Audi Q5problems, repair costs and recalls
Problems reported across 2009–2026. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
29 documented issues across all years, most serious first.
Timing chain tensioner can fail
- What you'll notice
- A rattle for a few seconds on cold start, a check engine light, misfires, or an engine that suddenly will not run.
- Why it happens
- The tensioner that keeps the timing chain tight can let go, allowing the chain to jump. When that happens the valves and pistons can collide. A class settlement extended coverage on some of these years.
- What to do
- If you hear a start-up rattle, stop driving and have the tensioner version checked. Replacing it early is far cheaper than an engine.
Engine burns oil between changes
- What you'll notice
- Low oil warnings well before the next service, needing to add oil regularly, and sometimes blue smoke or loss of power.
- Why it happens
- The pistons and rings in this engine do not seal well enough, so oil gets past and is burned. Running low can damage the engine.
- What to do
- Check the oil level every couple of fill-ups and have a dealer run a consumption test. Do not drive with the low oil warning on.
Sunroof drains leak and can corrode an airbag inflator
- What you'll notice
- Wet headliner or water in the front pillar and footwell after rain, and sometimes a sunroof that stops working.
- Why it happens
- The sunroof drain setup can let water into the roof pillar, where it soaks foam around the side curtain airbag inflator. The inflator canister can rust and rupture.
- What to do
- Check the VIN for recall 17V-001. Have any water leak fixed promptly and the inflator inspected.
Electric coolant pump can overheat and catch fire
- What you'll notice
- Often no warning. Possible burning smell or smoke from under the hood, even with the vehicle parked.
- Why it happens
- The small electric coolant pump can jam with debris or short out from moisture and overheat. The first recall changed software and the second replaces the pump.
- What to do
- Check the VIN for recalls 17V-002 and 18V-229. If open, have them done now and park outside until then.
Fuel pump flange can crack and leak
- What you'll notice
- Fuel smell around the rear of the vehicle or inside, mostly with a full tank.
- Why it happens
- The plastic flange on top of the in-tank fuel pump can develop fine cracks that let fuel seep out. The recall replaces cracked flanges and covers sound ones with a protective film.
- What to do
- Check the VIN for recall 16V-660 and its 2017 expansion (Audi code 20Z8). Leaking fuel is a fire risk, so do not put it off.
Auxiliary heater connector can corrode and melt
- What you'll notice
- Burning plastic smell from the vents, reduced cabin heat, or in rare cases smoke.
- Why it happens
- The connector for the electric auxiliary heater can corrode, heat up and melt nearby wiring.
- What to do
- Check the VIN for Audi safety recall 80C5 / 80C6. If you smell burning, turn the climate system off and have it inspected right away.
Seat-mounted side airbag inflator can rupture
- What you'll notice
- No symptom before a crash. In a crash the side airbag in the seat may not protect properly.
- Why it happens
- Inflators in the seat side airbags on vehicles built in early 2015 could burst when deploying.
- What to do
- Check the VIN for Audi safety recall 69M1 and have the airbag modules replaced if it is open.
Vehicle can roll away in Park
- What you'll notice
- The vehicle creeps or rolls after being shifted to Park if the parking brake is not set.
- Why it happens
- A fault inside the gearbox on a small number of 2017 vehicles can keep the parking lock from holding.
- What to do
- Check the VIN for Audi safety recall 37K6. Always set the parking brake until the recall is confirmed done.
Airbags and seat belt tensioners may not fire
- What you'll notice
- Usually no warning, though an airbag light may be on. In a crash the airbags or belt tensioners may not work.
- Why it happens
- Some igniters in the airbags and seat belt pretensioners on early-build 2018 vehicles may not trigger properly.
- What to do
- Have a dealer check the VIN for the open airbag recall and get the parts replaced before carrying passengers regularly.
Valve cover bolts may be loose and leak oil
- What you'll notice
- Oil smell, smoke from the engine bay or oil wetness around the top of the engine.
- Why it happens
- The screws holding the cylinder head cover may not have been tightened correctly at the factory, so oil can escape onto hot parts.
- What to do
- Check the VIN for recall 25V-294. If you smell burning oil or see smoke, stop and have it inspected because of the fire risk.
Air bag control unit can corrode and fail (recall)
- What you'll notice
- An air bag warning light on the dash, sometimes coming and going.
- Why it happens
- Moisture can reach the air bag control unit and corrode it until it no longer works.
- What to do
- Have the control unit replaced under the recall; with it faulty the air bags may not fire in a crash.
Brake master cylinder can lose pressure (recall)
- What you'll notice
- The brake pedal sinks or goes soft and the car takes much longer to stop.
- Why it happens
- The master cylinder casting can be made too short, so the seals do not work as intended and pressure escapes.
- What to do
- Have it replaced under the recall straight away; the electric parking brake still works, but normal braking can disappear with little warning.
Water can reach the gateway module and cut engine power
- What you'll notice
- A sudden loss of drive power, many warning messages at once, or a car that goes dead and will not restart.
- Why it happens
- Liquid can get to the gateway control module, the hub that passes messages between systems, and shut it down.
- What to do
- Have the recall work done without delay and mention any damp carpet; losing power in traffic is a crash risk.
Front brake caliper pistons may be badly coated (recall)
- What you'll notice
- Weak braking or a pedal that needs more effort than it used to for the same stop.
- Why it happens
- The caliper pistons may not have enough protective coating, so they corrode and stop moving freely.
- What to do
- Do not drive until a dealer has checked the calipers under the recall; braking can be reduced without any warning light.
Front seat backrest can break in a rear-end crash (recall)
- What you'll notice
- The backrest may feel loose or move when leaned on, but often nothing shows until a crash.
- Why it happens
- The seat frame and backrest adjuster may have been welded badly, so the backrest is not strong enough.
- What to do
- Have the seat inspected and repaired under the recall; a backrest that folds back in a crash offers no protection.
Rear trailing arm nut can corrode and break
- What you'll notice
- The rear of the car feels unsettled or steers itself slightly, often with uneven rear tire wear.
- Why it happens
- The lock nut on the rear trailing arm can corrode until it breaks, letting the rear wheel move out of alignment.
- What to do
- Have it replaced and the axle aligned under the recall soon; a loose rear arm can make the car hard to control.
Connecting rod bearings may be damaged from new (recall)
- What you'll notice
- A deep knock from low in the engine that rises with revs, low oil pressure warnings, or the engine stalling.
- Why it happens
- The connecting rod bearings can be damaged in build, so they wear quickly and lose their oil film.
- What to do
- Stop driving and have the engine inspected under the recall if you hear knocking; a failed bearing destroys the engine and can leak oil onto hot parts.
Plug-in charging cable can overheat at the outlet
- What you'll notice
- The plug, cable or household outlet gets hot, smells of hot plastic or shows scorch marks after charging.
- Why it happens
- Charging at full current from a household outlet can overload the plug and the outlet it sits in.
- What to do
- Stop using that cable and outlet and have it replaced under the recall; an overheating plug can start a house fire.
High-voltage battery can overheat (recall)
- What you'll notice
- Hybrid system warnings, charging that stops on its own, or a hot or chemical smell from under the car.
- Why it happens
- A fault inside the high-voltage battery can let it overheat, most likely while it is charging.
- What to do
- Stop charging the car and have the battery inspected under the recall; the maker warns of a fire risk, so park it outdoors until then.
Passenger seat sensor connection can come loose (recall)
- What you'll notice
- An air bag warning light, or the passenger air bag light saying it is off with an adult sitting there.
- Why it happens
- The connection for the sensor that tells the car who is in the passenger seat can work loose.
- What to do
- Have the connection repaired under the recall; with it loose the passenger air bag may not fire in a crash.
Front seat belts may be built wrong (recall)
- What you'll notice
- Nothing shows in normal use; the belt latches and retracts as usual.
- Why it happens
- The driver and front passenger belts may have been assembled incorrectly, so they may not hold an occupant in a crash.
- What to do
- Have the belts replaced under the recall; there is no way to tell from the seat whether yours are affected.
Earlier fuel pump flange repair may not stop the leak (recall)
- What you'll notice
- A fuel smell around the back of the vehicle or in the cargo area, sometimes a damp patch or staining under the rear seat.
- Why it happens
- The plastic flange on top of the fuel tank cracks. Audi's first remedy did not hold on every vehicle, so a follow-up campaign replaces the flange outright.
- What to do
- Have the VIN checked for this follow-up campaign and get it done. Until then keep the vehicle out of a closed garage, because fuel vapour near a hot or electrical part is a fire risk.
Windshield pillar trim can come loose in a crash
- What you'll notice
- Usually nothing until a crash. Sometimes the trim on the pillar beside the windshield looks loose or rattles.
- Why it happens
- A clip holding the pillar trim could be faulty on early-build cars, so the trim could come off when the side curtain airbag fires.
- What to do
- Check the VIN for Audi safety recall 70D4 and have the clip inspected at your next visit.
Water pump and thermostat housing leak coolant
- What you'll notice
- Coolant level dropping, a sweet smell, pink crust or drips at the front of the engine, or the temperature gauge climbing.
- Why it happens
- The water pump and thermostat share a plastic housing that warps and seeps with heat and age.
- What to do
- Have the leak confirmed soon and keep the coolant topped up. Stop driving if the temperature warning comes on.
Front sunroof glass can crack in extreme cold
- What you'll notice
- A loud bang followed by a cracked or shattered front sunroof panel in very cold weather.
- Why it happens
- The glass panel on vehicles built from mid to late 2011 could break when temperatures are very low. Audi recalled them to fit a new panel.
- What to do
- Check the VIN for Audi safety recall 60B2. If the glass is cracked, keep the shade closed and have it replaced soon.
Reversing camera can show a blank screen (recall)
- What you'll notice
- The screen stays black or empty when reverse is selected instead of showing the view behind.
- Why it happens
- A software fault keeps the camera picture from reaching the display.
- What to do
- Have the software updated under the recall and look over your shoulder when reversing until then.
Rear seat belt retractors can lock too early (recall)
- What you'll notice
- A rear belt locks up while being pulled out, making it hard to get a child seat tight.
- Why it happens
- The retractor can go into its locking mode sooner than intended.
- What to do
- Have the retractors replaced under the recall, and check any child seat is really tight in the meantime.
Wheel arch trim can work loose and fall off
- What you'll notice
- Flapping or rattling from a wheel arch at speed, and a trim piece hanging away from the body or missing.
- Why it happens
- The fasteners holding the wheel arch cover can let go, so the trim lifts in the airflow.
- What to do
- Have the trim refastened under the recall at your convenience; a piece that comes off becomes a hazard for the car behind.
Rear axle alignment may never have been set (recall)
- What you'll notice
- The rear tires wear unevenly, usually on one shoulder, far sooner than expected.
- Why it happens
- After earlier repair work the rear axle alignment was not checked, so it can sit out of specification from new.
- What to do
- Have the alignment checked under the recall and the tires looked at while it is on the rack; it is a wear issue, not a safety emergency.
Repair prices for your Audi Q5
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Inspect and replace A-pillar trim clips
- Replace timing chain, tensioner and guides
- Replace pistons and rings
- Replace water pump and thermostat housing assembly
- Inspect and coat or replace curtain airbag inflator; clear drains
- Replace front sunroof glass panel
- Replace electric auxiliary coolant pump
- Replace fuel pump flange or apply protective film
- Replace auxiliary heater and update software
- Replace seat side airbag modules
- Replace transmission
- Replace affected airbags and seat belt pretensioners
- Inspect and retighten or replace cylinder head cover screws
- Replace air bag control unit
- Replace brake master cylinder and bleed brakes
- Refasten or replace wheel arch trim
- Seal the module area and replace the gateway module if damaged
- Replace front brake calipers
- Replace front seat backrest frame
- Replace rear trailing arm lock nut and align rear axle
- Check and set rear axle alignment
- Update rear camera software
- Inspect engine and replace connecting rod bearings
- Replace rear seat belt retractors
- Replace the plug-in charging cable
- Inspect and replace high-voltage battery modules
- Repair passenger occupant detection connection
- Replace front seat belt assemblies
- Replace fuel tank pump flange
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.