Your 2001 Buick Centuryproblems, repair costs and recalls
What we've documented about the 2001 Buick Century: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2001 Buick Century
18 documented issues apply to 2001, most serious first.
Lower intake manifold gasket leaks coolant or oil
- What you'll notice
- Coolant level keeps dropping, a sweet smell, coolant or oil seeping from where the intake meets the engine, overheating, or oil that looks milky on the dipstick.
- Why it happens
- The original intake manifold gaskets on the 3.1L V6 have plastic carriers and soft seals that deform with heat and age. Coolant can leak outside or into the engine oil, often starting around 60,000 miles. It is the worst engine complaint on the Century.
- What to do
- Have a shop pressure-test the cooling system and check the oil for coolant as soon as you notice coolant loss. Replace both gaskets with the updated design along with new bolts, and change the oil and coolant. Stop driving if it overheats, since that can crack a cylinder head.
Automatic transmission slips or fails
- What you'll notice
- The engine revs up but the car does not speed up, shifts are delayed or missing, the car feels stuck in one gear, or it will not move in drive or reverse.
- Why it happens
- The 4-speed automatic wears internally with age and mileage. CarComplaints rates a slipping transmission on the 2000 Century as its single worst problem, and GM issued many bulletins on slipping, shudder and loss of drive.
- What to do
- Check the fluid level and smell. Get the codes read and a transmission diagnosis early; small problems such as a solenoid can be cheaper to fix before the clutches burn.
Seat belt buckle may not hold in a crash (recall)
- What you'll notice
- There may be no warning signs.
- Why it happens
- Some seat belt buckles from TRW might not restrain a person properly in a crash.
- What to do
- Check your VIN for recall 00V-228. The dealer replaces affected buckles for free.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Harsh or slipping shifts from a pressure control solenoid
- What you'll notice
- Hard, banging upshifts, slipping, and a check engine light, often with codes P1811 or P0748.
- Why it happens
- The pressure control solenoid in the transmission sets how firmly gears engage. GM issued a bulletin to replace this solenoid when it causes harsh or slipping shifts.
- What to do
- Have the codes read. A solenoid can often be replaced without removing the transmission. Ask the shop about GM bulletin 02-07-30-048.
Power window falls down or stops working
- What you'll notice
- The window drops into the door, moves crooked, makes a grinding or snapping noise, or does not move at all.
- Why it happens
- The window regulator cable breaks or comes off its pulley, or the window motor wears out. A dead power window is the single most reported Century complaint.
- What to do
- Prop or tape the glass up to keep rain out. A shop can tell whether the regulator, motor or switch is at fault before replacing parts.
Sludge in the coolant leads to overheating
- What you'll notice
- Brown, muddy coolant or crust in the reservoir, weak heat from the vents, or the temperature gauge running higher than normal.
- Why it happens
- Old coolant mixed with oil or air from a leaking intake gasket breaks down into sludge that clogs the radiator and heater core.
- What to do
- Have the cooling system and intake gaskets checked. Fix the leak first, then flush the system thoroughly and refill with fresh coolant.
Hard starts and rough idle from clogged fuel injectors
- What you'll notice
- Hard starting, chugging, a rough idle and occasional misfires, sometimes with a check engine light.
- Why it happens
- GM issued repeated bulletins on these engines for fuel injectors clogged with deposits, which upset the fuel spray.
- What to do
- Try a quality fuel system cleaner and top-tier fuel first. If it continues, a shop can clean or replace the injectors.
Misfire from a failing ignition coil
- What you'll notice
- A shaking engine, loss of power, a flashing check engine light and misfire codes.
- Why it happens
- The ignition coils and the ignition module under them wear out. Worn spark plugs and wires add strain on the coils.
- What to do
- Have the misfire codes read. Replacing the bad coil, and plugs and wires if they are old, usually fixes it. Do not drive far with a flashing check engine light.
ABS warning light comes on
- What you'll notice
- The ABS light turns on now and then or stays on. The normal brakes still work, but anti-lock does not.
- Why it happens
- Usually a failing wheel speed sensor or its wiring. GM issued several bulletins on intermittent ABS lights on the Century.
- What to do
- Have the ABS codes read to find which wheel is at fault. The sensor is usually an inexpensive part.
Front wheel bearing growls
- What you'll notice
- A humming or growling noise from the front that gets louder with speed and changes when you turn.
- Why it happens
- The sealed front hub bearing wears out. Owners report replacing them on many Centurys.
- What to do
- Have the bearings checked. Replace a noisy one soon, since a failing bearing can get hot and loose.
Worn struts, springs and control arms
- What you'll notice
- Clunking over bumps, a bouncy or floaty ride, uneven tire wear, or the car sitting lower on one corner.
- Why it happens
- Struts, coil springs and control arm bushings wear out with age. Owners report broken front springs and worn lower control arms.
- What to do
- Have the front suspension inspected. Replace worn parts in pairs and get an alignment afterward.
Rear drum brakes stick or seize
- What you'll notice
- Grinding or scraping from the rear, a hot rear wheel, the car pulling, or a parking brake that does not release fully.
- Why it happens
- The rear drum brake parts and adjusters corrode and stick, especially in salty areas.
- What to do
- Have the rear brakes inspected. Shoes, drums and hardware are usually replaced on both sides.
Tilt steering column sticks in the up position
- What you'll notice
- The tilt steering wheel locks in the highest position or another position and will not release.
- Why it happens
- GM issued several bulletins about the tilt column mechanism sticking or binding.
- What to do
- Do not force the lever. A dealer or shop can repair the tilt mechanism under the bulletin procedure.
Gauges go dead and the car will not crank
- What you'll notice
- The instrument cluster stops working, warning lights come on, and the engine may not crank.
- Why it happens
- GM bulletins trace this to low ignition voltage through the ignition switch or body control module.
- What to do
- Have a shop check ignition switch output voltage. A new ignition switch or body control module is the usual fix.
Power window switch fails
- What you'll notice
- A window works only sometimes, works from one switch but not another, or stops responding completely.
- Why it happens
- The window switches wear out internally. They often work on and off for a while before failing completely.
- What to do
- Try the window from the driver's master switch and the door switch to narrow it down. A replacement switch is cheap and easy to fit.
Knocking or rattling when the engine is cold
- What you'll notice
- A knock, rattle or tap from the engine for the first few minutes after a cold start or under light load, which fades as the engine warms.
- Why it happens
- GM issued bulletins for cold-engine knock on these engines. In some cases the fix was replacing pistons, and GM later released coated service pistons.
- What to do
- If the noise goes away when warm and oil level and pressure are fine, it is usually not urgent. Have it checked if the noise gets louder or stays when warm.
Blower fan only works on high
- What you'll notice
- The heater and A/C fan works only on the highest setting, or not at all on some speeds.
- Why it happens
- The blower motor resistor burns out. It is a common and cheap part.
- What to do
- Replace the blower motor resistor. If the new one fails quickly, have the blower motor checked for drawing too much current.
Oil pan gasket leak
- What you'll notice
- Oil drips under the engine and oily residue on the bottom of the oil pan.
- Why it happens
- GM issued bulletins on repeat oil pan gasket leaks for these engines.
- What to do
- Check the oil level often. A shop can clean the area to confirm the leak before replacing the gasket.
Repair prices for your 2001 Buick Century
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and bolts, flush coolant, change oil
- Replace automatic transmission with a remanufactured unit
- Replace transmission pressure control solenoid
- Replace power window regulator (and motor if needed)
- Replace power window switch
- Flush cooling system and refill with fresh coolant
- Remove and clean, or replace, the six fuel injectors
- Replace ignition coil
- Replace front wheel speed sensor
- Replace front hub and bearing assembly (one side)
- Replace front struts or lower control arms (pair) and align
- Replace rear brake shoes, drums and hardware (both sides)
- Replace blower motor resistor
- Replace ignition switch
- Replace oil pan gasket
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace seat belt buckles (recall 00V-228)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…