Your 1998 Chevrolet Luminaproblems, repair costs and recalls
What we've documented about the 1998 Chevrolet Lumina: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1998 Chevrolet Lumina
13 documented issues apply to 1998, most serious first.
Lower intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping, a sweet smell or green/orange drips at the front of the engine, the temperature gauge climbing, or milky oil on the dipstick. Some owners notice weak heat or a check engine light.
- Why it happens
- The plastic-framed lower intake manifold gaskets on these V6 engines break down with age and long-life coolant, letting coolant leak outside the engine or into the oil. It is the most reported Lumina problem, usually showing up around 100,000 miles, and GM issued several bulletins with revised gaskets.
- What to do
- Check the coolant level when the engine is cold and watch the temperature gauge. If coolant is mixing with the oil, stop driving and have the gaskets replaced before the engine bearings are damaged.
Steering gets stiff or binds in left turns (recall)
- What you'll notice
- The steering wheel suddenly gets hard to turn, binds or locks briefly, usually during a left turn, sometimes with grinding or clunking from the front.
- Why it happens
- Bearing balls can escape from the lower pinion bearing in the power steering rack because the retainer tabs were not crimped properly, letting the pinion shaft push upward. GM recalled the steering gear (NHTSA campaign 03V527) to install a new lower pinion bearing or replace the rack.
- What to do
- Have a Chevrolet dealer check your VIN for open steering recalls. If steering binds, drive gently and get it repaired right away.
Stalls while driving or cranks but won't start
- What you'll notice
- The engine sputters and dies, cuts out when slowing for a stop, hesitates, or turns over but won't fire. A check engine light may come on.
- Why it happens
- Owners trace this to several causes, including a failing engine computer (PCM), ignition module and fuel delivery problems. It is one of the most reported problems on the 1996 model.
- What to do
- Have the codes read and check fuel pressure and spark while it is acting up. Stalling in traffic is dangerous, so don't put this off.
Head gasket failure and overheating
- What you'll notice
- The engine runs hot, coolant disappears, white exhaust smoke, milky oil, knocking, or rough running.
- Why it happens
- Head gasket failures are reported on the 3.1L V6, often after overheating, sometimes linked to an earlier intake gasket coolant leak that went unnoticed.
- What to do
- Stop driving if the gauge reaches the red. A cooling-system pressure test and a combustion leak test will confirm the problem before more damage is done.
Oil can leak onto the exhaust and start a fire (recall)
- What you'll notice
- A burning-oil smell, smoke from under the hood, oil around the valve cover, or in the worst cases an engine fire.
- Why it happens
- On the 3.8L V6, oil can leak from the valve cover gasket onto the hot exhaust manifold. GM recalled these engines (campaign 15V701) to fix the leak; owners report parts delays and confusion about coverage.
- What to do
- Check your VIN for open recalls. If you smell burning oil or see smoke, pull over, turn off the engine and get away from the car.
Warped rotors and fast brake wear
- What you'll notice
- Pulsing in the pedal or vibration when braking, grinding or squealing, and pads that wear out quickly.
- Why it happens
- Brakes are one of the largest complaint groups for these years. Owners describe repeated pad replacement and warped or cracked rotors.
- What to do
- Have the pads and rotors measured. Replace rotors in pairs and use good quality pads; don't ignore grinding, which means metal-on-metal contact.
ABS problems: light on or pump runs on its own
- What you'll notice
- The ABS light comes on, the ABS pump runs when it shouldn't, or the pedal feels wrong in a hard stop.
- Why it happens
- GM issued a bulletin for the ABS pump running when not needed, and owners report failed wheel speed sensors setting the ABS light.
- What to do
- Have the ABS codes read. Normal braking usually still works, but the anti-lock function may be off until it is fixed.
Hard starts and rough idle from clogged fuel injectors
- What you'll notice
- Long cranking before the engine starts, chuggle, a rough idle, or misfires.
- Why it happens
- Deposits build up on the fuel injectors. GM issued bulletins for hard starts, chuggle and misfire caused by injector deposits.
- What to do
- Try a quality fuel system cleaner and top-tier gasoline. If it continues, have the injectors professionally cleaned or replaced.
Misfire from a failing ignition module or plug wires
- What you'll notice
- Rough running, shaking at idle, loss of power, and a check engine light, sometimes flashing.
- Why it happens
- GM issued bulletins for misfire caused by the ignition control module and for spark plug wire failure.
- What to do
- Have the misfire codes read. A flashing check engine light means you should drive gently and get it checked soon to protect the catalytic converter.
Fuel gauge reads wrong
- What you'll notice
- The gauge shows the wrong level or jumps around, reads full when nearly empty, or the low-fuel chime sounds too early.
- Why it happens
- GM issued several revisions of a bulletin for inaccurate or fluctuating fuel gauges and early low-fuel chimes. The fuel level sender in the tank is usually involved.
- What to do
- Track your mileage between fill-ups so you don't run dry. A shop can test the sender and gauge to find which one is at fault.
Knocking or rattle when the engine is cold
- What you'll notice
- A knock or rattle for the first minutes after a cold start that fades as the engine warms up.
- Why it happens
- The 3.1L V6 is known for piston slap when cold. GM released revised polymer-coated service pistons and a bulletin on cold-start rattle.
- What to do
- If the noise goes away when warm and oil pressure is normal, it is usually harmless. A noise that stays when warm needs a proper diagnosis.
Grinding or growling when parked on a hill
- What you'll notice
- A grinding or growling noise from the transmission while in Park on an incline.
- Why it happens
- GM issued a bulletin for this noise on the 4-speed automatic when the car is parked on a slope.
- What to do
- Use the parking brake before shifting into Park on hills. Have it checked if the noise appears on level ground.
Chuggle or surge at highway speeds
- What you'll notice
- A light bucking or chuggle feeling at steady highway speed or on light acceleration, with no warning light.
- Why it happens
- GM issued a bulletin for intermittent chuggle with no trouble codes, usually related to the torque converter clutch.
- What to do
- Have a shop check transmission fluid and torque converter clutch operation.
Repair prices for your 1998 Chevrolet Lumina
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and refill coolant
- Diagnose and replace the failed part (engine computer, ignition module or fuel pump)
- Replace head gaskets
- Replace front brake pads (rotors extra if warped)
- ABS and brake system inspection and code read
- Diagnose fuel gauge and fuel level sender
- Remove and clean or replace fuel injectors
- Replace spark plug wires or ignition control module
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace lower pinion bearing or steering rackNo charge if your vehicle is included
- Recall repair of the valve cover oil leakNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…