Your 2013 Honda Crosstourproblems, repair costs and recalls
What we've documented about the 2013 Honda Crosstour: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2013 Honda Crosstour
10 documented issues apply to 2013, most serious first.
Steering suddenly turns heavy (power steering unit failure)
- What you'll notice
- The power steering warning light comes on and the steering becomes very hard to turn, sometimes without warning.
- Why it happens
- The electric power steering control unit can fail. Honda extended coverage on this part for 2013-2014 Crosstours to 15 years with unlimited miles.
- What to do
- Treat it as urgent and have it towed or driven carefully to a Honda dealer. Ask about the extended EPS warranty; it may be free.
Passenger airbag inflator can rupture (recall)
- What you'll notice
- Nothing you notice day to day. The danger is in a crash.
- Why it happens
- The Takata passenger airbag inflator can degrade after years of heat and humidity and burst when it deploys.
- What to do
- Check the VIN for recalls 16V-346, 17V-030, 18V-042, 18V-661 and 19V-502 and get the free replacement right away.
Free at a Honda dealer under recall 16V-346 / 17V-030 / 18V-042 / 18V-661 / 19V-502.
Replacement passenger airbag may be installed wrong (recall)
- What you'll notice
- No symptoms. The airbag may not open correctly in a crash.
- Why it happens
- Some passenger airbag modules replaced during earlier recall work may not have been installed correctly.
- What to do
- Check the VIN for recalls 17V-545, 18V-268 and 19V-378 so the dealer can inspect the installation.
Free at a Honda dealer under recall 17V-545 / 18V-268 / 19V-378.
Rough running or rattle at steady cruise (VCM)
- What you'll notice
- A rattle, shake or rough feel when cruising at a steady speed, sometimes with a blinking check engine light.
- Why it happens
- Honda issued a bulletin for rough running and rattles while the V6 switches cylinders on and off at cruise.
- What to do
- Have the codes read and ask a Honda dealer about the bulletin. Spark plugs, engine mounts and software are the usual areas checked.
Torque converter judder at 20–60 mph
- What you'll notice
- A shudder or rumbling while cruising gently between about 20 and 60 mph, as if driving on a rough road.
- Why it happens
- Honda issued bulletins for the torque converter lock-up clutch judder on these years.
- What to do
- Ask the dealer to check for the bulletin. A software update and fresh fluid are the usual first steps.
Grinding rattle on cold start (VTC actuator)
- What you'll notice
- A loud grinding or rattle for a second or two right after starting a cold engine.
- Why it happens
- The variable valve timing (VTC) actuator on the camshaft can wear and rattle before oil pressure builds. Honda issued a bulletin to replace it.
- What to do
- Have it checked, especially if the noise gets longer. Replacing the actuator usually ends the noise.
Starter grinds or won't crank
- What you'll notice
- A grinding or spinning noise when starting, or the engine not cranking at all.
- Why it happens
- Honda investigated no-starts and grinding on these V6 models and issued a bulletin saying the starter's gear clearance was not ideal.
- What to do
- Have the starter checked; ask a Honda dealer about the starter bulletin.
Front axle clicking or failing
- What you'll notice
- Clicking when turning, vibration when accelerating, or grease spattered inside the wheel.
- Why it happens
- Owners of the 2013 report front axles failing repeatedly.
- What to do
- Have the axles and boots inspected. A torn boot caught early can sometimes be replaced alone.
Touchscreen not responding or freezing
- What you'll notice
- The lower touchscreen ignores taps, responds in the wrong spot, or freezes.
- Why it happens
- Honda found debris getting into the gap around the screen bezel can cause it to misread touches.
- What to do
- Ask a Honda dealer about the touchscreen bulletin; cleaning the bezel gap often fixes it.
Rubbing or groaning from the steering wheel
- What you'll notice
- A rubbing or groaning sound from the steering wheel when turning it.
- Why it happens
- Honda issued a bulletin for the driver airbag module rubbing inside the steering wheel.
- What to do
- Ask a Honda dealer about the bulletin; the fix is a quick adjustment.
Repair prices for your 2013 Honda Crosstour
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose VCM, replace spark plugs
- Transmission software update and fluid change
- Replace power steering control unit or rack
- Replace VTC actuator
- Replace starter
- Clean screen bezel or replace display
- Adjust or shim driver airbag module
- Replace front axle (CV shaft)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…