Your 1997 Buick Skylarkproblems, repair costs and recalls
What we've documented about the 1997 Buick Skylark: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Buick Skylark
15 documented issues apply to 1997, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping, a sweet smell after driving, wet spots or crusty residue near the top-center of the engine, or the engine starts to run hot. In bad cases the oil turns milky.
- Why it happens
- The 3.1L V6 uses lower intake manifold gaskets that break down with age, heat and the factory long-life coolant. Coolant then seeps out of the engine or into the oil.
- What to do
- Keep the coolant topped up and watch the temperature gauge. If the gauge climbs, pull over and shut the engine off. Have a shop pressure-test the cooling system and check the oil for coolant; replace the gaskets before coolant damages the engine bearings.
Water pump leak, coolant loss and overheating
- What you'll notice
- Low-coolant warnings, coolant drips under the front of the engine, a sweet smell, or the temperature gauge rising.
- Why it happens
- The water pump seal wears and leaks. On the 2.4L Twin Cam the pump is known for failures and is hard to get to, so replacing it costs much more than on the V6.
- What to do
- Don't keep driving with the temperature gauge high; an overheat can ruin the head gasket. Have the leak source confirmed with a pressure test and replace the pump. On the 2.4L, ask about replacing the timing chain parts at the same time.
Timing chain rattle or failure
- What you'll notice
- A rattle or slapping noise from the passenger side of the engine, loudest at startup, sometimes with a check engine light. If the chain breaks, the engine stops and won't restart.
- Why it happens
- The 2.4L Twin Cam from these years is known for timing chain wear and failures. Its small oil passages also make it sensitive to skipped oil changes.
- What to do
- If you hear a new rattle, have it checked soon rather than waiting for the chain to break. Keep up with oil changes using the right oil.
Ignition switch can overheat during long cranking (recall)
- What you'll notice
- A hot or burning plastic smell from the steering column, smoke from under the dash, or the key and switch acting up after a long period of cranking.
- Why it happens
- Holding the key in Start for a long time can overheat parts inside the ignition switch. GM recalled these cars (recall 02V-070 for 1996-1997 and 04V-036 for 1998) because a damaged switch could start a fire in the steering column, even after the car is turned off.
- What to do
- If you smell burning from the column, turn the car off, take the key out and get out. Don't hold the key in Start for long. Ask a GM dealer with your VIN whether the recall repair was done.
Underhood fuse box can short and start a fire (recall)
- What you'll notice
- Smoke or a burning smell from under the hood, often near the fuse and relay box.
- Why it happens
- A protective cover was left off the underhood fuse center on some cars. High current can then arc there and start a fire (recall 97V-059).
- What to do
- If you see smoke from under the hood, pull over, turn the car off and get out. Ask a dealer with your VIN whether the cover was installed under the recall.
Engine stalls or won't stay running
- What you'll notice
- The engine starts and dies after a few seconds, or it shuts off while driving, often at low speed or when pulling away. On some cars the security light blinks.
- Why it happens
- Owners trace it to several causes: the anti-theft system cutting fuel, a worn ignition switch, or fuel delivery and idle control problems. Many shops struggle to pin it down.
- What to do
- A stall can take away power steering and brake assist, so leave extra room and steer firmly to a safe spot. Note whether the security light is on and have the codes read while the problem is happening.
ABS light on, brakes grab or the pedal goes soft
- What you'll notice
- The ABS warning light comes on or flashes, the brakes lock or grab on wet roads or turns, the ABS kicks in when it shouldn't, or the pedal sinks and stopping takes longer.
- Why it happens
- Owners report recurring antilock brake faults and worn pads and rotors. Causes include wheel speed sensor faults and ABS unit problems, and dealers often could not reproduce them.
- What to do
- Brake problems are a safety issue. If the pedal feels soft or sinks, don't drive the car until a qualified shop inspects the brakes. If only the ABS light is on, normal brakes usually still work but ABS may not, so leave more stopping distance and get it checked soon.
Fuel tank can be damaged in a rear crash (recall)
- What you'll notice
- No warning sign in normal driving. After a rear-end collision you may smell fuel or see a leak.
- Why it happens
- On some 1997 cars, sheet metal near the left rear could damage the fuel tank or fuel lines in a rear impact and cause a leak (recall 96V-212).
- What to do
- After any rear-end crash, check for fuel smell or drips and don't start the car if you find them. Ask a dealer with your VIN whether this recall was done.
Engine surges or throttle sticks
- What you'll notice
- The car speeds up by itself, revs high under light throttle, idles very low and then surges, or the gas pedal feels stuck.
- Why it happens
- Owners report sudden surging and sticking throttles. In one crash case a shop blamed the cruise control cable jamming the throttle linkage.
- What to do
- If the car accelerates on its own, shift to Neutral, brake firmly and steer to a safe stop, then turn the engine off. Have the throttle body, accelerator cable and cruise cable inspected before driving again.
Car won't start or stalls from a worn ignition switch
- What you'll notice
- You turn the key and get a click or nothing, the dash lights don't come on, or the engine cuts out and the battery keeps going flat.
- Why it happens
- The ignition switch wears out on these cars. Some owners say problems continued even after the recall repair, and dealers also found wiring shorts and parasitic battery drains.
- What to do
- Have a shop test the battery and starter first, then check the ignition switch and wiring. If the car stalls while driving, steer to a safe stop; power steering and brakes get harder without the engine running.
Dashboard gauges stop working
- What you'll notice
- The speedometer, fuel gauge, temperature gauge or tachometer drop to zero, swing around, or die all at once. Warning lights may stay on.
- Why it happens
- The instrument cluster or its wiring on these GM compacts fails with age. This Skylark, Achieva and Pontiac Grand Am share the same platform and parts.
- What to do
- Without a working temperature or fuel gauge you can overheat or run dry, so check fluids and fuel by hand until it's fixed. Have a shop check fuses and connectors first, then test or rebuild the cluster.
Overheating from a rough radiator filler neck
- What you'll notice
- The temperature gauge climbs or coolant is lost even though no large leak can be found.
- Why it happens
- On 1997 models a rough radiator filler neck could keep the cap from sealing, letting coolant escape so the engine runs hot.
- What to do
- Stop and shut the engine off if the gauge reaches the red. Once it cools, have the cap and filler neck checked; a new radiator may be needed.
Alternator failure, battery light or burning smell
- What you'll notice
- The battery light comes on, lights dim, the battery keeps going flat, or there is a loud noise and burning smell from the alternator area.
- Why it happens
- Owners report failed alternators and, in one case, an alternator that caught fire at about 130,000 miles.
- What to do
- If you see smoke or smell burning, pull over and turn the engine off. Otherwise have the charging system tested; replace the alternator if it fails the test.
Ticking noise on cold starts
- What you'll notice
- A light ticking or rattle for the first moments after a cold start that fades as the engine warms.
- Why it happens
- Extra clearance between the piston pins and pistons makes noise until the parts expand with heat. GM documented this on these years.
- What to do
- If the noise goes away once warm and the oil level is right, it is usually harmless. If it gets louder, lasts when warm, or the oil light flickers, have it checked.
Power window stops working
- What you'll notice
- A window moves slowly, stops partway, or won't move at all, sometimes after working for a while.
- Why it happens
- The power window motors can overheat and fail.
- What to do
- Avoid running a slow window up and down repeatedly. Have the motor tested and replaced; check the regulator at the same time.
Repair prices for your 1997 Buick Skylark
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets, change oil and refill coolant
- Replace water pump and refill coolant
- Replace ignition switch
- No-start and stalling diagnosis
- Replace one ABS wheel speed sensor
- Replace power window motor, one door
- Repair or replace instrument cluster
- Replace radiator
- Replace alternator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Ignition switch recall repairNo charge if your vehicle is included
- Install underhood fuse center coverNo charge if your vehicle is included
- Rear sheet metal recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…