Your 2007 Honda Elementproblems, repair costs and recalls
What we've documented about the 2007 Honda Element: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Honda Element
15 documented issues apply to 2007, most serious first.
Driver air bag inflator can rupture (Takata recall)
- What you'll notice
- Usually no warning. The danger only shows up in a crash, when the driver air bag can burst with too much force.
- Why it happens
- The Takata inflator in the driver air bag uses a propellant that breaks down after years of heat and humidity. In a crash it can rupture and throw metal pieces. Every Element model year is covered, and some replacement inflators from earlier repairs were recalled again.
- What to do
- Check your VIN now and have the inflator replaced for free. An Element that never had the repair is at high risk.
Free inflator replacement under recalls 15V-320, 19V-182 and 19V-499.
Passenger air bag inflator can rupture (Takata recall)
- What you'll notice
- No warning before a crash. In a collision the front passenger air bag can burst and spray metal fragments.
- Why it happens
- The passenger-side Takata inflator has the same propellant breakdown. Several recalls cover Elements depending on year and the state where the car was registered.
- What to do
- Check your VIN and get the free replacement. Until then, avoid carrying a front passenger.
Free inflator replacement under recalls 14V-353, 16V-344, 17V-029, 18V-041, 18V-662 and 19V-501.
Automatic transmission bearing can break and cause stalling or rollaway (recall)
- What you'll notice
- The engine stalls, the transmission makes grinding noises, or the car can roll after being put in Park.
- Why it happens
- A bearing race on the automatic transmission secondary shaft can break from hard downshifts. Honda recalled these Elements for a software update that changes shift control to protect the bearing.
- What to do
- Check your VIN and make sure the software update was done. Always set the parking brake when parked.
Free transmission software update under recall 11V-395. The update does not repair a bearing that is already damaged.
Soft or sinking brake pedal from air in the stability control unit (recall)
- What you'll notice
- The brake pedal feels soft or sinks farther toward the floor than normal.
- Why it happens
- Air can get into the stability control (VSA) brake modulator over time. Honda recalled these Elements to bleed the air out and seal the unit.
- What to do
- Check your VIN. If the pedal feels soft, have the brakes checked before driving more.
Free brake bleed and modulator sealing under recall 10V-098.
Trailer turn signals only work with the brakes on (recall)
- What you'll notice
- When towing, the trailer turn signals do not flash unless you press the brake pedal.
- Why it happens
- The Honda trailer hitch wiring harness had the turn signal and brake light wires swapped. Honda recalled it.
- What to do
- If you tow with a Honda harness, check your VIN and have the wiring corrected.
Free wiring correction under recall 12V-436.
Loud rattle for a few seconds on cold start (VTC actuator)
- What you'll notice
- A grinding or rattling noise for one or two seconds right after starting a cold engine, sometimes with a check engine light for cam timing.
- Why it happens
- The VTC actuator (variable cam timing gear) on the 2.4L engine can let the timing chain rattle before oil pressure builds. A worn chain tensioner can add to it. Honda revised the actuator design.
- What to do
- Have the codes read and the actuator checked. If the noise only lasts a second and there are no codes, it is not urgent, but get it diagnosed.
VTEC solenoid leaks oil or sets engine codes
- What you'll notice
- Oil seeping from the back of the engine, a check engine light, rough running, or the engine lacking power above about 2,500 rpm.
- Why it happens
- The VTEC solenoid and its gasket on the back of the cylinder head leak oil, and the solenoid or its pressure switch can fail. Some owners also report oil dilution after a major leak.
- What to do
- Have the leak traced. Replacing the gasket early is cheap; a failed solenoid needs a new assembly.
Misfires from tight valve clearances
- What you'll notice
- Check engine light with a misfire code, rough idle, or shaking under load.
- Why it happens
- The 2.4L engine has screw-type valve adjusters that need checking. If the valves tighten up over time, they do not seal fully and cause misfires.
- What to do
- Have the valve clearances checked and adjusted. Replace plugs at the same time if they are due.
Worn engine mounts cause vibration
- What you'll notice
- Strong vibration at idle or when accelerating, a clunk when shifting into gear, or a groan from the engine area.
- Why it happens
- The rubber engine and transmission mounts wear out and crack with age, so engine movement reaches the cabin.
- What to do
- Have the mounts inspected. Replace any that are cracked or collapsed.
Key will not turn or go into the ignition
- What you'll notice
- The key is hard to insert or turn, the car starts only sometimes, or the green key light flashes and the engine will not start.
- Why it happens
- The ignition lock cylinder wears and the ignition switch can fail. The 2003 model has the most complaints.
- What to do
- Do not force the key. Have the lock cylinder or ignition switch replaced; the key may need to be programmed at a dealer.
A/C compressor fails or A/C cuts in and out
- What you'll notice
- The A/C blows warm air, cools only sometimes, or the compressor makes noise.
- Why it happens
- The A/C compressor or its clutch wears out, and a failing A/C relay can make the system cut in and out.
- What to do
- Have the A/C relay and refrigerant checked first. A failed compressor needs a new compressor plus a system flush.
Rear differential groans on turns or seizes (4WD)
- What you'll notice
- A groan or shudder from the back when turning slowly, or grinding noise. Some neglected units leak and seize.
- Why it happens
- The Real Time 4WD rear differential uses Honda Dual Pump fluid that wears out. Without fluid changes, its clutches chatter and bearings wear. A slow leak can run it dry.
- What to do
- Change the rear differential fluid with Honda Dual Pump fluid every 30,000-40,000 miles, and check for leaks.
Gauge needles fall off
- What you'll notice
- The speedometer or tachometer needle drops off or points the wrong way, sometimes with a bright light from the gauges.
- Why it happens
- Owners of 2007 Elements report the gauge needles coming loose, often after a bump.
- What to do
- Have the gauge cluster repaired or replaced; a reattached needle may not read correctly.
Brakes wear out early
- What you'll notice
- Squealing or grinding brakes and pads that need replacing at low mileage.
- Why it happens
- Owners of these years report pads and rotors wearing out much sooner than expected.
- What to do
- Check pad thickness at each oil change and replace pads before they reach the metal.
Oil pressure switch leaks
- What you'll notice
- Oil drips at the back of the engine or an oil pressure light that flickers.
- Why it happens
- The oil pressure switch on the engine block wears and leaks oil.
- What to do
- Have the switch replaced; it is a cheap part. Keep the oil topped off.
Repair prices for your 2007 Honda Element
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace VTEC solenoid gasket or solenoid
- Valve clearance adjustment
- Replace one engine mount
- Replace ignition lock cylinder or switch
- Replace A/C compressor, drier and recharge
- Drain and refill rear differential
- Replace instrument cluster
- Replace brake pads and rotors (one axle)
- Replace oil pressure switch
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…