Your 1996 Chrysler LHSproblems, repair costs and recalls
What we've documented about the 1996 Chrysler LHS: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1996 Chrysler LHS
15 documented issues apply to 1996, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Harsh or delayed shifts, slipping, the car refusing to shift into top gear, or the transmission suddenly locking up or quitting.
- Why it happens
- The electronically controlled automatic in these big Chrysler sedans is the most commonly reported expensive failure, usually after 80,000 miles or so. Worn clutches, low or burnt fluid and solenoid faults are typical causes.
- What to do
- Check the fluid level and condition (it should be red, not brown or burnt-smelling) and use only the Chrysler-specified ATF+4. If it slips or goes into limp mode, have the codes read before it gets worse.
Inner tie rod or steering rack failure
- What you'll notice
- Clunking when turning, loose or wandering steering that needs constant correction, or in bad cases a sudden loss of steering control.
- Why it happens
- Owners report inner tie rods wearing out early, tie rods separating from the rack, rack bushings breaking down and rack mounting bolts shearing. It is the most common complaint filed with NHTSA for every LHS year.
- What to do
- Treat any new clunk or play in the steering as urgent. Have the tie rods, rack bushings and mounting bolts inspected and replace worn parts before driving at speed.
Fuel rail or O-ring fuel leak (recall)
- What you'll notice
- Strong gasoline smell under the hood or in the cabin, wet fuel around the top of the engine, or in the worst case smoke or fire.
- Why it happens
- The plastic fuel injection rail on the 3.5L V6 could develop hairline cracks and its sealing O-rings could leak, dripping fuel near hot engine parts. Chrysler recalled these cars, but owners report some leaks returning after the repair.
- What to do
- Stop driving if you smell raw fuel. Have a dealer check whether recall 98V184000 was done; if it was and the leak is back, have the fuel rail and injector O-rings inspected right away.
Free at a Chrysler dealer if the recall was never done.
Car can roll away after the key is removed (recall)
- What you'll notice
- The shifter can be moved out of Park with the key out, or the key can come out when the shifter isn't fully in Park. Owners reported the car rolling and hitting things.
- Why it happens
- The ignition-park interlock in the floor shifter could fail. Chrysler recalled these cars to add a stronger push rod in the shifter.
- What to do
- Always set the parking brake. Ask a Chrysler dealer to check that recall 04V021000 was completed; the repair is free.
Free at a Chrysler dealer if the recall was never done.
Water pump failure damages the timing belt
- What you'll notice
- Coolant leaks or overheating, and in some cases the engine suddenly stops and won't restart because the timing belt failed.
- Why it happens
- On the 3.5L V6 the water pump is driven by the timing belt. A leaking or seized pump can ruin the belt, and because this is an interference engine, a snapped belt can bend valves.
- What to do
- Replace the water pump whenever the timing belt is done, and follow the timing belt interval. If you see coolant leaking from behind the timing cover, get it checked before driving far.
Overheating
- What you'll notice
- The temperature gauge climbs, especially in traffic, and the car may boil over.
- Why it happens
- Overheating is the single most-reported 1996 LHS problem. Owners trace it to failed cooling fans, cracked radiators and leaking water pumps.
- What to do
- Pull over and shut the engine off if the gauge goes into the red. Have the fans, radiator, cap and water pump checked before the head gaskets are damaged.
Stalling while driving or at idle
- What you'll notice
- The engine dies at a stop or at highway speed, sometimes restarting right away and sometimes not. Some owners also report idle surging.
- Why it happens
- Stalling is reported across every LHS year. The causes vary, so the fault codes stored at the time of the stall are the best clue.
- What to do
- Have the codes read as soon as possible after a stall, while they are still stored. Avoid highway driving until it is diagnosed.
Lower ball joint wear
- What you'll notice
- Clunking or knocking from the front end over bumps and loose steering. A badly worn joint can separate.
- Why it happens
- The lower ball joints wear out on these cars, and owners reported failures that affected steering.
- What to do
- Have the ball joints checked for play at every tire rotation or brake job, and replace them if any looseness is found.
Power steering leaks or heavy steering
- What you'll notice
- Steering suddenly becomes very heavy, especially on slow left turns, often with a whine or fluid spots under the front of the car.
- Why it happens
- The power steering rack or pump leaks fluid or loses assist as it wears.
- What to do
- Check the power steering fluid level. If it keeps dropping or the steering is heavy, have the rack and pump checked for leaks. Don't keep driving with no assist.
Clockspring failure: airbag light, horn and cruise stop working
- What you'll notice
- The airbag light comes on and stays on, and the horn, cruise control or steering-wheel buttons stop working.
- Why it happens
- The clockspring, a coiled ribbon cable behind the steering wheel, breaks with wear. When it fails, the driver airbag may not deploy.
- What to do
- Have the airbag codes read. Replacing the clockspring usually fixes it, and it restores the horn and cruise.
Worn subframe and control arm bushings
- What you'll notice
- Clunks over bumps, front-end shake, vibration, or the car pulling to one side.
- Why it happens
- The rubber bushings that mount the front subframe (cradle) and control arms wear out and crack.
- What to do
- Have the front suspension inspected. Replacing the worn bushings restores a quiet ride and steady handling.
Warped front brake rotors
- What you'll notice
- The brake pedal pulses and the steering wheel shakes when stopping, often at low mileage.
- Why it happens
- The front rotors on these heavy sedans warp and wear quickly.
- What to do
- Have the rotors measured. Replace them with quality rotors and pads, and have the lug nuts torqued correctly.
Instrument cluster or dash lights cut out
- What you'll notice
- Gauges or dash lights drop out while driving and then come back.
- Why it happens
- Owners trace this to loose ground connections and wiring faults behind the dash.
- What to do
- Have the cluster grounds and connectors checked and cleaned.
Cloudy, yellowed headlight lenses
- What you'll notice
- Headlights look hazy or yellow and light up the road poorly at night.
- Why it happens
- The plastic headlight lenses on these cars break down from sunlight and age.
- What to do
- Polishing or a restoration kit helps for a while. Replacement headlight assemblies are the long-term fix.
Trunk lid or hood supports won't hold
- What you'll notice
- The hood or trunk lid drifts down or drops suddenly.
- Why it happens
- The gas struts that hold the hood and trunk lid open lose pressure with age.
- What to do
- Replace the support struts. Don't rely on a weak strut to hold the hood up while you work.
Repair prices for your 1996 Chrysler LHS
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace power steering rack (or inner tie rods if only they are worn)
- Replace leaking power steering rack
- Replace water pump with timing belt and tensioner
- Replace radiator
- Diagnose stalling and read stored codes
- Replace airbag clockspring
- Replace headlight assembly (one side)
- Replace front control arm with bushings
- Replace front ball joint
- Front brake pads and rotors
- Replace trunk lid gas support struts
- Diagnose and repair cluster ground or wiring
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Reinforce or replace fuel rail and replace O-rings (recall 98V184000)No charge if your vehicle is included
- Install new shifter interlock push rod (recall 04V021000)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…