Your 2008 Ford Explorer Sport Tracproblems, repair costs and recalls
What we've documented about the 2008 Ford Explorer Sport Trac: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Ford Explorer Sport Trac
9 documented issues apply to 2008, most serious first.
Automatic transmission fails on 2007-2010 trucks
- What you'll notice
- Slipping, flaring revs, a sudden loss of drive, or a shift into the wrong gear while accelerating. Some trucks lose forward and reverse completely and have to be towed.
- Why it happens
- Owners of second-generation trucks with both the V6 and the V8 report complete transmission failures, often between 75,000 and 110,000 miles. Reported causes include a failed torque converter that sends metal through the unit, worn shift servo bores in the case and damaged shift solenoids.
- What to do
- If the truck slips or loses a gear, stop towing and get the transmission scanned and the fluid checked right away. Ask the shop for a written diagnosis before agreeing to a rebuild, and ask Ford whether any extended coverage applies to your VIN.
Timing chain rattle or failure
- What you'll notice
- A rattle or chatter from the engine, loudest for a few seconds after a cold start, that gets worse over time. It may come with a check engine light. If a chain or guide breaks, the engine can stop running.
- Why it happens
- The 4.0L overhead-cam V6 uses several timing chains with plastic guides and tensioners. The guides crack and the tensioners wear, so the chains slap. A broken guide can punch through the valve cover, and a broken chain can damage the engine.
- What to do
- Don't ignore a new rattle. Have a shop listen to it and check for cam timing codes. Replacing the chains, guides and tensioners before something breaks costs far less than a new engine.
Transmission cooler line bolt can loosen (recall)
- What you'll notice
- Red transmission fluid dripping under the truck, or a burning smell or smoke from underneath.
- Why it happens
- Under recall 07V-453, the bolt holding a transmission cooler line may not have been tightened properly. Leaking fluid can hit the catalytic converter and start a fire.
- What to do
- If you see smoke or smell burning fluid, pull over and shut off the engine. Check your VIN for open recalls and have it fixed free at a Ford dealer.
Free at a Ford dealer if still open; ask the dealer to check your VIN for open recalls.
Harsh, delayed or slamming shifts
- What you'll notice
- The truck jerks or bangs into gear at low speed, slams into reverse, pauses a few seconds before engaging, or shudders when pulling away.
- Why it happens
- Owners trace this to transmission computer programming, the solenoid pack, or chafed transmission wiring. Ford issued a service bulletin (8-4-16 is cited by owners) that reprograms the computer for this complaint.
- What to do
- Ask a Ford dealer to check for transmission software updates and service bulletins for your VIN before replacing parts. If shifts keep getting worse or the truck slips, have it diagnosed promptly.
No-crank or stalling from chafed engine computer wiring
- What you'll notice
- The engine won't crank, stalls, runs poorly, or the check engine light comes on, sometimes on and off.
- Why it happens
- Ford service bulletins for these trucks describe the engine wiring harness rubbing against the engine computer (PCM) mounting bracket, and other no-crank and drivability faults tied to the engine and transmission computers.
- What to do
- Have a shop read the codes and inspect the harness at the PCM bracket for rubbed-through wires. Mention the Ford bulletins so they look there first.
Spark plugs break off during removal
- What you'll notice
- During a tune-up, one or more spark plugs snap and leave part of the plug stuck in the cylinder head. The truck may have been in for a misfire.
- Why it happens
- The 3-valve V8 used a two-piece spark plug whose lower shell can seize in the aluminum head with carbon. Ford bulletin 08-7-6 covers 2007-2008 Sport Trac V8s built before November 30, 2007 and gives a special cold-engine removal procedure.
- What to do
- Have plugs changed by a shop that knows Ford's procedure and has the extraction tools. Never remove them with the engine warm. Ask for a quote that covers broken-plug extraction before work starts.
Plastic thermostat housing cracks and leaks
- What you'll notice
- Coolant seeping or dripping near the top front of the engine, a low coolant level, or a coolant smell after driving.
- Why it happens
- The thermostat housing on the V6 is plastic and can crack. Owners have replaced it with an aluminum aftermarket housing.
- What to do
- Top up with the correct coolant and have the housing replaced soon. Watch the temperature gauge; if it climbs, pull over and let the engine cool.
Hard starting, rough idle or idle dips when slowing
- What you'll notice
- Long cranking before it starts, rough running, or the idle dropping very low (below about 600 rpm) as you coast to a stop.
- Why it happens
- Ford service bulletin 08-9-5 covers 4.0L and 4.6L trucks built on or before April 2, 2008 for this complaint, which is fixed with updated engine computer software.
- What to do
- Ask a Ford dealer to check whether bulletin 08-9-5 applies to your truck and whether the software update has been done.
Oil seepage at the rear axle shaft seals
- What you'll notice
- Oily residue near the rear wheels or on the inside of the rear tires.
- Why it happens
- Ford service bulletin 08-19-3 notes that oil can separate from the axle shaft cartridge seal and is often mistaken for an axle gear oil leak.
- What to do
- Have the shop check the bulletin before replacing axle parts. Check that the rear axle oil level is correct; a true leak onto the brakes needs prompt repair.
Repair prices for your 2008 Ford Explorer Sport Trac
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transmission
- Replace timing chains, guides and tensioners
- Reprogram transmission computer; replace solenoid pack if needed
- Repair chafed engine harness at PCM bracket
- Update engine computer software
- Replace spark plugs with broken-plug extraction
- Replace thermostat housing and thermostat
- Replace rear axle shaft seals
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Retighten or replace cooler line boltNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…