Your 2000 Chevrolet Ventureproblems, repair costs and recalls
What we've documented about the 2000 Chevrolet Venture: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Chevrolet Venture
13 documented issues apply to 2000, most serious first.
Lower intake manifold gasket coolant leak
- What you'll notice
- The coolant level keeps dropping, a sweet antifreeze smell, coolant drips near the front of the engine, overheating, or milky oil on the dipstick.
- Why it happens
- The 3.4L V6 used lower intake gaskets that break down over time and leak coolant, either outside the engine or into the oil. It is the most-reported problem on the Venture, and GM issued bulletins with a revised gasket.
- What to do
- Check the coolant level often and watch the temperature gauge. Have the cooling system pressure-tested and the gaskets replaced with the updated design before coolant contaminates the oil or the engine overheats.
Overheating that leads to head gasket or cylinder head damage
- What you'll notice
- The temperature gauge climbs, steam or white exhaust smoke, a sweet smell, loss of heat, or rough running after the engine has overheated.
- Why it happens
- Coolant loss, often from the intake gasket leak, lets the engine overheat. Running it hot can blow the head gaskets or crack a cylinder head.
- What to do
- Stop driving as soon as the gauge climbs. Have a combustion leak test done; fixing the coolant leak early avoids far bigger repairs.
Automatic transmission jerking, hard shifts or failure
- What you'll notice
- Jerking or banging into gear, harsh or erratic shifts, slipping, a whine at highway speed, loss of overdrive, or a check engine light with codes such as P1811 or P0742.
- Why it happens
- The 4-speed automatic suffers from a failing pressure control solenoid, worn clutches and valve body wear. GM issued several bulletins for firm shifts, shudder and slipping.
- What to do
- Have the codes read and the fluid checked as soon as shifting changes. A solenoid or valve body repair caught early can avoid a full rebuild.
Power sliding door can open while driving (recall)
- What you'll notice
- The power sliding door does not fully latch, or opens while the van is moving.
- Why it happens
- Weak welds in the door's unlatch actuator could jam it so the door doesn't latch. GM recalled the vans (01V-067 and 01V-264) to inspect and replace the actuator.
- What to do
- Keep kids buckled in and check the door is latched. Ask a dealer if both recall repairs were done.
Free at a Chevrolet dealer if it was never done. Check your VIN for open recalls.
Power sliding door can push a passenger's arm (recall)
- What you'll notice
- If a passenger holds the inside handle while the power door opens, their arm can be pulled into the seat back or armrest.
- Why it happens
- The power sliding door motor keeps pushing even when a hand is on the handle. GM recalled the vans (04V-597) to change how the door works.
- What to do
- Teach passengers not to hold the handle while the door opens. Check for an open recall with your VIN.
Free at a Chevrolet dealer if it was never done. Check your VIN for open recalls.
Power sliding door won't open, close or latch
- What you'll notice
- The power sliding door stops working, reverses while closing, looks closed but the alarm sounds when you shift out of Park, or rattles.
- Why it happens
- Worn cables, the motor, the latch and door switches all fail with use. GM issued several bulletins on power sliding door operation.
- What to do
- Use the door manually if you can. A shop can find whether the motor, cable or latch is at fault.
ABS or traction control light on
- What you'll notice
- The ABS or traction control light comes on, sometimes on and off, and anti-lock braking may stop working.
- Why it happens
- Wheel speed sensor and ABS module faults are the common causes. GM put out bulletins for ABS lights and wheel speed sensor diagnosis.
- What to do
- Normal braking still works. Have the ABS codes read to find the faulty sensor or wire.
Dead battery from power sliding door
- What you'll notice
- The battery is dead after the van sits overnight or for a few days.
- Why it happens
- On vans with power sliding doors, GM issued a bulletin for a battery drain linked to the door system.
- What to do
- Have a shop do a parasitic draw test. Disconnecting the door's power system for a test can confirm the cause.
Weak heat at idle in cold weather
- What you'll notice
- The heater blows lukewarm air at idle or low speed in freezing weather.
- Why it happens
- GM issued a bulletin for poor heater output at low engine speed below freezing, often helped by restoring full coolant level and flow.
- What to do
- Make sure the coolant is full first, since a low level from a leak is a common cause. Then ask a shop about the GM bulletin fix.
A/C weak in hot weather or noisy compressor clutch
- What you'll notice
- The A/C feels weak on hot, humid days, or there is a rattle or noise from the compressor at 1,000–2,000 rpm.
- Why it happens
- GM issued bulletins for weak A/C in hot, humid weather and for compressor clutch noise.
- What to do
- Have the A/C pressures and clutch checked rather than just adding refrigerant.
Water leaks at the windshield or overhead console
- What you'll notice
- Water drips from the overhead console or map light, or wet carpet after rain.
- Why it happens
- Gaps in the windshield seal and around the roof console let water in. GM issued bulletins for these leaks.
- What to do
- Dry the carpet to avoid mold and have a shop water-test and reseal the leak.
Headlights fog up or lenses come loose
- What you'll notice
- Moisture inside the headlights, dim lights, or a headlight lens falling off.
- Why it happens
- The headlamp seals let water in and lenses can loosen. GM issued bulletins for leaking headlamps.
- What to do
- Replace or reseal the headlamp so you can see well at night and the bulbs don't fail early.
Power window switch fails
- What you'll notice
- A power window won't go up or down from one or more switches.
- Why it happens
- Power window switches commonly wear out on the Venture.
- What to do
- Try the window from the driver's master switch to narrow it down, then replace the faulty switch.
Repair prices for your 2000 Chevrolet Venture
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and refill coolant
- Replace head gaskets (and cylinder head if cracked)
- Replace pressure control solenoid, or rebuild/replace the transaxle
- Repair power sliding door motor, cable or latch
- Parasitic drain test and door circuit repair
- Replace wheel speed sensor or repair wiring
- Cooling system service and heater flow repair
- A/C diagnosis and compressor clutch repair
- Water-test and reseal windshield or console area
- Replace headlamp assembly
- Replace power window switch
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…