Your 2004 Chevrolet Astroproblems, repair costs and recalls
What we've documented about the 2004 Chevrolet Astro: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Chevrolet Astro
9 documented issues apply to 2004, most serious first.
Automatic transmission slips, shifts hard or fails
- What you'll notice
- Late or harsh shifts, the engine revving up between gears, slipping when warm, or the van losing reverse, second or overdrive. In the worst cases it will not move at all.
- Why it happens
- The 4L60-E four-speed automatic behind the 4.3L works hard moving a heavy van, and heat breaks down the fluid and wears clutches and internal parts such as the sun gear shell. Transmission failure is the most costly problem owners report for these vans.
- What to do
- Check the fluid level and smell with the engine warm. Dark or burnt fluid is a bad sign. If it slips or will not engage, stop towing or loading the van and get a transmission diagnosis; a rebuild or a replacement unit is usually needed. An add-on transmission cooler helps a rebuilt unit last.
ABS kicks in at low speed and the van rolls farther
- What you'll notice
- When slowing to a stop, usually under about 5 mph on dry pavement, the pedal pulses and buzzes as if on ice and the van keeps rolling. Stopping distances get longer and the ABS light may come on.
- Why it happens
- Rust builds up on the front wheel speed sensors and the toothed rings they read. The weak or uneven signal makes the ABS computer think a wheel is locking, so it lets off brake pressure when it should not. Owners report it widely on these vans.
- What to do
- Leave extra room when stopping and get it checked soon. A shop can clean the sensor mounting areas and replace corroded sensors; if that does not cure it, the ABS module may be at fault. Do not simply pull the ABS fuse as a permanent fix.
Rusted brake and fuel lines leak
- What you'll notice
- The brake pedal suddenly sinks toward the floor, brake fluid drips near a wheel, or you smell raw fuel around the van. A brake warning light may come on.
- Why it happens
- The steel brake and fuel lines run along the underside and rust through with age, especially where roads are salted. Lines can also wear through where they rub on other parts.
- What to do
- If the pedal goes soft or you smell fuel, stop driving and have it towed. Ask the shop to check every brake and fuel line, not just the one leaking, because the rest are usually in similar shape.
Battery cable or wiring rubbed through by steering parts
- What you'll notice
- A dead battery or no-start, sparks or a burning smell, everything electrical cutting out while driving, or the brake pedal sinking after a sharp turn. In some cases a fire started.
- Why it happens
- The positive battery cable and a wiring harness near the front passenger wheel can rub against the steering linkage and suspension as the wheels turn. Once the insulation wears through, the wire shorts to the frame, which can melt nearby brake lines or damage the engine and ABS computers.
- What to do
- Look along the battery cable and nearby wiring for shiny worn spots, melted insulation or rub marks. Have damaged wires replaced and secured with proper clips away from moving parts before they short.
Intake manifold gaskets leak coolant
- What you'll notice
- Coolant puddles on top of the engine where the intake meets the cylinder heads, a sweet smell, a falling coolant level, or overheating. Coolant mixing into the oil can turn it milky.
- Why it happens
- The 4.3L V6 uses intake gaskets that break down over time, which owners often link to the original Dex-Cool coolant. Coolant then seeps out of the joint, usually on the driver side.
- What to do
- Top up the coolant and watch the level and temperature gauge. Get it fixed soon, because coolant in the oil or overheating can ruin the engine. The fix is new upper and lower intake gaskets and fresh coolant.
ABS warning light from a failed ABS control module
- What you'll notice
- The ABS light stays on. Anti-lock braking is switched off, and some owners notice odd pulsing or a hard pedal before the light comes on.
- Why it happens
- The electronic brake control module that runs the anti-lock system fails with age, often well past 100,000 miles. RepairPal has dozens of reports on these vans.
- What to do
- Normal brakes still work, but drive gently and have the ABS codes read. Rule out a cheaper wheel speed sensor problem first, then replace or rebuild the module.
Misfires from worn ignition parts or vacuum leaks
- What you'll notice
- Jerking at highway speed, a shaky idle, and a check engine light with code P0300 or a single-cylinder misfire code.
- Why it happens
- The 4.3L fires its plugs through a distributor cap, rotor and long plug wires that wear out, and aging vacuum hoses split and let in extra air. Owners often find more than one of these at once.
- What to do
- Have the codes read. Replace the cap, rotor, wires and plugs as a set if they are old, and check the vacuum hoses for cracks. Do not keep driving with a flashing check engine light, since it can overheat the catalytic converter.
Power door locks stop working
- What you'll notice
- One or more doors will not lock or unlock with the switch or remote, or a lock clicks without moving.
- Why it happens
- The electric lock actuator inside the door wears out. It is one of the most reported problems on RepairPal for these vans.
- What to do
- Test each door to find which actuator has failed. Replacing the actuator inside the door panel usually fixes it.
Outside door handles break
- What you'll notice
- A door handle feels loose or snaps, and the door will not open from outside.
- Why it happens
- The plastic outside handles crack with age and use. RepairPal has more than 100 owner reports, on every door.
- What to do
- Replace the handle before it fails completely. On the sliding door, a broken handle can leave passengers unable to get out from the outside.
Repair prices for your 2004 Chevrolet Astro
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace 4L60-E automatic transmission
- ABS diagnosis; clean mounts and replace front wheel speed sensors
- Replace or rebuild ABS electronic brake control module
- Replace and re-route positive battery cable
- Replace upper and lower intake manifold gaskets and coolant
- Replace distributor cap, rotor, spark plug wires and spark plugs
- Replace power door lock actuator (one door)
- Replace outside door handle (one door)
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…