Your 2013 Honda Fitproblems, repair costs and recalls
What we've documented about the 2013 Honda Fit: problems owners and shops report, typical repair and upkeep costs, and safety recalls. No 2014 model year was sold in the US.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2013 Honda Fit
5 documented issues apply to 2013, most serious first.
Rusted driveshaft can break
- What you'll notice
- A clunk or grinding from the front wheels, then sudden loss of drive.
- Why it happens
- The protective coating on the driveshafts may have been applied poorly, so road salt can rust them until they break. Honda recalled these years.
- What to do
- Check the VIN for open recalls and have the driveshafts inspected or replaced, especially in salt-belt states.
Passenger-side driveshaft can break
- What you'll notice
- A clunk, then the car will not move under power.
- Why it happens
- Some right-side driveshafts on manual-transmission cars were not heat treated correctly and can break. Honda recalled these cars.
- What to do
- Check the VIN for open recalls and have the driveshaft replaced.
A/C stops blowing cold
- What you'll notice
- Warm air from the vents, sometimes with grinding or rattling when the A/C runs.
- Why it happens
- The A/C compressor or its clutch can fail, and some cars lose refrigerant first and need a recharge.
- What to do
- Have the A/C tested for leaks and compressor operation before simply adding refrigerant.
Ignition coil failure
- What you'll notice
- Check engine light, misfire codes, shaking at idle and hesitation when accelerating.
- Why it happens
- Ignition coil packs are the most reported repair on the Fit. When one fails, its cylinder stops firing properly. Honda issued a service bulletin on misfires for the third generation.
- What to do
- Have the misfire code read and the failed coil replaced. Do not drive long with a flashing check engine light.
Stability control may not hold the car in hard maneuvers
- What you'll notice
- Usually nothing noticeable in normal driving. The car may slide more than expected in a sudden swerve.
- Why it happens
- With certain tires, the stability control settings could allow too much yaw at large steering angles. Honda recalled these years for a software update.
- What to do
- Check the VIN for open recalls and have the update done.
Repair prices for your 2013 Honda Fit
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front driveshaft (CV axle)
- Replace A/C compressor and recharge
- Replace ignition coil
- Update stability control (VSA) software (recall)
- Replace passenger-side driveshaft (recall)
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…