Your 2011 Chevrolet Cruzeproblems, repair costs and recalls
What we've documented about the 2011 Chevrolet Cruze: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 Chevrolet Cruze
13 documented issues apply to 2011, most serious first.
Coolant leaks from water pump, housings and reservoir
- What you'll notice
- Low coolant in the reservoir, a sweet antifreeze smell inside or outside the car, overheating, weak heat, or an A/C off due to high engine temperature message.
- Why it happens
- Many plastic cooling parts on the 1.4 turbo crack or leak with age, including the thermostat housing, water outlet, reservoir and water pump. GM extended water pump coverage on many 2011-2014 cars under bulletin 14371A.
- What to do
- Check coolant regularly and fix leaks quickly. Ask a dealer whether the water pump coverage applies to your VIN. Do not drive if the temperature gauge climbs, because overheating can ruin the engine.
Timing belt must be replaced on schedule
- What you'll notice
- Usually no warning. The engine suddenly quits while driving and then cranks but will not start.
- Why it happens
- The 1.8L engine uses a rubber timing belt rather than a chain, and it is an interference design. If the belt breaks, the valves can hit the pistons.
- What to do
- If there is no record of a belt, tensioner and idler change around the interval in the owner's manual, have it done now. If the engine dies and will not restart, have it towed rather than cranking it.
Steering wheel or steering shaft not fully secured (recalls)
- What you'll notice
- Play or looseness in the steering wheel, clunking in the steering, or the wheel not turning the car as expected.
- Why it happens
- On some early cars the steering wheel was not properly fastened, and on others the bolt joining the steering shaft to the steering gear was not fully seated. Either could lead to loss of steering. GM recalled affected cars.
- What to do
- Check the VIN for open recalls. If the steering feels loose in any way, stop driving and have it towed to a dealer.
Shifter may show Park when not in Park (recall)
- What you'll notice
- The car rolls after you shift to Park and shut it off, or the gear indicator does not match the gear.
- Why it happens
- The shift linkage could be installed wrong at the factory, so the transmission might not be in Park even when the shifter says it is. GM recalled affected cars.
- What to do
- Check the VIN for open recalls. Always set the parking brake until the repair is done.
Spilled oil can catch fire on the engine shield (recall)
- What you'll notice
- Burning oil smell or smoke from under the car, especially after an oil change.
- Why it happens
- Oil spilled during service could collect on the engine shield and ignite on hot parts. GM recalled affected cars.
- What to do
- Check the VIN for open recalls. If you see smoke from under the hood, pull over, shut the engine off and get away from the car.
Intermittent loss of power brake assist (recall)
- What you'll notice
- The brake pedal suddenly feels hard and the car takes longer to stop, sometimes with a brake warning.
- Why it happens
- The electric vacuum pump that helps power the brake booster might not switch on, cutting brake assist. GM recalled affected cars.
- What to do
- Check the VIN for open recalls. If the pedal turns hard, press much harder, stop safely and have it repaired before driving on.
PCV valve cover failure causes oil burning and vacuum leaks
- What you'll notice
- Rough idle, a whistle or hiss from the engine, blue exhaust smoke, oil use between changes, oil leaks, and a check engine light.
- Why it happens
- The crankcase ventilation diaphragm built into the valve cover can tear, and a check valve in the intake manifold can fail. Pressure builds in the engine and oil gets pulled in and burned. GM addressed it in bulletin PIP5197J.
- What to do
- Have a shop smoke-test for vacuum leaks and check the valve cover. Replacing the valve cover, and the intake manifold if needed, usually fixes it.
Loose negative battery cable causes warning messages
- What you'll notice
- The dash display flickers or shuts off, and ABS, traction control or power steering messages pop up, sometimes with steering assist dropping out.
- Why it happens
- The negative battery cable can develop a poor connection. GM issued bulletin 14311B and extended coverage to replace the cable.
- What to do
- Ask a Chevrolet dealer whether the cable coverage applies to your VIN. Have the battery and cable connections tested if warnings come and go.
Turbocharger underboost and wastegate problems
- What you'll notice
- Weak acceleration, hesitation, a whining noise from the front of the engine, and a check engine light for low boost.
- Why it happens
- The turbo's internal wastegate can stick or its seat can crack. Vacuum leaks from a failed PCV system or a loose charge pipe can cause the same symptoms.
- What to do
- Have vacuum and boost leaks checked first, since those are simpler fixes. If the turbo itself is at fault, it usually needs to be replaced.
Ignition coil failure and misfires
- What you'll notice
- The engine shakes or stumbles, power drops, and the check engine light comes on or flashes.
- Why it happens
- The ignition coil pack can corrode and fail over time, often together with worn spark plugs.
- What to do
- Get the code read. Replace the faulty coil and any old spark plugs, and check the PCV system if misfires keep coming back.
6T40 automatic hard shifting, loss of reverse or failure
- What you'll notice
- Harsh or delayed shifts, slipping, no reverse gear, or the transmission failing outright.
- Why it happens
- The 6T40 six-speed automatic in early Cruzes draws many complaints for hard shifting and internal failures. Leaking transmission cooler lines can also run it low on fluid.
- What to do
- Check for fluid leaks at the cooler lines and have the fluid and codes checked. If it slips or loses reverse, limit driving and get it diagnosed before the damage spreads.
Fuel tank strap brackets missing welds (recall)
- What you'll notice
- Usually nothing you would notice day to day. The risk shows up in a crash.
- Why it happens
- Welds on the fuel tank strap brackets could be missing, so the tank might come loose and leak fuel in a crash. GM recalled affected cars.
- What to do
- Check the VIN for open recalls and get the free repair done.
Key can come out when not in Park (recall)
- What you'll notice
- You can pull the key out of the ignition even though the shifter is not in Park.
- Why it happens
- A faulty park lock lever or key cylinder housing could let the key come out with the transmission not in Park, so the car could roll away. GM recalled affected cars.
- What to do
- Check the VIN for open recalls. Always confirm the car is in Park and set the parking brake before getting out.
Repair prices for your 2011 Chevrolet Cruze
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace valve cover with built-in PCV valve
- Replace water pump (most common coolant leak source)
- Replace negative battery cable
- Replace turbocharger
- Replace ignition coil pack and spark plugs
- Replace timing belt, tensioner and idler pulley
- Rebuild 6T40 automatic transmission
- Inspect and secure steering wheel and intermediate shaft
- Inspect and adjust shift linkage
- Modify engine shield to keep oil off it
- Add fasteners to fuel tank strap brackets
- Replace microswitch in brake booster vacuum pipe
- Replace ignition key cylinder lock housing
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…