Your 2005 Chevrolet Equinoxproblems, repair costs and recalls
What we've documented about the 2005 Chevrolet Equinox: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Chevrolet Equinox
4 documented issues apply to 2005, most serious first.
Intake or head gasket failure and coolant loss
- What you'll notice
- The coolant level keeps dropping, a sweet smell, overheating, the heater going cold, or white smoke from the exhaust.
- Why it happens
- The gaskets on this older GM V6 commonly start leaking at higher mileage, letting coolant escape outside the engine or seep into it.
- What to do
- Check the coolant level often. If the engine runs hot, pull over and shut it off, then have the gaskets pressure-tested before the engine is damaged.
Heater blows only cold air
- What you'll notice
- The heat stays cold no matter the setting, or the temperature does not change, and the defroster cannot clear the windshield well.
- Why it happens
- The door that blends hot and cold air, or the plastic shaft and actuator that move it, breaks inside the dash.
- What to do
- Have the blend door and actuator checked. Until it is fixed, make sure you can keep the windshield clear in cold or damp weather.
AWD driveshaft center bearing or U-joint wear
- What you'll notice
- A vibration that builds around highway speed, a clunk when taking off, or grinding from under the middle of the vehicle.
- Why it happens
- On all-wheel-drive models the support bearing in the middle of the rear driveshaft and the U-joints wear out. A badly worn joint can let the shaft come loose.
- What to do
- Have the driveshaft and its bearing inspected soon if you feel new vibration or hear clunks. Do not wait for it to get worse.
Key sticks in the ignition
- What you'll notice
- The key is hard to turn or will not come out of the ignition, sometimes along with trouble starting.
- Why it happens
- The ignition lock cylinder or switch wears and starts to bind.
- What to do
- Do not force the key. Have the lock cylinder and switch checked before it leaves you unable to start or shut off the car.
Repair prices for your 2005 Chevrolet Equinox
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets
- Replace broken temperature blend door (dashboard removal)
- Replace rear driveshaft center support bearing
- Replace ignition lock cylinder
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…