Chevrolet Camaroproblems, repair costs and recalls
Problems reported across 1996–2024. Pick your model year below to see what applies to your vehicle. Not produced 2003-2009.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
23 documented issues across all years, most serious first.
Coolant leaks and overheating (LT1)
- What you'll notice
- Coolant drips at the front of the engine, the temperature gauge climbs, and in bad cases white exhaust smoke or a milky oil cap.
- Why it happens
- The LT1 does not tolerate heat well, and leaks from the water pump or hoses can lead to overheating and a failed head gasket.
- What to do
- Stop driving if the gauge reaches hot. Have leaks found and fixed early, before the engine overheats.
Timing chain stretch (3.6L V6)
- What you'll notice
- Check engine light with timing codes such as P0008 or P0017, a rattle at startup, a rough idle or misfire, and loss of power.
- Why it happens
- The timing chains on the early 3.6L V6 can stretch early, and long gaps between oil changes speed it up.
- What to do
- Have the codes read and the chain checked soon. A badly stretched chain can jump and damage the engine. Keep oil changes on time.
Sticking cylinder-deactivation lifter (V8)
- What you'll notice
- A steady ticking from the engine, a misfire on one cylinder, and a check engine light.
- Why it happens
- The special lifters used to shut off cylinders for fuel economy can stick or collapse. Left alone, a bad lifter can wear out the camshaft.
- What to do
- Have it diagnosed promptly when a tick and misfire appear. Fixing a lifter early is far cheaper than replacing a damaged camshaft.
Knee can knock the key out of Run (recall)
- What you'll notice
- The engine shuts off while driving, often after the driver's knee bumps the flip key. Power steering and power brakes go away.
- Why it happens
- The flip-style key sits where a knee can push it out of the Run position. GM recalled 2010-2014 cars and later recalled replacement flip keys sold for 2010-2015 cars.
- What to do
- Check your VIN for both recalls. The dealer swaps the flip key for a fixed-blade key.
Power seat can drop suddenly (recall)
- What you'll notice
- A power-height-adjustable front seat suddenly drops down.
- Why it happens
- A shoulder bolt on the seat height adjuster can fall out.
- What to do
- Check your VIN for the recall and have the bolts replaced before regular driving. A seat that drops while driving can make you lose control.
Loose steering and control arm fasteners (recall)
- What you'll notice
- Clunks, wandering steering or looseness in the front end.
- Why it happens
- Some fasteners on the steering parts or lower control arm ball joint may not have been tightened properly and could come apart.
- What to do
- Check your VIN for the recall. If the front end feels loose, stop driving and have it towed in.
Water in the trunk damaging the rear fuse block
- What you'll notice
- No-start, a clicking or dead radio, a check engine light, random electrical faults, a damp trunk floor, and in rare cases smoke from the trunk.
- Why it happens
- Water can get past the trunk lid seal, tail light pockets, rear window seams or drains and reach the rear fuse block and wiring. GM issued a bulletin on finding the leak, repairing the wiring and adding a trunk drain.
- What to do
- If you see smoke or smell burning from the trunk, stop and shut the car off. Otherwise have the leak traced and the fuse block and battery cable checked for corrosion soon.
10-speed automatic can lock the rear wheels (recall)
- What you'll notice
- Harsh shifts or a sudden jolt and skid on a downshift; the rear wheels can briefly lock.
- Why it happens
- Internal valve wear in the 10-speed automatic can damage the transmission. GM's fix adds software that watches for the wear and limits gear use.
- What to do
- Check your VIN for this recall and have it done right away. If the transmission shifts harshly or jolts, limit driving until it is inspected.
Driver airbag inflator can rupture (recall 23V-516)
- What you'll notice
- Nothing is noticeable day to day. The risk only shows up if the driver airbag goes off in a crash.
- Why it happens
- A manufacturing fault lets the inflator housing break apart when it fires, so metal pieces can be thrown into the cabin.
- What to do
- Check the VIN with a Chevrolet dealer and have the free inflator replacement done before carrying passengers or driving much more.
Rear axle shaft can separate (recall 21V-188)
- What you'll notice
- A clunk or grinding from the rear, then the car losing drive even though the engine still runs.
- Why it happens
- A retaining ring was left off the axle shaft on some cars, so the shaft can slide out of the differential.
- What to do
- Stop driving and check the VIN for this recall. The axle is inspected and repaired free of charge.
Fuel pump missing its pressure regulator can leak (recall 19V-837)
- What you'll notice
- A strong fuel smell, a wet spot under the back of the car, or rough running and stalling.
- Why it happens
- Some fuel pumps were built without the pressure regulator, so pressure climbs until the pump housing cracks and leaks.
- What to do
- Stop driving, keep the car away from sparks and heat, and have the VIN checked. The pump is replaced free of charge.
Seat belt anchor bolts may be the wrong ones (recall 20V-811)
- What you'll notice
- Nothing shows up in normal use, and the belt latches and retracts as it should.
- Why it happens
- Bolts of the wrong grade were used at a belt anchor, so the anchor may not hold the load of a crash.
- What to do
- Check the VIN and have the free bolt replacement done before anyone relies on that belt.
Optispark distributor failure (LT1)
- What you'll notice
- Misfires, a rough or stumbling idle, hesitation when you press the gas, and a check engine light. It often shows up after rain, a car wash, or a coolant leak.
- Why it happens
- The LT1 uses a front-mounted Optispark distributor that sits low behind the water pump. Moisture and coolant can get inside it and upset the ignition signal.
- What to do
- Have the ignition system and the area around the water pump checked. Many owners replace the unit with a better-vented design, and any water pump leak above it should be fixed at the same time.
Seat belt retractor may not meet standards (recall)
- What you'll notice
- Usually nothing you can notice; a belt may not lock or retract as it should.
- Why it happens
- A small batch of cars was built with seat belt retractors that did not meet the federal standard.
- What to do
- Run your VIN through a recall check and have the retractors replaced if the car is listed.
Weak welds near the driver door hinge (recall)
- What you'll notice
- Usually nothing you can notice in normal driving.
- Why it happens
- Welds near the lower driver-side door hinge may not have been made to spec, which could weaken the body in a crash.
- What to do
- Check your VIN for this recall. Dealers add structural rivets to fix it.
Shudder from the 8-speed automatic
- What you'll notice
- A vibration like rolling over rumble strips at steady speeds with light throttle, roughly highway and suburban speeds.
- Why it happens
- The torque converter clutch shudders because the original transmission fluid absorbs moisture and breaks down. GM bulletins call for a full exchange to an updated fluid.
- What to do
- Ask a dealer about bulletins 16-NA-175 and 18-NA-355 and the updated fluid exchange.
Steering wheel emblem can come loose in an airbag deployment (recall 21V-211)
- What you'll notice
- You may notice the center emblem on the steering wheel sitting loose or lifting at an edge.
- Why it happens
- The emblem is not bonded well enough to stay put when the driver airbag inflates, so it can be thrown at the driver.
- What to do
- Have the VIN checked and the free recall repair done at your next convenient service visit.
False low-coolant warning
- What you'll notice
- The low-coolant light flickers or stays on even though the coolant is full.
- Why it happens
- The coolant level sensor on these cars is touchy and commonly fails, giving false warnings.
- What to do
- Check the coolant level with the engine cold first. If it is full, have the sensor tested and replaced.
Slow, noisy or failed power windows
- What you'll notice
- Windows move slowly, scrape or rattle, or stop working.
- Why it happens
- The window motors and regulators on this generation wear out, and the regulator rivets can break.
- What to do
- Have the motor and regulator checked. Replacing the worn part usually fixes it.
T-top roof leaks
- What you'll notice
- Water drips inside around the roof panels, wet carpets or a stained headliner after rain or washing.
- Why it happens
- The rubber seals around the removable T-top panels shrink and harden with age.
- What to do
- Have the T-top seals inspected and replaced, and dry the interior to stop mold and electrical problems.
Dim or failing rear lights
- What you'll notice
- Tail lights, brake lights or turn signals are dim or work only some of the time.
- Why it happens
- The rear bulb sockets and their connections corrode and loosen with age.
- What to do
- Have the sockets checked and replaced, ideally on both sides, so other drivers can see you brake and signal.
Convertible top leaks at the windshield corner
- What you'll notice
- Water drips in at the top corner of the windshield or the front pillar on convertibles.
- Why it happens
- The front weatherstrip on the folding top can sit out of position at the corner.
- What to do
- Ask a dealer about bulletin 16-NA-334, which repositions the weatherstrip.
Cold-start knock and oil use (LS1)
- What you'll notice
- A light knocking for the first few minutes after a cold start that fades as the engine warms up. Some engines also need oil topped up between changes, and a tired one may puff blue smoke at startup.
- Why it happens
- Owners and engine specialists usually put the noise down to the pistons fitting a little loosely in the cylinders until they warm up and expand. It is widely reported on this engine and is often harmless.
- What to do
- Check the oil level regularly and keep it topped up. If the knock does not go away when warm, or oil use climbs, have a shop do a compression or leak-down test.
Repair prices for your Chevrolet Camaro
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace Optispark distributor
- Replace water pump and refill coolant
- Replace coolant level sensor
- Replace power window motor or regulator
- Replace T-top weatherstrip seals
- Replace tail lamp bulb sockets
- Install structural rivets near driver door hinge
- Replace timing chains, guides and tensioners (3.6L V6)
- Replace flip key with fixed-blade keys and key rings
- Replace power seat height adjuster bolts
- Inspect and torque steering shaft and control arm fasteners
- Full transmission fluid exchange with updated ATF (per bulletin)
- Find and seal the leak, install trunk drain (GM bulletin 18-NA-375) and replace the rear fuse block
- Replace driver airbag inflator module
- Secure or replace steering wheel emblem
- Inspect and replace rear axle shaft
- Replace in-tank fuel pump module
- Replace seat belt anchor bolts
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer inspects and replaces seat belt retractor under recallNo charge if your vehicle is included
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.