Your 2010 Chevrolet Cobaltproblems, repair costs and recalls
What we've documented about the 2010 Chevrolet Cobalt: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Chevrolet Cobalt
11 documented issues apply to 2010, most serious first.
Ignition switch can slip out of Run (recall)
- What you'll notice
- The engine suddenly shuts off while driving, often after hitting a bump or bumping the key ring with your knee. Steering and braking get much heavier.
- Why it happens
- The ignition switch was made with too little turning resistance, so a heavy key ring or a jolt can move it from Run to Accessory. That cuts the engine and can keep the airbags from deploying in a crash. This defect was linked to deaths, and GM recall 14V-047 replaces the switch.
- What to do
- Check your VIN right away for open recall 14V-047. Until it's fixed, use only the ignition key with nothing else on the ring.
Power steering assist cuts out (recall)
- What you'll notice
- The steering suddenly becomes very heavy, especially at low speed, and a power steering warning may show. It can come and go.
- Why it happens
- The electric power steering motor or its sensor fails, so the system stops helping you steer. GM recalls 10V-073 and 14V-153 replace the motor, and GM extended coverage on it.
- What to do
- Hold the wheel firmly and slow down; you can still steer, it just takes more effort. Check your VIN for open recalls 10V-073 and 14V-153.
Owners report out-of-recall repairs can be costly; ask for a written quote.
Key can come out when not in Off (recall)
- What you'll notice
- You can pull the key out of the ignition even though it isn't fully in the Off position.
- Why it happens
- Wear in the ignition lock cylinder lets the key come out early. With an automatic, the car might not be in Park and could roll away. GM recall 14V-171 replaces the lock cylinder.
- What to do
- Always set the parking brake. Check your VIN for open recall 14V-171.
Timing chain rattle and tensioner failure
- What you'll notice
- A rattle from the engine on cold starts, a check engine light for timing codes, rough running, or in the worst case the engine won't start.
- Why it happens
- The timing chain tensioner and guides wear, especially if the oil runs low or isn't changed often, and the chain stretches and slaps.
- What to do
- Keep the oil full and changed on schedule. If the rattle lasts or timing codes appear, have the chain, guides and tensioner replaced before the chain jumps and damages the engine.
Driver curtain airbag wiring can short (recall)
- What you'll notice
- The airbag warning light may come on. The driver-side curtain airbag might not deploy in a side crash.
- Why it happens
- A misrouted wiring harness for the side-impact sensor can get damaged and short. GM recall 15V-500 reroutes and repairs it.
- What to do
- Check your VIN for open recall 15V-500 and get the airbag light checked.
Aftermarket ignition switch can slip out of Run (recall)
- What you'll notice
- On a car that had its ignition switch replaced with an aftermarket part, the engine can shut off while driving.
- Why it happens
- Some replacement ignition switches sold in auto parts stores have the same weak design as the original GM switch. Equipment recall 14E-021 covers them.
- What to do
- If your switch was ever replaced at an independent shop, ask what part was used and have the GM recall work done to install a correct switch.
Key gets stuck in the ignition
- What you'll notice
- The key won't turn back to Off or won't come out, even with the shifter in Park.
- Why it happens
- On automatic cars the shifter has to tell the ignition it's in Park before the key will release. A worn shifter switch, cable or lock cylinder breaks that link.
- What to do
- Jiggle the shifter firmly in Park and try again. A shop can test the shifter's park switch and cable; the shifter or lock cylinder is the usual fix.
Ignition coil failure and misfire
- What you'll notice
- The engine shakes or stumbles, especially when accelerating, the check engine light flashes, and the car may lose power or even stall.
- Why it happens
- The ignition coil pack (ignition module) fails, so one or more cylinders stop firing.
- What to do
- A flashing check engine light means stop driving hard, because unburned fuel can ruin the catalytic converter. Have the codes read; the coil pack and spark plugs are usually replaced together.
Front lower control arm bushings wear out
- What you'll notice
- A clunk or knock from the front over bumps, a shimmy or vibration at speed, or the car pulling and wearing tires unevenly.
- Why it happens
- The rubber bushings in the front lower control arms crack and wear, letting the arm move around.
- What to do
- Have the front end inspected. The usual fix is new control arms with fresh bushings, followed by an alignment.
Water pump leak
- What you'll notice
- Coolant drips or crusty residue at the front of the engine, a falling coolant level, or the temperature gauge rising.
- Why it happens
- The water pump seal on the 2.2L Ecotec wears with age and mileage and starts to leak.
- What to do
- Top up with the right coolant and have the leak pressure-tested. Replace the pump before the engine overheats.
Check gas cap message and check engine light
- What you'll notice
- A Check Gas Cap message or check engine light, sometimes with a slight fuel smell near the filler.
- Why it happens
- A worn gas cap seal or a corroded fuel filler neck lets fuel vapor escape, and the emissions system flags a leak.
- What to do
- Tighten the cap until it clicks. If the message returns, try a new cap; if that doesn't fix it, have the filler neck and evaporative system smoke-tested.
Repair prices for your 2010 Chevrolet Cobalt
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace shifter park switch/shifter assembly or lock cylinder
- Replace timing chain, guides and tensioner
- Replace ignition coil pack and spark plugs
- Replace gas cap (or filler neck if corroded)
- Replace front lower control arm(s) and align
- Replace water pump
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition switch (recall 14V-047)No charge if your vehicle is included
- Replace electric power steering motor (recalls 10V-073 / 14V-153)No charge if your vehicle is included
- Replace ignition lock cylinder and keys (recall 14V-171)No charge if your vehicle is included
- Repair and reroute side-impact sensor harness (recall 15V-500)No charge if your vehicle is included
- Replace with correct ignition switch (recall 14E-021 / 14V-047)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…