Your 2006 Ford Freestarproblems, repair costs and recalls
What we've documented about the 2006 Ford Freestar: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Ford Freestar
18 documented issues apply to 2006, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Shifts that slip, flare or bang, a delay before the van moves, no reverse, or a sudden loss of drive with the engine still running. Failures often come with little warning.
- Why it happens
- The four-speed automatic in the Freestar wears out internally, and failure is by far the most-reported problem on this van. Most owners report it somewhere around 90,000 to 120,000 miles.
- What to do
- If shifting changes at all, have the fluid level and condition checked and the codes read right away. Slipping or no-drive usually means a rebuilt or replacement transmission, so get a written quote and compare it with the value of the van.
Third-row seat anchor can rust loose (recall)
- What you'll notice
- The third-row seat may not latch firmly, may rattle, or may shift. In a rear crash an unlatched seat raises injury risk.
- Why it happens
- The sheet metal under the floor that holds the third-row seat latch strikers can corrode, especially in states that use road salt.
- What to do
- Check for open recalls with your VIN and have a Ford dealer inspect and repair the seat mounting area for free. Avoid seating passengers in the third row until it is checked.
Engine computer damaged by water leaks
- What you'll notice
- Stalling or rough running, flickering dash or interior lights, battery light on, the radio or A/C cutting in and out, or the transmission acting up, often after rain or a car wash.
- Why it happens
- Water can get past the cowl and windshield area seals and reach the powertrain control module (the main engine and transmission computer), which then fails or acts erratically.
- What to do
- Have a shop check for water at the computer and its connectors and fix the leak path and water shield first. A damaged computer usually has to be replaced and programmed to the van.
Rocker panel, door and subframe rust
- What you'll notice
- Bubbling paint or holes along the rocker panels, door bottoms and wheel wells, a rusted liftgate latch, or heavy scale on the subframe underneath.
- Why it happens
- The Freestar is built on the old Windstar platform and rusts in the same places, especially where roads are salted.
- What to do
- Have the underbody and subframe inspected on a lift, especially before buying one. Cosmetic rust can be patched, but a badly rusted subframe is a safety problem.
Misfire from a failing ignition coil pack
- What you'll notice
- The engine shakes, runs rough or lacks power, and the check engine light may flash.
- Why it happens
- The coil pack that feeds the spark plug wires fails with age and heat, often along with worn plugs and wires. An ongoing misfire can also upset shifting.
- What to do
- Have the misfire codes read and fix the misfire promptly. Replacing the coil pack, plugs and wires together is common.
Misfire from clogged EGR ports in the intake
- What you'll notice
- Rough idle or misfire codes on higher-mileage vans, sometimes on one or two cylinders only.
- Why it happens
- Small passages in the intake manifold that carry exhaust gas (EGR) to each cylinder can clog with carbon sludge, so cylinders get uneven mixtures.
- What to do
- Ask the shop to check the EGR passages before replacing coils or injectors. Cleaning them is often the fix.
Squealing camshaft synchronizer
- What you'll notice
- A screech or squeal from the engine that sounds like a bad belt, sometimes with stalling at stops.
- Why it happens
- The camshaft synchronizer (the unit that holds the cam sensor) has a bearing that wears out. If it seizes it can damage the engine.
- What to do
- Do not ignore a new screeching noise. Have the synchronizer checked and replaced if it is noisy or has play.
Front wheel bearing whine or hum
- What you'll notice
- A whistle, whine or hum from the front that changes with speed and may get louder in turns.
- Why it happens
- Front hub bearings wear out. Ford issued bulletins about whistling and noise from the front hub bearings on these vans.
- What to do
- Have the wheel bearings checked for play and noise. Replace the worn hub assembly before it gets loose.
Power liftgate can drop suddenly (recall)
- What you'll notice
- The power liftgate drifts down or falls when open.
- Why it happens
- A strut on the power liftgate could fail on some 2005-2006 vans, so the gate would not stay up.
- What to do
- Check your VIN for open recalls and have the free repair done. Until then, do not stand under an open liftgate.
ABS and traction control lights on
- What you'll notice
- The ABS, traction control and parking brake lights flicker or stay on, and traction control may stop working.
- Why it happens
- Ford issued several bulletins for these lights, including a pressure sensor fault in the ABS system and module calibration faults. Owners also report failed ABS/traction control modules.
- What to do
- Have the ABS codes read. Normal braking still works, but ABS and traction control may not until the fault is fixed.
Rear brakes wear fast or calipers seize
- What you'll notice
- Rear pads and rotors wearing out early, grinding, or a hot, dragging rear wheel.
- Why it happens
- Ford issued bulletins for fast rear brake lining wear on the Freestar, and owners report rear calipers that freeze up.
- What to do
- Have the rear brakes checked at every oil change. Clean and lube the caliper slides at each brake job and replace a seized caliper.
Alternator stops charging
- What you'll notice
- Battery light on, dim lights, or a dead battery that keeps coming back.
- Why it happens
- Owners report alternator failures, sometimes more than once.
- What to do
- Have the battery and charging system tested before replacing parts.
A/C compressor fails
- What you'll notice
- The A/C blows warm, the compressor is noisy, or the A/C belt breaks.
- Why it happens
- Owners report replaced A/C compressors, sometimes with a broken belt that also left the van unable to run.
- What to do
- If the compressor is noisy or the belt breaks, have it checked before driving far. A seized compressor can take out the belt.
Power steering leak or hard steering
- What you'll notice
- Power steering fluid leaks, whining from the pump, or steering that feels heavy or slow to return to center.
- Why it happens
- Owners report leaking power steering pumps, lines and racks on these vans.
- What to do
- Check the fluid level and look for leaks. Have the leak source found before the pump runs dry.
Broken outer CV joint
- What you'll notice
- Clicking when turning, a clunk from a front wheel, or a vibration on acceleration.
- Why it happens
- Ford issued a bulletin on broken outer CV joints on Freestars built before May 2005. Owners also report clunks from the driveline.
- What to do
- Have the front axles and boots checked. A broken CV joint can leave the van unable to move.
Power sliding door or liftgate will not open
- What you'll notice
- The power sliding doors or power liftgate stop working from the overhead buttons or the key fob.
- Why it happens
- Ford published bulletins on power sliding door and liftgate faults, including a module fault code that stops them responding.
- What to do
- Have the door system codes read. Sometimes a reset or reprogram fixes it; otherwise a motor, cable or latch needs replacing.
Rear defroster and antenna stop working
- What you'll notice
- Rear window defroster lines do not clear, and radio reception may be weak.
- Why it happens
- The connector tab on the rear glass can come loose. Ford published repair bulletins for it.
- What to do
- A shop can re-attach the tab with a repair kit. Replacing the glass is rarely needed.
Front power windows stop working
- What you'll notice
- A front window will not go up or down.
- Why it happens
- Ford issued a bulletin for front window motors that stop working on these vans.
- What to do
- Have the switch and motor tested. Usually the motor or regulator gets replaced.
Repair prices for your 2006 Ford Freestar
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace transmission with rebuilt or used unit
- Replace and program powertrain control module; repair water leak
- Cut out and weld in rocker panel sections, refinish
- Replace ignition coil pack, spark plugs and wires
- Clean intake EGR passages (upper intake removed)
- Replace camshaft synchronizer
- Replace front wheel hub and bearing (one side)
- Replace ABS/traction control module
- Replace rear calipers, pads and rotors
- Diagnose and repair power sliding door motor, cable or latch
- Replace alternator
- Replace A/C compressor, drier and recharge
- Replace power steering pump
- Replace front axle shaft (one side)
- Repair rear defroster terminal tab
- Replace front window motor/regulator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free recall repair at a Ford dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…