Your 2019 Ford Fiestaproblems, repair costs and recalls
What we've documented about the 2019 Ford Fiesta: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2019 Ford Fiesta
13 documented issues apply to 2019, most serious first.
PowerShift automatic shudders and jerks from a stop
- What you'll notice
- The car shudders, jerks or hesitates when pulling away or creeping in traffic, sometimes followed by a hard shift you feel through the steering wheel. It often gets worse over time.
- Why it happens
- The PowerShift automatic is really two computer-controlled dry clutches, like a manual gearbox that shifts itself. The clutches wear and grab unevenly, which causes the shudder. This was the most-reported Fiesta problem and led to a class action and Ford warranty extensions.
- What to do
- Have a Ford dealer check the clutches, seals and software. Ask with your VIN whether any extended clutch coverage still applies; most of it has run out by now, but some cars may still qualify.
Transmission control module failure
- What you'll notice
- A wrench or transmission warning light, the car refusing to start or go into gear, or the car suddenly dropping into neutral and losing power while driving.
- Why it happens
- The computer that runs the PowerShift clutches sits on the transmission and can fail from heat and moisture. Ford issued several reprogramming bulletins and extended coverage on this module to 10 years or 150,000 miles on many cars.
- What to do
- Losing drive in traffic is dangerous, so get it checked promptly. Have a dealer read the transmission codes and check your VIN for the extended module coverage.
Coolant loss and head gasket failure (ST)
- What you'll notice
- The coolant level keeps dropping with no puddle, the engine runs hot, or there is white smoke from the exhaust.
- Why it happens
- Coolant loss that ends in head gasket failure is one of the best-known Fiesta ST problems, more common on earlier cars. Ford later used an updated head gasket.
- What to do
- Top up with the correct coolant and have a pressure test done soon. Fixing a small leak early is far cheaper than a head gasket job.
Front brakes may drag and overheat (recall)
- What you'll notice
- Brakes that feel like they are sticking, a hot or burning smell from the wheels, or the car pulling.
- Why it happens
- Some front calipers were assembled with the wrong fluid, which made the seals swell and the brakes drag. Ford recalled the cars to flush the brake fluid and replace the front calipers and hoses.
- What to do
- Check your VIN for the recall. Dragging brakes can overheat and lose stopping power.
Coolant leak from thermostat housing or water pump
- What you'll notice
- A sweet smell, drips or crusty residue on the passenger side of the engine, a dropping coolant level, or the temperature gauge rising.
- Why it happens
- The plastic thermostat housing and the water pump on the 1.6L engine are common leak points as they age. The water pump is one of the most-replaced parts on these cars.
- What to do
- Top up the coolant and have the leak found before the engine overheats. Running low on coolant can damage the head gasket.
Low boost and lack of power (ST)
- What you'll notice
- The ST feels flat, boost is low or comes and goes, and the check engine light may show boost codes.
- Why it happens
- Ford issued a bulletin for lack of power with boost codes on this engine. The boost control solenoid is a common replacement part.
- What to do
- Have the codes read and the boost control parts and hoses checked for leaks.
Manual clutch slipping or hard to select gears (ST)
- What you'll notice
- The engine revs rise without the car speeding up, the clutch pedal feels heavy, or it is hard to get into reverse, first or second.
- Why it happens
- Hard driving wears the clutch, and worn synchronizers make some gears hard to engage.
- What to do
- Have the clutch and gearbox checked. A slipping clutch only gets worse and can overheat the flywheel.
Backup camera shows blank or distorted image (recall)
- What you'll notice
- The rearview camera screen is blank, flickers or shows a distorted picture when in reverse.
- Why it happens
- The camera can fail intermittently. Ford has recalled 2019 cars more than once to inspect and replace the camera.
- What to do
- Check your VIN for open camera recalls and look over your shoulder when backing up until it is fixed.
Turbo wastegate rattle on cold start (ST)
- What you'll notice
- A rattle from the turbo when the engine is cold, sometimes with a small loss of power.
- Why it happens
- The wastegate linkage on the ST turbo can wear and rattle.
- What to do
- Have the turbo linkage inspected. A worn actuator or linkage is usually the fix.
Carbon buildup causes rough idle (ST)
- What you'll notice
- Rough idle, slower throttle response and occasional misfires as mileage climbs.
- Why it happens
- This engine sprays fuel straight into the cylinders, so fuel never washes the intake valves and carbon slowly builds up on them.
- What to do
- If the engine runs rough, have a shop check for carbon buildup. Cleaning the valves (often by walnut-shell blasting) usually restores smooth running.
Hard start after refueling
- What you'll notice
- The engine cranks a long time or stalls right after filling the tank, sometimes with a check engine light for the evaporative system.
- Why it happens
- The canister purge valve can stick open and let fuel vapor flood the engine just after a fill-up.
- What to do
- Have the evaporative codes read. Replacing the purge valve is usually a simple fix.
Radio or SYNC freezes or stops working
- What you'll notice
- The radio goes silent, the screen freezes, or Bluetooth will not connect.
- Why it happens
- The audio module can fail, often blamed on heat and cold, and early SYNC software is known to freeze.
- What to do
- Try disconnecting the battery for several minutes and check the radio fuses. Ask the dealer about SYNC software updates before buying a new unit.
Clunking over bumps from worn shocks or struts
- What you'll notice
- Knocking or clunking over bumps, a bouncy ride, or uneven tire wear.
- Why it happens
- Shock absorbers, struts and rear axle bushings are among the most-replaced parts on the Fiesta as the cars age.
- What to do
- Have the suspension inspected. Replace shocks or struts in pairs.
Repair prices for your 2019 Ford Fiesta
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace dual clutch assembly and input shaft seals, then relearn
- Replace and program transmission control module
- Replace head gasket and resurface cylinder head
- Replace thermostat housing or water pump and refill coolant
- Replace boost control solenoid and check boost hoses
- Replace turbo wastegate actuator
- Walnut-blast clean intake valves
- Replace clutch kit
- Replace canister purge valve
- Update SYNC software or replace audio module
- Replace front struts or rear shocks (pair)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Flush brake fluid, replace front calipers and hosesNo charge if your vehicle is included
- Inspect and replace rearview cameraNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…