Chevrolet Capriceproblems, repair costs and recalls
Problems reported across 1996–1996. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
17 documented issues across all years, most serious first.
Optispark distributor misfires, stalls or won't start
- What you'll notice
- The engine misses, idles rough, hesitates or stalls, often after rain, a car wash or a coolant leak. It may crank but not start, and the check engine light may come on.
- Why it happens
- Both V8s use GM's Optispark distributor, mounted low on the front of the engine behind the water pump. Moisture or coolant gets inside, and the cap and rotor can crack or carbon-track. GM issued a service bulletin (87-65-27) for this miss on 1994-1996 Caprices with either engine.
- What to do
- If it stalls or misfires badly, get to a safe spot and don't keep driving with a flashing check engine light. Have a shop check the Optispark cap and rotor and look for a water pump leak above it; fix the leak at the same time so the new part isn't ruined.
Water pump leaks coolant and the engine overheats
- What you'll notice
- Coolant drips at the front of the engine, the level keeps dropping, you smell sweet coolant, or the temperature gauge climbs.
- Why it happens
- The water pump is driven off the camshaft at the front of the engine. Its seal wears and the pump starts to weep, typically past 100,000 miles. The coolant often runs down onto the Optispark distributor below it.
- What to do
- Watch the temperature gauge and pull over and shut off the engine if it heads toward hot. Have the pump replaced soon, and have the Optispark checked for coolant damage at the same time.
Front lower ball joint nuts may loosen (recall)
- What you'll notice
- Clunking from the front end, loose or wandering steering, or uneven tire wear. In the worst case a front wheel can collapse.
- Why it happens
- On some 1996 Caprices the nuts holding the front lower ball joints to the steering knuckles were not tightened correctly at the factory. The joint can loosen, wear and separate from the knuckle, causing loss of control.
- What to do
- Ask a Chevrolet dealer to run the VIN for recall 96V-018. If you hear a clunk or the steering feels loose, have the front end inspected before driving at speed.
Free at a Chevrolet dealer if not already done. Check the VIN.
Wheel lug nuts may not be tight (recall)
- What you'll notice
- A clicking or knocking from a wheel, a vibration, or a wheel that feels loose.
- Why it happens
- Some 1995-1996 Caprices left the factory with lug nuts not tightened to spec. Loose nuts can let a wheel stud break and the wheel come off.
- What to do
- Ask a dealer to run the VIN for recall 96V-245. If you hear clicking from a wheel, stop and check the lug nuts before driving on, and have them torqued to spec by a shop.
Free at a Chevrolet dealer if not already done. Check the VIN.
Rear lower control arms can crack on police and taxi cars (recall)
- What you'll notice
- A clunk or rattle from the rear, the rear end feeling loose or steering itself, or visible cracks near where the rear sway bar bolts to the lower control arms.
- Why it happens
- On heavy-duty police (9C1) and taxi (9C6) package Caprices, the rear lower control arm can crack at the sway bar mount and eventually break. Many ex-police 1996 Caprices are now in private hands.
- What to do
- If your car is a former police or taxi car, ask a dealer to run the VIN for recall 96V-020 and have the rear control arms inspected. Don't drive hard on cracked arms.
Free at a Chevrolet dealer for covered police and taxi package cars. Check the VIN.
Engine stalls when shifted into reverse
- What you'll notice
- The engine dies when you stop and shift into reverse, sometimes on wet pavement, and you lose power steering and brake assist while backing up.
- Why it happens
- Owners of 1996 Caprices reported this stall to NHTSA, and GM issued a 1996 bulletin for a stall in reverse on these cars. Dealers sometimes reprogrammed or replaced the engine computer, with mixed results.
- What to do
- Let the engine idle a moment before shifting into reverse, and be ready to brake firmly if it stalls. Have a shop scan for codes and check the idle air control and the bulletin's fix.
4L60-E automatic slips or loses gears at high mileage
- What you'll notice
- Slipping, flaring revs between shifts, harsh or late shifts, or loss of upper gears. Some owners notice a clunk as it drops into gear.
- Why it happens
- The 4L60-E four-speed automatic is generally durable, but owners report wear-out problems on these cars beyond about 120,000 miles.
- What to do
- Check the fluid level and condition. If it is slipping or burnt-smelling, stop towing or hard driving and get a transmission diagnosis; a rebuild is often needed.
Fuel pump fails and the engine stalls
- What you'll notice
- The engine sputters, jerks or backfires under load, stalls while driving, or cranks but won't start, especially after sitting.
- Why it happens
- The in-tank electric fuel pump and sending unit wear out. Several 1996 Caprice owners reported pump failures to NHTSA, and the fuel gauge sender can also fail.
- What to do
- If the engine stalls in traffic, steer to safety; steering and braking get heavy. Have the fuel pressure tested before replacing parts.
Oil leak from the front engine seals
- What you'll notice
- Oil wets the front of the engine and the area around the distributor, with drips under the front of the car or a burning oil smell.
- Why it happens
- Several seals sit at the front of the engine, including the seal behind the water pump drive and the crankshaft balancer seal. On these LT1 engines they harden with age and leak, and the oil can reach the Optispark.
- What to do
- Check the oil level regularly and top it up. Have a shop find which seal is leaking; most of them mean removing the water pump and distributor, so it makes sense to do them together.
Rust in rear quarter panels and frame
- What you'll notice
- Bubbling paint or holes low on the rear quarter panels behind the rear wheels, rusty rear sway bar mounts, or flaking frame rails.
- Why it happens
- Salted winter roads attack the lower rear body panels, and these body-on-frame cars also rust on the frame and rear suspension hardware.
- What to do
- Have the frame rails and rear suspension mounts inspected on a lift, especially before buying. Surface rust can be treated; rot in the frame or mounts needs a body shop.
Serpentine belt chirps or power steering cuts out
- What you'll notice
- A chirping or squealing belt, or steering that suddenly gets heavy, often at low speed when turning in and out of driveways.
- Why it happens
- Owners reported belts that chirped or slipped and were replaced several times. A slipping or worn belt, tensioner or idler pulley can drop power steering assist.
- What to do
- If steering suddenly gets heavy, slow down and steer firmly. Have the belt, tensioner and pulleys checked; a broken belt also stops the alternator from charging.
Worn ball joints and fast front tire wear
- What you'll notice
- Clunks over bumps, loose or wandering steering, a pull to one side, and front tires wearing on the edges.
- Why it happens
- These heavy cars wear their front ball joints and bushings, and several owners reported alignment and tire wear problems that kept coming back. Owners often upgrade to stronger ball joints.
- What to do
- Have the ball joints and front end checked before an alignment. A badly worn ball joint can separate, so don't put it off if you hear clunking.
Transmission leaks at the rear output seal
- What you'll notice
- Red fluid drips under the middle of the car, near where the driveshaft meets the transmission.
- Why it happens
- The seal on the transmission's rear extension housing wears and leaks. RepairPal's owner reports put it at very high mileage, around 180,000-200,000 miles.
- What to do
- Check the transmission fluid level and keep it topped up. A shop can usually replace the seal without removing the transmission.
Door window won't go up or sits crooked
- What you'll notice
- A window binds, tilts in the frame, goes up slowly, or stops partway.
- Why it happens
- The plastic rollers (sliders) that guide the glass in its track wear out and break. The door panel clips are also brittle by now.
- What to do
- Keep the window closed if it might not go back up. A shop or a careful owner can replace the rollers; replace both in the door at the same time.
EGR valve failure turns on the check engine light
- What you'll notice
- The check engine light comes on, and you may feel rough idle, hesitation or pinging under load.
- Why it happens
- The exhaust gas recirculation valve on these engines is known to fail, and GM issued service information about EGR valve problems on the Caprice.
- What to do
- This is usually not urgent, but have the codes read. Pinging under load should be fixed soon because it can damage the engine.
Electric air pump corrodes and fails
- What you'll notice
- The check engine light comes on, or you no longer hear the air pump whir for the first minute after a cold start.
- Why it happens
- The electric air injection pump helps clean the exhaust after a cold start. When its check valves wear, moist exhaust gets back into the pump and corrodes it. GM issued a bulletin on water getting into the air pump.
- What to do
- Not a safety issue, but it can cause an emissions failure. Have the check valves replaced along with the pump so it doesn't happen again.
Odometer display goes blank or flickers
- What you'll notice
- The digital odometer reading fades, flickers or disappears.
- Why it happens
- Solder joints on the odometer display board crack with age and heat.
- What to do
- Not a safety issue. An instrument cluster repair shop can resolder the board. If you are buying one, be cautious if the odometer has been replaced or doesn't match the car's wear.
Repair prices for your Chevrolet Caprice
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace Optispark distributor (cap, rotor and housing)
- Replace water pump and refill coolant
- Replace front cover and water pump drive seals
- Rebuild or replace the 4L60-E automatic transmission
- Replace in-tank fuel pump
- Replace window regulator or motor (if new rollers don't fix it)
- Replace EGR valve
- Replace idler pulley (and drive belt)
- Replace front lower control arm with ball joint (one side)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall 96V-018 ball joint nut inspection and repairNo charge if your vehicle is included
- Recall 96V-245 lug nut retorqueNo charge if your vehicle is included
- Recall 96V-020 rear lower control arm replacementNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.