Chevrolet Silverado 1500problems, repair costs and recalls
Problems reported across 1999–2027. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
20 documented issues across all years, most serious first.
Rusted brake lines can burst
- What you'll notice
- The brake pedal suddenly sinks toward the floor, the brake warning light comes on, or you find brake fluid dripping along the frame rail. Some owners lost most of their braking with no warning.
- Why it happens
- The steel brake lines run exposed along the frame and corrode from road salt over the years. A rusted line can split under hard braking. Federal regulators investigated this across GM trucks and SUVs of this era, with most failures in snowy, salted states.
- What to do
- If the pedal goes soft or fluid is leaking, do not drive the truck. Have every brake line inspected on a lift and replace corroded sections, ideally all of them at once.
Collapsed valve lifter (AFM V8)
- What you'll notice
- A ticking or tapping from the engine, a misfire code, rough running, and a flashing or steady check engine light. Misfires often show up on the cylinders that shut off for fuel economy.
- Why it happens
- The special lifters used by the cylinder-deactivation system can stick or collapse. A failed lifter can wear the camshaft and send metal through the engine.
- What to do
- Have the misfire diagnosed soon. Avoid hard driving and long trips until it is checked, because a failed lifter can damage the camshaft.
Hard brake pedal from vacuum pump failure (recall)
- What you'll notice
- The brake pedal suddenly feels hard and the truck takes much longer to stop.
- Why it happens
- These V8s use an engine-driven pump to supply vacuum for the power brakes. Its oil inlet screen can clog and the pump stops making enough vacuum. GM recalled the trucks for a brake module update that uses the anti-lock system to help brake.
- What to do
- Check your VIN for the recall. If the pedal turns hard, slow down carefully, leave extra stopping room, and have it repaired before driving normally again.
Lifter failure on V8s with cylinder deactivation
- What you'll notice
- Ticking from the engine, a chirp at startup, misfire codes, rough running, power loss, or hard starting.
- Why it happens
- The lifters that let the engine shut off cylinders can stick or collapse. A bad lifter can wear the camshaft and spread metal debris through the engine. Owners filed a class action, but GM has not issued a lifter recall.
- What to do
- Get a misfire or new tick checked right away and limit driving until it is diagnosed. Repairs usually mean replacing lifters and often the camshaft.
Driveshaft weld can separate (recall)
- What you'll notice
- Vibration or clunking from under the truck. If the driveshaft comes apart, the truck loses drive and may be damaged further.
- Why it happens
- A weld on the driveshaft may not have been made correctly at the factory. GM recalled affected trucks.
- What to do
- Check your VIN for the recall and get it done. Stop driving and have it towed if you hear a new clunk or feel a strong vibration from underneath.
Rear wheels can lock up (recall)
- What you'll notice
- The rear wheels can suddenly lock while driving, which can make the truck skid.
- Why it happens
- A part in the transmission valve body can cause a sudden downshift that locks the rear wheels. GM recalled affected diesel trucks, then issued a follow-up campaign for some trucks that got the wrong software.
- What to do
- Check your VIN for the recall and have it completed before driving the truck normally.
6.2L V8 engine failure (recall)
- What you'll notice
- Knocking, rough running, a check engine light, loss of power, or the engine stalling and seizing.
- Why it happens
- Some engines were built with connecting rods or crankshafts out of specification, or with debris in oil passages, which can ruin the bearings. GM recalled affected trucks, and federal investigators are still looking into the problem.
- What to do
- Check your VIN for the recall right away. If the engine knocks or loses power, stop driving and have it towed to a dealer.
Transfer case can lock the wheels - do not drive (recall)
- What you'll notice
- No warning at all before it happens. The front or rear wheels can suddenly lock up while driving.
- Why it happens
- A part was left out of the transfer case on some four-wheel-drive trucks, which can let the case seize and stop the wheels turning.
- What to do
- Do not drive the truck. Have it towed to a dealer, which inspects and replaces the transfer case free under the recall.
Rear bumper bracket may be too weak to tow (recall)
- What you'll notice
- Nothing until you tow. The hitch area can flex or give way under trailer load.
- Why it happens
- The bracket behind the rear bumper on some trucks is not strong enough for the rated hitch load, so a trailer can come off.
- What to do
- Do not tow until it is checked. The bracket and hitch are replaced free under the recall.
6.2L V8 engine failures outside the recall window (federal investigation)
- What you'll notice
- A deep knock from inside the engine that gets louder as the engine speeds up, often with an oil pressure warning, followed by sudden loss of power or an engine that will not restart.
- Why it happens
- Federal investigators are looking at the same connecting rod bearing and crankshaft faults behind the earlier 6.2L recall still turning up in engines built after the recall period, with metal debris in the oil and crankshafts that may be finished out of specification.
- What to do
- Stop driving and have the engine inspected if you hear knocking or get an oil pressure warning, because continuing can seize it. Ask a dealer to run your VIN against open campaigns, and keep oil change records in case coverage is extended.
Instrument cluster gauges stick or quit
- What you'll notice
- The speedometer, fuel, temperature or oil pressure needle sticks, reads wrong, or drops to zero. Some trucks lose the whole gauge cluster or have dash lights flicker.
- Why it happens
- The small motors that drive each gauge needle fail, and solder joints on the cluster circuit board crack. GM offered special coverage on some 2003-2004 trucks.
- What to do
- Have the cluster tested and repaired or rebuilt. Ask a GM dealer whether your truck falls under the old special coverage. Do not rely on a faulty fuel or temperature gauge.
5.3L V8 burns oil
- What you'll notice
- The oil level drops noticeably between changes, with blue smoke at startup, fouled spark plugs, misfires, or a low-oil warning. Most complaints involve 2010-2013 trucks.
- Why it happens
- When the cylinder-deactivation system shuts off cylinders, oil can be drawn past the piston rings. Carbon then sticks the rings and consumption gets worse. GM faced a class action over this engine.
- What to do
- Check the oil at every fill-up and never let it run low. Keep records and have a shop run an oil consumption test.
8-speed shudder and harsh shifts
- What you'll notice
- A shudder like driving over rumble strips at steady speeds, harsh 1-2 shifts, jerking near a stop, or a delay when shifting into gear.
- Why it happens
- The original transmission fluid absorbs moisture and lets the torque converter clutch shudder. Shift programming adds to the harshness. GM's bulletin calls for a fluid exchange with a revised fluid.
- What to do
- Ask a dealer about GM bulletin 18-NA-355 and any software updates before agreeing to major transmission repairs.
Diesel coolant control valve failure
- What you'll notice
- A check engine light and possible overheating.
- Why it happens
- The electrically controlled valve that routes coolant can fail. GM extended coverage on the part for 2023 trucks.
- What to do
- Watch the temperature gauge and stop if it climbs. Ask a dealer about GM special coverage N252508340.
Brake warning light may not come on when fluid is low (recall)
- What you'll notice
- No brake warning light even though the brake fluid is low and the pedal may feel soft or travel further than usual.
- Why it happens
- A software fault in the brake control module keeps the low-fluid warning from lighting up, so a leak can go unnoticed.
- What to do
- Check the brake fluid level yourself and have the software updated. The update is free and on many trucks can be done over the air.
Clunk felt in the steering wheel
- What you'll notice
- A knock or clunk you can feel through the steering wheel when turning at low speed, parking, or going over bumps.
- Why it happens
- The intermediate steering shaft that links the steering column to the steering gear develops play and binds as its slip joint dries out. GM issued a service bulletin for the noise.
- What to do
- Have the steering shaft checked. Lubricating or replacing it usually cures the noise. Get any looseness in the steering looked at promptly.
“Service 4WD” message and 4WD won't engage
- What you'll notice
- A Service 4WD message appears on the dash and the truck won't shift into four-wheel drive, takes a long time to engage, or shifts on its own.
- Why it happens
- Usually a fault in the transfer case shift system, such as the shift motor or actuator, its position sensor, or the dash selector switch.
- What to do
- Have the 4WD trouble codes read before replacing parts. Check the transfer case fluid level too.
Cracked dashboard
- What you'll notice
- Cracks open up in the top of the dash, often near the passenger air bag cover.
- Why it happens
- The dash material breaks down with years of sun and heat.
- What to do
- Mostly cosmetic. Use a sunshade and have any crack near the air bag cover looked at.
A/C stops blowing cold
- What you'll notice
- The air conditioning blows warm, sometimes all at once.
- Why it happens
- The condenser at the front of the truck can crack and leak refrigerant. The hose from the compressor to the condenser can leak too.
- What to do
- Have the system leak-tested and fix the leak instead of just recharging it.
Daytime running lights stay on with the headlights (recall)
- What you'll notice
- The daytime running lights stay lit when the headlights are on, and oncoming drivers flash you about the glare.
- Why it happens
- Body control module software does not switch the running lights off when the headlights come on, which makes the front of the truck too bright at night.
- What to do
- Have the body control module software updated. It is free under the recall and often available over the air.
Repair prices for your Chevrolet Silverado 1500
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace rusted brake lines (full preformed line set)
- Replace intermediate steering shaft
- Replace transfer case shift encoder motor
- Rebuild instrument cluster (replace gauge stepper motors)
- Replace pistons and rings (GM oil consumption fix)
- Replace valve lifters and camshaft
- Replace upper dash pad
- Replace brake vacuum pump
- Replace A/C condenser and recharge system
- Transmission fluid exchange with updated GM fluid
- Replace rear driveshaft
- Reprogram transmission control software (recall remedy)
- Replace engine assembly
- Replace engine coolant flow control valve
- Inspect and replace the transfer case
- Replace rear bumper bracket and trailer hitch
- Update brake control module software
- Update body control module software
- Replace the engine long block after rod bearing failure
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.