocked. Use the emergency release for the cable if needed. Have the dealer check for charging software updates and charge port faults.
Low coolant warning or coolant leak
- What you'll notice
- A low coolant warning appears, sometimes even though the reservoir looks full. Some cars lose coolant and leave a sweet-smelling puddle.
- Why it happens
- Audi issued bulletins for false low-coolant warnings and for leaks from an electric coolant valve. Some cars were also filled with the wrong type of coolant at the factory.
- What to do
- Check the reservoir when the car is cold. Don't top up with ordinary coolant; e-tron needs a specific Audi coolant. Have the dealer check for leaks and bulletins.
Air suspension fault warning or car sitting low
- What you'll notice
- An air suspension malfunction message appears, the car sits lower at one corner, or the ride height won't change.
- Why it happens
- Leaking air struts, a weak compressor or suspension control unit faults. Audi has issued bulletins for air suspension warnings and suspension control unit fault codes.
- What to do
- Have it checked soon, because a leaking strut overworks the compressor. Ask the dealer about software updates before replacing parts.
Sunroof or roof water leaks into cabin
- What you'll notice
- Wet carpets or footwells, water dripping from the headliner, or damp electronics after rain or a car wash.
- Why it happens
- Water gets past the panoramic roof seals or its drains, or other body seals. Owners worry about water reaching electrical parts.
- What to do
- Dry the interior quickly and have the dealer test the roof seals and clear the drains. Water damage to electronics can get expensive if ignored.
Infotainment unit fails and rear camera goes dark (recall)
- What you'll notice
- The main screen goes blank after the car has been shut off, and the rearview camera image doesn't show when reversing.
- Why it happens
- The infotainment main unit can be damaged internally when the vehicle is switched off.
- What to do
- Check for this recall. The dealer replaces the infotainment main unit for free.
Rearview camera image may not appear, software fault (recall)
- What you'll notice
- When you shift into reverse, the rear camera picture doesn't show up correctly or at all.
- Why it happens
- A software error can stop the rearview camera image from displaying. Audi issued a recall in 2025 that covers e-tron models.
- What to do
- Check your VIN for open recalls and have the free software update done. Until then, use your mirrors and look behind you.
Rearview camera shows black screen (recall)
- What you'll notice
- When you shift into reverse, the screen stays black or blank instead of showing the camera view.
- Why it happens
- An infotainment software fault can stop the rear camera image from appearing.
- What to do
- Have the free software update done at an Audi dealer. Until then, check your mirrors and look behind you when reversing.
Screens or virtual cockpit go blank or flicker
- What you'll notice
- The driver display or center screens flicker, show lines or go black while driving, sometimes taking climate controls with them.
- Why it happens
- Software and hardware faults in the displays and infotainment modules. Audi issued a bulletin for flickering lines in the virtual cockpit, and owners report cluster replacements.
- What to do
- Restarting the car may bring the screens back. Have the dealer check for software updates and fault codes.
Car rolls on hills even in gear
- What you'll notice
- The car rolls backward or forward on a slope after stopping, even in Drive or Reverse, or the brake hold doesn't hold.
- Why it happens
- Owners report the hold features not keeping the car still on inclines. Electric cars don't creep or hold like a regular automatic unless the hold function works.
- What to do
- Use the brake pedal and parking brake on hills. Report it to the dealer and ask for a software check.
Red steering warning light
- What you'll notice
- A red steering warning appears and steering may feel heavier.
- Why it happens
- Audi issued bulletins for steering warnings tied to specific fault codes in the steering system.
- What to do
- If steering feels heavy, stop safely. Have the dealer read the codes and check the steering bulletins.
Glove box hinge pin can block knee airbag (recall)
- What you'll notice
- No symptoms. In a crash the knee airbag may not deploy correctly.
- Why it happens
- A glove box hinge pin may not be secured, letting the lid trim get in the way of the knee airbag.
- What to do
- Have the dealer inspect and secure the hinge pin for free.
Rear seat belt may not hold a child seat (recall)
- What you'll notice
- The middle rear seat belt may stop locking, so a child seat installed with the belt can loosen.
- Why it happens
- The automatic locking feature of the rear seat belt retractor can switch off too early.
- What to do
- Use the LATCH anchors for child seats until the dealer inspects and replaces the belt for free.
Clunk or rattle from rear axle over bumps
- What you'll notice
- A clunk, rumble or rattle from the back of the car when driving over bumps or rough roads.
- Why it happens
- Audi issued several bulletins for rear axle and rear suspension noises, including loose or worn parts in the rear axle area.
- What to do
- Have the dealer road test the car and check the rear suspension bulletins. It is usually not urgent, but have it inspected.
Squeak or creak from front suspension
- What you'll notice
- A squeak or creak from the front while driving, often over bumps or when turning at low speed.
- Why it happens
- Audi issued bulletins for front suspension noises, including replacing a drive link shaft for front-end rumbling or squeaks.
- What to do
- Mention the noise during a service visit and ask the dealer to check the front suspension bulletins.
No sound from audio system
- What you'll notice
- No sound at all from the radio, media or phone calls, even though the screen works.
- Why it happens
- On certain early-production 2019 e-trons, an electronics control module for the audio system fails. Audi issued a bulletin to replace it.
- What to do
- Ask the dealer to check the bulletin for the audio electronics module.
Repair prices for your Audi e-tron
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front electric drive motor and coolant seals/hoses
- Diagnose high-voltage drive fault
- Diagnose dead 12-volt battery
- Diagnose charging fault
- Find coolant leak or false warning
- Replace leaking air strut or air suspension part
- Diagnose rear axle noise
- Diagnose front suspension noise
- Diagnose display fault and update software
- Diagnose audio system fault
- Replace high-voltage battery module control units (SX6)
- Diagnose hill hold fault
- Diagnose steering warning
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Battery monitoring software and module replacement (recall 23V-867)No charge if your vehicle is included
- Inspect and repair brake pedal-to-booster fastener (recall 24V-621)No charge if your vehicle is included
- Replace 240-volt portable charging cable (recall 23V-842)No charge if your vehicle is included
- Install new charging socket seal (recall 19V-434)No charge if your vehicle is included
- Replace brake booster (recall 21V-569)No charge if your vehicle is included
- Replace brake booster (recall 21V-707)No charge if your vehicle is included
- Replace infotainment main unit (recall 22V-806)No charge if your vehicle is included
- Camera system software update (recall 25V-900)No charge if your vehicle is included
- Infotainment software update (recall 22V-742)No charge if your vehicle is included
- Inspect and secure glove box hinge pin (recall 21V-595)No charge if your vehicle is included
- Replace rear center seat belt assembly (recall 21V-606)No charge if your vehicle is included
- Inspect and replace brake pressure line (recall 24V-428)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.