Your 2008 Buick Lucerneproblems, repair costs and recalls
What we've documented about the 2008 Buick Lucerne: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Buick Lucerne
20 documented issues apply to 2008, most serious first.
Fuel pump relay and rear fuse block melt
- What you'll notice
- The engine cranks but will not start, or it stalls while driving and will not restart. Some owners notice a burning smell from under the rear seat.
- Why it happens
- The fuel pump relay plugs into a fuse block under the rear seat. The relay can overheat and melt its socket, and a seat frame tab pressing on the fuse block cover has been blamed. GM issued a bulletin about the seat touching this fuse block.
- What to do
- If the car stalls or will not start, have the fuel pump relay and rear fuse block checked before replacing the fuel pump. A melted fuse block needs to be replaced, not just the relay.
Fuel pump fails and engine stalls
- What you'll notice
- The engine sputters, loses power, stalls and will not restart, or cranks a long time before it starts.
- Why it happens
- The in-tank electric fuel pump wears out, and a failing relay or fuse block can also take the pump down with it.
- What to do
- Stalling in traffic is dangerous, so get it checked right away. Have fuel pressure tested and the relay checked before buying a pump.
Ignition key can slip out of Run (recall)
- What you'll notice
- The engine shuts off while driving, often after the key ring is bumped or the road is rough. Power steering and power brakes get much heavier.
- Why it happens
- A heavy key ring or a knee bump can turn the ignition out of Run. The airbags may then not deploy in a crash.
- What to do
- Take extra keys off the ring and have a Buick dealer check your VIN to make sure the recall was done.
Free at a Buick dealer if it was never done. Check your VIN.
Heated washer fluid system can overheat and catch fire (recall)
- What you'll notice
- A burning smell or smoke near the front of the car, or other electrical features acting up.
- Why it happens
- The heated windshield washer module can short circuit and overheat. GM recalled it twice and later disabled the system.
- What to do
- Have a Buick dealer check your VIN to confirm both recalls were done. Stop and turn the car off if you smell burning plastic.
Free at a Buick dealer if it was never done. Check your VIN.
Automatic transmission slips or fails
- What you'll notice
- Slipping, delayed or harsh shifts, the car will not move in some gears, or a check engine light.
- Why it happens
- The four-speed automatic can wear out its clutches or have valve body and solenoid problems. Owners report failures from about 57,000 miles up.
- What to do
- Have the fluid and codes checked when shifting changes. Early valve body or solenoid repairs cost far less than a rebuilt transmission.
Head gasket failure and overheating
- What you'll notice
- The temperature gauge climbs on the highway or on hills, coolant keeps disappearing, white smoke from the tailpipe, or milky oil.
- Why it happens
- The Northstar V8 is known for head gasket leaks, usually blamed on the head bolts losing their grip in the aluminum block. Once coolant gets into the cylinders the repair is very expensive.
- What to do
- Stop driving if the engine overheats. Have a cooling system and combustion leak test done. Get a written quote, because a full head gasket repair can cost more than an older car is worth.
Engine stalls from a failing crankshaft sensor or ignition module
- What you'll notice
- The engine cuts out while driving, often with the steering and brakes getting heavy, then may restart after a few minutes.
- Why it happens
- Owners report stalling traced to the crankshaft position sensor, the ignition control module or coil connections. Stalling while driving is the most common engine complaint on later Lucernes.
- What to do
- Have stored codes read as soon as it happens. If the fuel pump relay and rear fuse block check out, test the crank sensor and ignition parts next.
Shocks and struts leak or fail
- What you'll notice
- A floaty or bouncy ride, clunks over bumps, oily residue on the shocks, or a suspension warning on CXS and Super models.
- Why it happens
- The shocks and struts wear and leak. Models with magnetic ride control use costly electronic shocks, and GM issued bulletins for leaks and a loose shock connector.
- What to do
- Have the suspension inspected. If you have magnetic ride control, ask whether a connector repair fixes the warning before replacing shocks.
Power steering fluid leaks
- What you'll notice
- A whining pump, heavier steering, and red or amber fluid under the front of the car.
- Why it happens
- GM issued bulletins for leaks at the steering gear line connection and at the fluid reservoir.
- What to do
- Check the fluid level and have the leak found. Running the pump low on fluid can ruin it.
ABS, traction and StabiliTrak lights come on
- What you'll notice
- The ABS and traction lights come on together, and the dash may say Service StabiliTrak.
- Why it happens
- A wheel speed sensor, steering angle sensor or related wiring sends a bad signal, so the system shuts itself off. GM issued several bulletins for these codes.
- What to do
- Normal braking still works, but ABS and stability control may not. Have the codes read to find the faulty sensor.
No crank, no start with the security light on
- What you'll notice
- You turn the key and nothing happens, or the engine starts and dies, and the security light may be on.
- Why it happens
- GM issued bulletins for no-crank conditions caused by a voltage spike to the engine computer and by theft-deterrent problems.
- What to do
- Have the battery tested first, then ask a shop to check the GM bulletins for no-crank with the security light on.
No crank and dark gear display from damaged wiring
- What you'll notice
- The car will not crank and the gear indicator (PRNDL) light is out.
- Why it happens
- GM found that a wiring harness at the transmission could be damaged, cutting the signal that tells the car it is in Park.
- What to do
- Have a shop check the transmission wiring harness and follow the GM bulletin.
Reduced power and check engine light from the throttle body
- What you'll notice
- The check engine light comes on, the car hesitates, and it may go into a reduced power mode.
- Why it happens
- The electronic throttle body can get dirty or its sensors can fail. GM issued bulletins to inspect and service it.
- What to do
- Have the codes read. Cleaning or replacing the throttle body usually fixes it.
Intermittent check engine light and reduced power from a dash wiring connector
- What you'll notice
- The check engine light comes and goes, and the car may briefly drop into reduced power.
- Why it happens
- GM found poor connections at the wiring connector between the instrument panel and body harness.
- What to do
- Ask the shop to check the GM bulletin for this connector before replacing sensors.
Engine mounts break
- What you'll notice
- Heavy vibration at idle, a clunk when shifting into gear or when accelerating.
- Why it happens
- Owners report engine mounts that fail repeatedly.
- What to do
- Have the mounts inspected if you feel a clunk. Worn mounts can stress hoses and wiring.
Front wheel bearing hum
- What you'll notice
- A humming or grinding noise from a front wheel that gets louder with speed.
- Why it happens
- The sealed hub and bearing assemblies wear out.
- What to do
- Have the hubs checked. Replace the noisy one before it gets loose.
Oil leaks and burning oil smell
- What you'll notice
- A burning oil smell after driving, smoke from under the hood, or oil spots under the engine.
- Why it happens
- Gaskets and seals harden with age and let oil reach hot exhaust parts. On the Northstar V8, leaks from the lower engine seals can be costly because the engine may need to come out.
- What to do
- Have the leak found while it is small. Keep the oil level correct, and do not ignore smoke from under the hood.
Clunk in the steering when turning slowly
- What you'll notice
- A clunk or bump felt in the steering wheel when turning at low speed, like in parking lots.
- Why it happens
- The intermediate steering shaft that links the column to the steering gear wears. GM issued a bulletin to replace it.
- What to do
- It is usually not dangerous, but have a shop confirm the cause and ask about the GM bulletin.
Knock sensor codes and spark knock
- What you'll notice
- Check engine light with knock sensor codes, pinging under load, or a slight misfire.
- Why it happens
- GM issued a bulletin for knock sensor faults on the 3.8L V6.
- What to do
- Have the codes read and the knock sensors and wiring checked.
Corroded wheel rims leak air
- What you'll notice
- One or more tires slowly lose air, and the tire pressure light comes on.
- Why it happens
- Corrosion builds up where the tire bead seals against the alloy wheel.
- What to do
- Have the shop clean the rim seat and reseal the tire. Badly corroded wheels may need to be refinished or replaced.
Repair prices for your 2008 Buick Lucerne
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace fuel pump relay and rear fuse block
- Replace in-tank fuel pump module
- Replace automatic transmission with a remanufactured unit
- Replace Northstar head gaskets with head bolt thread repair
- Replace crankshaft position sensor or ignition control module
- Find and reseal oil leak (valve cover or oil pan gasket)
- Replace front struts or rear shocks (pair)
- Replace intermediate steering shaft
- Replace leaking power steering line or reservoir
- Replace wheel speed sensor or front hub
- Diagnose no-crank and repair per GM bulletin
- Repair transmission wiring harness
- Clean or replace electronic throttle body
- Repair instrument panel to body harness connector
- Replace knock sensor
- Replace engine mount or torque strut
- Replace front hub and bearing assembly (one side)
- Clean and reseal tire bead on wheel
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install new key ring and key insert (recall 14V-355)No charge if your vehicle is included
- Disable or repair heated washer module (recalls 08V-441 and 10V-240)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…