Your 2000 Chevrolet Cavalierproblems, repair costs and recalls
What we've documented about the 2000 Chevrolet Cavalier: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Chevrolet Cavalier
10 documented issues apply to 2000, most serious first.
Automatic transmission loses gears or slips
- What you'll notice
- The car shifts hard, slips, revs high on the highway because it won't go into 3rd or 4th, or loses all forward gears while reverse still works. A check engine light with shift-solenoid codes is common.
- Why it happens
- The 4-speed automatic used in most Cavaliers (4T40-E) has known weak points, including failing shift solenoids, a cracked oil feed tube weld, and worn internal bands and bearings.
- What to do
- Check the fluid level and smell, and have the trouble codes read. A solenoid or feed tube fault is a smaller repair; if the internal parts are worn, a rebuilt or used transmission is usually the fix.
Fuel pump fails, car stalls or won't start
- What you'll notice
- The engine dies while driving and won't restart, cranks but won't fire, sputters under load, or you hear a whine from the rear of the car. It may get worse when the engine is hot.
- Why it happens
- The electric fuel pump inside the gas tank wears out. Owners report this most often on 2003 and newer cars, typically around 70,000 miles.
- What to do
- If the engine cranks but won't start, have a shop check for fuel pressure before replacing parts. The fix is usually a new fuel pump module, and the filter should be replaced at the same time.
Head gasket leak and overheating
- What you'll notice
- The low-coolant light comes on, coolant drips near the cylinder head, the engine runs hot, or you see white exhaust smoke and milky oil.
- Why it happens
- On these older engines the aluminum cylinder head and iron block expand at different rates, which wears out the head gasket over time. Overheating makes it worse and can crack the head.
- What to do
- Stop driving if the temperature gauge climbs. Have a cooling system pressure test and a combustion leak test done. Catching it early can save the cylinder head.
Ignition switch can overheat during long cranking (recall)
- What you'll notice
- A burning smell from the steering column, a hot key area, or smoke after holding the key in Start for a long time when the engine won't fire.
- Why it happens
- Without a separate starter relay, high current runs through the ignition switch. Holding the key in Start for a long time can melt parts inside the switch and start a fire in the steering column. GM recalls 02V-070 (1996-1997) and 04V-036 (1998-2001) add a starter relay.
- What to do
- Don't hold the key in Start for more than a few seconds. Check your VIN for an open recall and have a dealer install the free relay kit.
A damaged switch is replaced under the recall too.
Timing chain or tensioner breaks
- What you'll notice
- A rattle or slapping noise from the front of the engine, then the engine quits and won't run. A broken chain can bend valves or damage the head.
- Why it happens
- The timing chain tensioner and damper wear out, letting the chain go slack until it skips or breaks.
- What to do
- If you hear a new rattle from the front of the engine, get it checked right away. Replacing the chain, tensioner and damper before it breaks costs far less than an engine repair.
Passlock anti-theft no-start
- What you'll notice
- The engine cranks but won't start, or starts and dies, and the security or theft light on the dash is on or flashing. It often happens on and off, and cold weather can make it worse.
- Why it happens
- The Passlock sensor in the ignition lock cylinder sends a wrong signal, so the car thinks it is being stolen and shuts off fuel.
- What to do
- Turn the key to On (not Start) and leave it about 10 minutes until the security light stops flashing, then try again. For a lasting fix, have a shop test the sensor and replace the lock cylinder or sensor.
Worn ignition switch: no crank or engine won't shut off
- What you'll notice
- Nothing happens when you turn the key, the starter works only some of the time, or the engine keeps running after you turn the key off.
- Why it happens
- Heavy current through the ignition switch wears its internal contacts over time.
- What to do
- Have the battery and starter tested first so you don't replace good parts. If they test fine, the ignition switch is the likely cause. Check for open recalls on 1996-2001 cars before paying for a repair.
Heater fan only works on high
- What you'll notice
- The blower fan does nothing on low and middle settings but works on the highest setting.
- Why it happens
- The blower motor resistor, which sets the lower fan speeds, burns out. The high setting bypasses it, which is why only high still works.
- What to do
- Replace the blower motor resistor behind the glove box area. If it fails again soon, have the blower motor checked, since a worn motor can overload the resistor.
Front strut squeak or groan when turning
- What you'll notice
- A squeak, creak or groan from the front when turning at low speed, a clunk over bumps, or the steering not returning to center smoothly.
- Why it happens
- The bearing and spring seat at the top of the front struts bind as they age. GM issued a service bulletin covering this.
- What to do
- Have the strut mounts checked. Replacing the mounts or the complete strut assemblies on both sides, then getting an alignment, usually fixes it.
Water leaks into the cabin or trunk
- What you'll notice
- Wet carpets, a damp or musty smell, or water pooling in the trunk after rain or a car wash.
- Why it happens
- Common entry points are rusted cowl corners below the windshield, clogged A/C or sunroof drains, and worn trunk and taillight seals.
- What to do
- Find the leak with a hose test before buying parts. Clear the drains and replace worn seals; rust holes need proper repair so the floor doesn't rot.
Repair prices for your 2000 Chevrolet Cavalier
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace shift solenoids, filter and fluid
- Replace in-tank fuel pump module and filter
- Replace head gasket (resurface head)
- Replace ignition lock cylinder or Passlock sensor
- Replace ignition switch
- Replace timing chain, tensioner and damper
- Replace blower motor resistor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install starter relay kit (recall 02V-070 / 04V-036)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…