Your 2010 BMW 5 Seriesproblems, repair costs and recalls
What we've documented about the 2010 BMW 5 Series: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 BMW 5 Series
10 documented issues apply to 2010, most serious first.
Plastic cooling parts crack and the engine overheats
- What you'll notice
- Low coolant warning, a sweet coolant smell, drips under the front of the car, or the temperature gauge climbing toward hot.
- Why it happens
- The radiator end tanks, expansion tank, thermostat housing, hoses and water pump on these cars use a lot of plastic. Years of heat cycles make it brittle until it cracks or a fitting snaps.
- What to do
- Stop driving if the gauge climbs, because overheating can warp the aluminum cylinder head. Have the cooling system pressure-tested and replace the aged plastic parts as a set rather than one at a time.
Electric water pump fails and the engine overheats
- What you'll notice
- An engine temperature warning, the cooling fan running at full speed, reduced power, or a check engine light, often with no warning signs beforehand.
- Why it happens
- These engines use an electronically driven water pump, and its motor or electronics can quit, sometimes as early as 50,000 miles. The thermostat often fails along with it.
- What to do
- Pull over and shut the engine off if the temperature warning appears. A scan tool will usually show a coolant pump fault. Replacing the pump and thermostat together is the normal fix.
Worn valve stem seals make the V8 burn oil
- What you'll notice
- Blue-gray smoke from the exhaust right after startup or after idling, frequent low-oil warnings, and oily spark plugs.
- Why it happens
- The rubber valve stem seals on the V8 harden and shrink with heat and age, letting oil run down the valve guides into the cylinders.
- What to do
- Check the oil level often and keep it topped up. If the car needs more than about a quart every 1,000 miles, get a quote for valve stem seals from an independent BMW specialist.
High-pressure fuel pump fails and the engine stalls or loses power
- What you'll notice
- Long cranking before the engine starts, stalling soon after starting, a drivetrain malfunction message, hesitation under load, or limp mode.
- Why it happens
- The high-pressure fuel pump on the twin-turbo 535i failed at a high rate. The first year of the newer single-turbo engine used a similar pump; BMW changed the design for 2012.
- What to do
- Have the fault codes read to confirm low fuel pressure. Ask a dealer whether any updated pump or software was already installed on your car.
Drive belt shreds and can be pulled into the engine
- What you'll notice
- A squeal when revving, a belt that looks frayed, or sudden loss of power steering and charging after a loud slap from the engine bay.
- Why it happens
- Oil leaking onto the belt, worn tensioners or pulleys, and loose pulley bolts can make the belt fray. A broken piece can get sucked behind the crank pulley and into the engine, causing major damage.
- What to do
- Fix oil leaks promptly and have the belt, tensioner and pulleys checked at every service. Replace a belt that shows any cracking or fraying right away.
Automatic transmission shifts harshly or slips
- What you'll notice
- Delayed or harsh shifts, slipping, shudder, a transmission warning, being stuck in one gear, or trouble shifting out of Park.
- Why it happens
- The 6-speed automatic's mechatronic unit (the valve body and electronics that control shifting) and its sealing sleeve can fail between about 50,000 and 100,000 miles. BMW called the fluid lifetime, which doesn't help.
- What to do
- Have codes read and the fluid level checked. A mechatronic repair or sleeve replacement from an independent specialist usually costs far less than a new transmission.
Battery cable connector in the trunk can overheat (recall)
- What you'll notice
- Electrical faults, a burning smell from the trunk, or in rare cases a fire even when parked.
- Why it happens
- The positive battery cable's connector on the trunk floor may be poorly attached, so the bolt loosens and the joint heats up.
- What to do
- Have the recall checked with your VIN. Until it's done, park outside, away from buildings.
Free at a dealer when the recall is open for your VIN.
Crankcase vent valve heater can short and start a fire (recall)
- What you'll notice
- Often no warning. Sometimes a burning-plastic smell or a check engine light for the crankcase vent heater.
- Why it happens
- A small heater in the crankcase ventilation valve can short circuit and overheat, even with the car parked and off.
- What to do
- Have the recall done at a BMW dealer. Until then, park outside and away from buildings if possible.
Free at a dealer when the recall is open for your VIN.
Valve cover and oil filter housing gaskets leak oil
- What you'll notice
- Oil spots under the car, a burning-oil smell after driving, oil in the spark plug wells, or misfires.
- Why it happens
- The rubber gaskets on the valve cover, oil filter housing and oil pan harden with heat and start to seep. Oil dripping onto the exhaust or the drive belt causes smells and damage.
- What to do
- Have the source pinned down and replace the gasket. Don't let it run, because oil on the belt can lead to belt failure.
Turbo wastegate rattle on the 535i
- What you'll notice
- A metallic rattle from the turbos, especially when coasting or at light throttle, sometimes with boost-related codes or less power.
- Why it happens
- The linkage bushings in the turbochargers' wastegates wear, letting the flap rattle and eventually fail to control boost.
- What to do
- Have a BMW specialist confirm where the rattle is coming from. Mild rattles can be monitored; power loss or codes mean the turbos need repair or replacement.
Repair prices for your 2010 BMW 5 Series
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace radiator, expansion tank and hoses
- Replace electric water pump and thermostat
- Replace valve stem seals (both banks)
- Replace high-pressure fuel pump
- Replace serpentine belt (and tensioner if worn)
- Rebuild mechatronic unit and replace sleeve, fluid and filter
- Replace valve cover gasket
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a BMW dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…