Your 2003 Chevrolet Trackerproblems, repair costs and recalls
What we've documented about the 2003 Chevrolet Tracker: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Chevrolet Tracker
10 documented issues apply to 2003, most serious first.
Front crossmember rusts and control arm can break loose
- What you'll notice
- The truck pulls hard to one side when braking, the steering feels loose or wanders, clunks from the front end, a front tire rubs or wobbles. In the worst cases a lower control arm tears away from the frame.
- Why it happens
- The front suspension crossmember, which holds the lower control arms, rusts badly in road-salt states. GM started a special coverage program (number 06186) after NHTSA looked into control arms separating.
- What to do
- Have the crossmember inspected now, especially if you live where roads are salted. If you feel pulling or clunking, stop driving and have it towed. Ask a Chevrolet dealer whether your VIN was covered by the program.
Engine overheats
- What you'll notice
- The temperature gauge climbs, steam or coolant smell from the engine bay, or the heater blows cold.
- Why it happens
- Overheating is the top reported problem for the 2003 Tracker, and repairs are often costly. Coolant leaks, a failing radiator or water pump, or a blown head gasket can all cause it.
- What to do
- Pull over and shut the engine off if the gauge goes into the red. Have the cooling system pressure-tested; driving hot can warp the cylinder head.
Engine shakes when coming to a stop
- What you'll notice
- Strong shaking or vibration through the vehicle as you slow to a stop or sit at idle.
- Why it happens
- Owners report heavy shaking at idle at high mileage. Worn engine mounts, a dirty throttle body or misfires are common causes.
- What to do
- Have the engine mounts inspected and check for misfire codes.
Ticking noise from the engine
- What you'll notice
- A light tick from the engine, cold or hot.
- Why it happens
- GM revised its bulletin on this tick noise several times between 2000 and 2003. The dealer follows the bulletin to find the source.
- What to do
- Check the oil level first. If the noise is new or getting louder, have it checked and mention GM's tick-noise bulletin.
Serpentine belt squeals or frays
- What you'll notice
- A squeal from the engine, especially on startup, or a belt that looks frayed or jumps off its grooves.
- Why it happens
- GM issued bulletins on frayed serpentine belts, belts jumping grooves and belt squeal.
- What to do
- Replace a frayed belt right away; if it comes off you lose charging and power steering. Have the pulleys checked for alignment.
Brake pedal pulsates from rotor corrosion
- What you'll notice
- The brake pedal or steering wheel pulses or vibrates when braking, especially at higher speeds.
- Why it happens
- Corrosion between the wheel hub and brake rotor makes the rotor run out of true. GM issued bulletins for this and for rear brake pulsation.
- What to do
- Have the rotors measured. Resurfacing or replacing the rotors and cleaning the hub face fixes it.
Front end creaks or pops over bumps and in turns
- What you'll notice
- Creaking, squeaking or popping from the front suspension over bumps or when turning tightly.
- Why it happens
- GM issued a bulletin for front-end creaking and popping, and owners report squeaks when turning.
- What to do
- Have the front suspension checked. Rule out the crossmember rust problem first, since it can also cause noises.
Door handles break
- What you'll notice
- An inside or outside door handle snaps off and the door won't open from that side.
- Why it happens
- Owners report door handles breaking easily on these years.
- What to do
- Replace the handle. Open the door from the other side until it is fixed.
Rattle in neutral with clutch released
- What you'll notice
- On manual trucks, a rattle in low gear or neutral that stops when you press the clutch pedal.
- Why it happens
- Owners report this rattle on manual trucks. Worn input-shaft bearings or clutch parts are typical causes.
- What to do
- Have a shop check the transmission oil level and listen to the clutch and gearbox before it gets worse.
Check engine light from loose or worn gas cap
- What you'll notice
- The check engine light comes on with no change in how the engine runs.
- Why it happens
- The most common Tracker problem on RepairPal is a gas cap that doesn't seal, which sets an evaporative emissions code.
- What to do
- Tighten the cap until it clicks. If the light stays on after a few drives, replace the cap and have the codes read.
Repair prices for your 2003 Chevrolet Tracker
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front suspension crossmember and control arm bushings
- Diagnose overheating and repair cooling system or head gasket
- Replace worn engine mount
- Diagnose engine noise per GM bulletin
- Replace serpentine belt
- Clean hub faces and replace front brake rotors
- Replace worn control arm bushings or ball joints
- Replace door handle
- Replace clutch and related parts
- Check engine light diagnosis
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…