Daewoo Leganzaproblems, repair costs and recalls
Problems reported across 1999–2002. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
21 documented issues across all years, most serious first.
Camshaft position sensor can melt and start a fire (recall)
- What you'll notice
- A burning plastic or rubber smell, smoke from under the hood and the check engine light on. Some cars stalled or wouldn't start, and several owners reported fires.
- Why it happens
- The camshaft position sensor can overheat and melt, and the heat can spread to the cam cover and wiring harness and start a fire. Recalls 04V-357 and 04V-394 replace the sensor and add a fuse. Some owners said the sensor failed again after the fix.
- What to do
- If you smell burning or see smoke, pull over, turn the engine off and get everyone out. Daewoo's US dealers closed soon after the recall, so many cars never got the fix. Call NHTSA's recall line with your VIN and have a shop check the sensor, fuse and wiring.
Daewoo's US dealers closed, so a shop may charge for this. Ask for a written quote.
Timing belt or tensioner fails and bends valves
- What you'll notice
- The engine dies on the road, sometimes with all the warning lights on, and then cranks but won't start.
- Why it happens
- The 2.2L engine uses a rubber timing belt, and the valves hit the pistons if it breaks. Owners reported belt failures between about 60,000 and 84,000 miles, some caused by a failed tensioner bearing or the belt rubbing the engine. Repairs often meant bent valves or a replacement engine.
- What to do
- If you can't prove it was done, replace the belt, tensioner, idler pulleys and water pump now. Daewoo owners suggest about every 55,000 miles because the tensioner tends to fail first. If it has already broken, don't keep cranking; have it towed and tested before paying for repairs.
Overheating, blown head gasket or coolant in the cylinders
- What you'll notice
- The temperature gauge climbs, steam or white smoke comes from the engine or exhaust, coolant disappears, the oil looks milky, or the engine shakes at start-up.
- Why it happens
- Owners reported failed thermostats, blown head gaskets and coolant leaking into the cylinders, possibly from the intake manifold gasket. Adding cold water to a very hot engine cracked one owner's block.
- What to do
- If the gauge rises, pull over and shut the engine off. Never open the radiator cap or pour cold water into a hot engine. Have the cooling system pressure-tested and the oil checked for coolant before driving again.
Engine stalls or shuts off while driving
- What you'll notice
- The engine cuts out at speed or when stopping, sometimes over and over, and may not restart right away.
- Why it happens
- Owners linked stalling to the failing camshaft sensor, fuel pump trouble, wiring faults and timing belt failure. Some problems came back after repairs.
- What to do
- If it stalls, turn on the hazards and steer to safety; the steering and brakes will feel heavier. Have it scanned for codes and checked for the recall sensor, fuel pressure and timing belt condition.
Automatic transmission slips, won't shift or fails
- What you'll notice
- The transmission slips, won't shift for several minutes, surges when shifting or fails completely. One owner's failed before 50,000 miles.
- Why it happens
- Owners reported worn transmissions and failed shift solenoids, which are the electric valves that control shifting.
- What to do
- Check the fluid level and condition. If it slips or won't shift, avoid hard driving and have a shop scan for transmission codes. A solenoid is far cheaper than a rebuild.
Brake pedal goes soft or sinks to the floor
- What you'll notice
- The pedal feels soft or nearly reaches the floor, and the car takes longer to stop. One owner lost control and hit a median.
- Why it happens
- The reports don't name one cause. A leak, air in the lines or a failing master cylinder are the usual reasons for a sinking pedal.
- What to do
- Don't drive if the pedal goes low. Check the brake fluid level and have the whole system inspected for leaks before driving again.
ABS light on or front wheels lock when braking
- What you'll notice
- The ABS light comes on, and the front wheels lock up or the brakes grab hard. Some owners reported crashes.
- Why it happens
- Owners reported ABS problems and worn ABS wheel speed sensors. When the ABS is faulty, the wheels can lock in a hard stop.
- What to do
- Brake gently and leave extra distance. Have the ABS codes read; a wheel speed sensor or its wiring is a common fix.
Brake lights don't come on
- What you'll notice
- The brake lights don't light when you press the pedal. Some owners also couldn't shift out of Park.
- Why it happens
- A failing brake light switch at the pedal cuts the brake lights and the signal that releases the shift lock.
- What to do
- Have someone check your brake lights. If they're out, get the switch replaced soon so drivers behind you can see you stopping.
Headlights cut out or headlight housing overheats
- What you'll notice
- The headlights go out at random while driving, sometimes along with power accessories and the horn, or a headlight assembly overheats and cracks.
- Why it happens
- Owners reported electrical faults at the headlights and overheated headlight assemblies.
- What to do
- Pull over safely if the lights go out. Have the headlight connectors, switch and wiring checked for heat damage.
Check engine light stays on
- What you'll notice
- The check engine light comes on and stays on or flickers, sometimes with slow acceleration. Some cars failed state inspection.
- Why it happens
- Most owners traced the light to a failing camshaft position sensor. Others had loose gas caps or other sensor faults.
- What to do
- Have the codes read. If it's the camshaft sensor, check whether the recall was done. A flashing light means a misfire, so have it checked right away.
Brakes wear quickly and rotors warp
- What you'll notice
- Squealing or grinding, a shaking pedal or steering wheel when stopping, and pads and rotors that need replacing often. One owner needed four brake jobs in a year.
- Why it happens
- Owners reported early pad wear and warped or rusted rotors that couldn't be resurfaced.
- What to do
- Have the pads, rotors and calipers inspected. Replacing worn rotors instead of resurfacing them, and checking for a sticking caliper, usually helps.
Airbag warning light stays on
- What you'll notice
- The airbag light stays on all the time.
- Why it happens
- The airbag system has stored a fault. One dealer said the airbag control module needed replacing; others couldn't find the cause.
- What to do
- Assume the airbags may not work until it's fixed. Have a shop with an airbag-capable scan tool read the codes.
Shifter sticks in Park or shift button breaks
- What you'll notice
- The shifter won't come out of Park, won't go into gear unless you hold the lock button, or the shift button breaks off.
- Why it happens
- Owners reported broken shift lever buttons and sticking shift linkage. A bad brake light switch can also keep the shifter locked in Park.
- What to do
- Check that the brake lights work, since that often points to the switch. Have the shift lever and its lock checked and repaired.
Key sticks in the ignition
- What you'll notice
- The key won't turn to the lock position or won't come out, and in some cases the key gets hot.
- Why it happens
- Owners reported sticking ignition lock cylinders and switches.
- What to do
- Don't force the key. Have the ignition lock cylinder and switch checked, and check the shift lock, since the key can't come out unless the car is fully in Park.
Exhaust or fuel smell inside the car
- What you'll notice
- You smell fuel or exhaust inside the cabin, especially through the air vents, or hear a metal rattle from the muffler.
- Why it happens
- Owners reported fumes in the cabin and rusted mufflers. Exhaust leaks can let carbon monoxide into the car.
- What to do
- Open the windows and get it checked soon. Have the exhaust system and fuel lines inspected for leaks. Headaches or drowsiness while driving are a sign to stop driving the car.
Car pulls to one side or steering rack fails
- What you'll notice
- The car pulls left or right at any speed, or the steering feels loose or noisy.
- Why it happens
- Owners reported a failed steering rack, worn suspension parts and alignment problems.
- What to do
- Have the steering rack, tie rods and front suspension inspected, then get an alignment.
Hard starting or no-start
- What you'll notice
- The engine needs many tries to start, cranks but won't start, or keeps blowing fuses.
- Why it happens
- Owners found blown engine computer fuses, a smoking camshaft sensor that damaged the wiring, and weak electrical connections or grounds.
- What to do
- Check the battery and fuses first. Have a shop check for spark and fuel and look over the cam and crank sensor wiring.
Passenger-side A-pillar padding added (recall)
- What you'll notice
- No symptom. The front passenger could suffer worse head injuries by hitting the pillar beside the windshield in a crash.
- Why it happens
- The cars didn't meet the federal head-impact standard at the passenger-side windshield pillar. Recall 01V-180 adds padding to the pillar.
- What to do
- Ask the dealer to check the recall status using your VIN. If it isn't done, ask a shop whether the padding can still be installed.
Seat belts won't retract or lock up
- What you'll notice
- A seat belt locks while retracting or won't pull out or wind back in.
- Why it happens
- Owners reported sticking seat belt retractors.
- What to do
- A belt that doesn't work properly may not protect you in a crash. Have the retractor checked and replaced if needed.
Power windows stop working
- What you'll notice
- A power window won't move, or one goes up by itself and then won't move.
- Why it happens
- Owners reported failed window motors and switches.
- What to do
- Have the switch and motor tested. Repair it before bad weather if the window is stuck down.
Dashboard pad warps or separates
- What you'll notice
- The dash top lifts or separates near the windshield, and air from the vents blows in the driver's face.
- Why it happens
- Owners reported dashboard padding coming loose and warping.
- What to do
- This is mostly cosmetic, but have it secured if it blocks the defroster or your view.
Repair prices for your Daewoo Leganza
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace timing belt, tensioner, idlers and water pump
- Replace head gasket
- Diagnose stalling and replace failed sensor or fuel part
- Read codes and replace faulty sensor
- Replace shift solenoid or rebuild automatic transmission
- Replace front brake pads and rotors
- Repair brake leak or replace master cylinder and bleed brakes
- Replace ABS wheel speed sensor
- Replace brake light switch
- Repair shift lever button or shift lock
- Repair headlight wiring or replace headlight assembly
- Repair exhaust leak or replace muffler
- Replace steering rack and align
- Diagnose no-start and repair sensor wiring
- Replace power window motor or regulator
- Replace seat belt retractor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace camshaft position sensor and add fuseNo charge if your vehicle is included
- Install A-pillar paddingNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.