Your 2002 Daewoo Nubiraproblems, repair costs and recalls
What we've documented about the 2002 Daewoo Nubira: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2002 Daewoo Nubira
9 documented issues apply to 2002, most serious first.
Camshaft position sensor can melt and start a fire (recall)
- What you'll notice
- A burning plastic smell or smoke from under the hood, often with the check engine light on. Some owners also had rough running, stalling or a no-start.
- Why it happens
- The camshaft position sensor, which tells the engine computer where the camshaft is, can overheat and melt. The heat can spread to the cam cover and the sensor wiring and could start a fire. Recalls 04V-357 and 04V-394 replace the sensor and add a fuse. Several owners reported fires.
- What to do
- If you smell burning or see smoke, pull over, turn the engine off and get everyone away from the car. Daewoo's US dealers closed soon after the recall, so many cars never got the fix. Call NHTSA's recall line with your VIN, and ask a shop to check the sensor, fuse and wiring.
Daewoo's US dealers closed, so a shop may charge for this. Ask for a written quote.
Timing belt breaks and bends valves
- What you'll notice
- The engine suddenly quits while driving and then cranks but won't start. Some owners heard a slap or rattle first.
- Why it happens
- The 2.0L engine uses a rubber timing belt, and it is an engine where the valves hit the pistons if the belt snaps. Owners reported belts breaking between about 45,000 and 71,000 miles, often leading to bent valves. A leaking water pump or a worn tensioner can ruin the belt early.
- What to do
- If you have no record of it, have the timing belt, tensioner, idler pulleys and water pump replaced now. Daewoo owners suggest doing it about every 55,000 miles. If the belt has already broken, don't keep cranking. Have the car towed and ask for a compression or leak-down test before deciding on repairs.
Front brake hoses can crack and leak (recall)
- What you'll notice
- Brake fluid on the inside of a front wheel, a falling fluid level, or a brake pedal that feels soft or sinks.
- Why it happens
- Some front brake hoses did not meet the federal brake hose standard. The outer rubber layer can crack, and the hose can burst and leak fluid, cutting braking power. Recall 02V-257 installs redesigned hoses.
- What to do
- If the pedal feels soft or you see a leak, don't drive the car. Ask the manufacturer's service representative to confirm by VIN whether the recall repair was completed. If not, have a shop fit new front brake hoses and bleed the brakes.
If the recall can't be done, a shop will charge per brake hose; ask for a written quote.
Brake pedal sinks toward the floor
- What you'll notice
- The brake pedal feels spongy or slowly sinks to the floor during a stop, and the car takes longer to stop. A few owners reported crashes.
- Why it happens
- Owners traced this to leaking brake hoses, corroded brake lines and failing master cylinders. In some cases, a master cylinder was replaced and the problem came back.
- What to do
- Treat this as urgent. Don't drive if the pedal goes low. Have the whole brake system checked, including the hoses, steel lines, calipers and master cylinder, and have any leak fixed before driving again.
Automatic transmission fails or won't move
- What you'll notice
- The car won't move in Drive even though the engine runs, gets stuck in one gear, or downshifts suddenly at speed and won't upshift.
- Why it happens
- Owners reported automatic transmission failures from about 50,000 to 75,000 miles. The cause isn't documented in detail, but worn internal parts and low or old fluid are usual reasons.
- What to do
- Check the fluid level and condition. If it is low, dark or smells burnt, or the car won't move, don't keep driving. Have a transmission shop check for codes and fluid problems before agreeing to a rebuild.
Front lower control arm bushings wear out
- What you'll notice
- The car pulls or darts to one side, jerks sideways when you get on or off the gas, shakes at highway speed, or eats the front tires. Some owners heard a squeak, creak or clunk from the front end.
- Why it happens
- The rubber bushings in the front lower control arms wear out early on this car, sometimes before 20,000 to 30,000 miles. Loose arms let the wheels shift under power and braking, which also throws off the alignment.
- What to do
- Have the front suspension inspected for torn or loose bushings and worn ball joints. Replacing the control arms or bushings, then getting an alignment, usually cures the pulling and tire wear.
Check engine light stays on
- What you'll notice
- The check engine light comes on and stays on, or flickers on and off. Some cars ran rough, lost power or failed emissions inspection.
- Why it happens
- Many owners found the camshaft position sensor at fault. Others had a misfire code, an oxygen sensor or a knock sensor. Some lights stayed on even after the recall sensor was fitted.
- What to do
- Have the trouble codes read. If the code points to the camshaft sensor, also check whether the recall work was done. Don't ignore a flashing light, which means a misfire that can damage the catalytic converter.
Brake rotors warp and pads wear fast
- What you'll notice
- Grinding or squealing brakes, a shaking steering wheel or pedal when stopping, and pads and rotors that need replacing very often.
- Why it happens
- Many owners had to resurface or replace front rotors and pads again and again, sometimes every few thousand miles. Worn control arm bushings can add to the shimmy.
- What to do
- Have the brakes inspected for thin pads, warped rotors and sticking calipers. Good-quality pads and rotors, plus checking the front suspension bushings, usually help.
Engine rattle
- What you'll notice
- A rattling noise from the engine.
- Why it happens
- One owner reported a rattle. On this engine, a worn timing belt tensioner or idler pulley is a common source, as are loose heat shields.
- What to do
- Have a shop find where the noise comes from. If it's the timing belt area, replace the belt and pulleys before they fail.
Repair prices for your 2002 Daewoo Nubira
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace timing belt, tensioner, idlers and water pump
- Replace front lower control arms and align
- Repair brake leak or replace master cylinder and bleed brakes
- Read codes and replace faulty sensor
- Replace automatic transmission with a used or rebuilt unit
- Replace front brake pads and rotors
- Diagnose engine noise and replace tensioner or idler
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace camshaft position sensor and add fuseNo charge if your vehicle is included
- Replace front brake hosesNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…