Your 2018 BMW X2problems, repair costs and recalls
What we've documented about the 2018 BMW X2: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2018 BMW X2
13 documented issues apply to 2018, most serious first.
Timing chain rattle on cold start
- What you'll notice
- A brief rattle or chain-like noise from the engine in the first few seconds after a cold start.
- Why it happens
- The timing chain tensioner can weaken over time, especially when oil changes have been stretched out, letting the chain slap until oil pressure builds.
- What to do
- Do not ignore a rattle that gets longer or louder. Have the chain and tensioner checked; replacing a worn tensioner is far cheaper than repairing an engine after the chain jumps.
Crankshaft sensor software can stall the engine (recall)
- What you'll notice
- The engine may stall suddenly while driving.
- Why it happens
- The crankshaft position sensor may have been programmed with incorrect software, so it can misread engine position.
- What to do
- Check your VIN for open recalls. A BMW dealer replaces the sensor for free.
Coolant leaks from the expansion tank and hoses
- What you'll notice
- A low coolant warning, a sweet smell after driving, or dried coolant crust around the coolant tank and hose joints under the hood.
- Why it happens
- The plastic expansion tank can crack and hose connections can start to seep as the engine ages, so coolant slowly escapes. Owners and repair shops call coolant leaks one of the most common faults on this generation.
- What to do
- Top up only with BMW-approved coolant and have the system pressure-tested to find the leak. Fix it soon, because running low on coolant can overheat and damage the engine.
Oil leaks from the valve cover gasket
- What you'll notice
- Oil spots under the car, a burning oil smell after a drive, or oil residue around the top and side of the engine.
- Why it happens
- The rubber valve cover gasket hardens with age and heat and stops sealing, letting oil seep out onto hot engine parts. The oil filter housing seal on this engine family can also leak.
- What to do
- Have a shop confirm where the oil is coming from. Replacing the gasket is routine, but oil dripping on the exhaust can smoke and is a fire risk if ignored.
Engine using oil between services
- What you'll notice
- The oil level drops between oil changes and the car asks you to add oil, sometimes well before the next service is due.
- Why it happens
- As these engines build up miles, worn piston rings or valve stem seals can let small amounts of oil burn off inside the engine, usually noticed around 50,000-70,000 miles.
- What to do
- Check the oil level every few fill-ups and keep it topped up. If you are adding more than about a quart every 1,000-1,500 miles, have a shop run a consumption test and look for leaks first.
Clunk or droning from worn engine mounts
- What you'll notice
- More vibration in the cabin than usual, a clunk when shifting or pulling away, or a creak or drone from low in the engine bay.
- Why it happens
- The engine mounts and the engine torque link wear out, especially on the more powerful M35i. BMW has issued service bulletins for creaking from the lower engine area and worn engine stabilizer links.
- What to do
- Have the mounts and torque link inspected. Worn mounts are not usually urgent, but replacing them stops the vibration and protects other parts.
Hesitation or jerky shifts at low speed
- What you'll notice
- The car hesitates, lurches or shifts roughly when creeping in traffic or pulling away from a stop.
- Why it happens
- Transmission fluid that has never been changed can cause rough low-speed behavior. Owners also report vibration and odd smells from the transmission in some cases.
- What to do
- Ask a shop or dealer to check for software updates and stored codes. Many independent specialists recommend a transmission fluid service on higher-mileage cars even though BMW calls the fluid lifetime.
Water in the front footwell from the A/C drain
- What you'll notice
- Damp carpet in the front footwell, a musty smell in the cabin, or water dripping under the dash on the passenger side.
- Why it happens
- The A/C condensate drain can let water run into the cabin instead of outside. BMW has issued and repeatedly updated a service bulletin for this.
- What to do
- Lift the floor mat and feel the carpet. Have a dealer check the condensate drain and dry the carpet, since trapped water can cause mold and damage wiring under the floor.
Knocking from worn front control arm bushings
- What you'll notice
- Knocking over bumps, vague or wandering steering, or uneven front tire wear.
- Why it happens
- The rubber bushings in the front lower control arms wear with mileage, usually around 50,000-70,000 miles. Rear bushings on xDrive models can wear too and make the rear feel loose.
- What to do
- Have the front suspension checked. Replace worn arms or bushings and get an alignment afterward.
Side mirror fault that disables windows
- What you'll notice
- A side mirror stops adjusting or the glass cracks or looks damaged, and the power windows or mirrors on that side may stop working properly.
- Why it happens
- Faulty mirror electronics can short the car's data line (LIN bus) that also runs the windows. Owners have also reported a melting driver mirror on early cars.
- What to do
- Have a dealer scan the body electronics. Replacing the faulty mirror part usually brings the windows back.
Brake pads and rotors wear out early
- What you'll notice
- The brake service warning comes on early, sometimes before 30,000 miles, and the pads and rotors need replacing at the same time.
- Why it happens
- The X2 uses soft, high-grip brake pads that wear relatively quickly along with the rotors. One owner reported needing a brake job at about 27,000 miles.
- What to do
- When the warning appears, plan a brake job soon. Ask for a quote that includes the wear sensor, since BMW requires a new one with new pads.
Central screen freezes or restarts
- What you'll notice
- The iDrive screen freezes, goes blank, flickers or reboots while driving.
- Why it happens
- Software faults in the head unit, mostly on earlier cars. BMW also released a bulletin for a flickering central display.
- What to do
- Ask the dealer for the latest iDrive software update, which often fixes it.
Rear light housings work loose and clack
- What you'll notice
- A clacking or rattling from the rear of the car over bumps, or a taillight that moves when pushed.
- Why it happens
- The mounts for the rear light housings can loosen. BMW extended the warranty on these housings to 10 years with no mileage limit.
- What to do
- Push gently on each taillight. If it moves or rattles, ask a BMW dealer to repair it under the extended warranty.
Repair prices for your 2018 BMW X2
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace coolant expansion tank or leaking hose, then bleed the system
- Replace valve cover gasket (or oil filter housing gasket)
- Oil consumption test and leak inspection
- Replace timing chain tensioner (chain and guides if worn)
- Replace engine mount or torque link
- Transmission software update or fluid service
- Clear A/C condensate drain, dry carpet and check for damage
- Replace outside mirror glass or mirror electronics
- Front brake pads, rotors and wear sensor
- Replace front lower control arms or bushings, plus alignment
- iDrive software update
- Re-secure or replace rear light housing mounts
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…