Your 1999 Honda Preludeproblems, repair costs and recalls
What we've documented about the 1999 Honda Prelude: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 Honda Prelude
8 documented issues apply to 1999, most serious first.
Burning oil and blue exhaust smoke
- What you'll notice
- The oil level drops between changes, blue-gray smoke comes from the exhaust (especially after idling or on hard acceleration), and spark plugs may foul.
- Why it happens
- The high-revving VTEC engine is known for burning oil as it ages, mostly from worn piston rings and valve stem seals. Owners of the 2001 report it as the top problem, at around 80,000 miles.
- What to do
- Check the oil every fill-up and never let it run low. A compression and leak-down test will show whether rings or valve seals are to blame before you spend money.
Timing belt breaks and damages the engine
- What you'll notice
- The engine suddenly stops while driving and won't restart, sometimes after a slapping or ticking noise from the front of the engine.
- Why it happens
- Prelude engines are interference designs, so when the timing belt snaps the pistons hit the valves. Owners report broken belts around 110,000 miles and costly engine repairs.
- What to do
- If there's no record of a timing belt change, have the belt, tensioner and water pump replaced now. It is much cheaper than repairing bent valves.
Engine stalls or won't start from failed igniter
- What you'll notice
- The engine cuts out while driving or cranks but won't start, often when hot, with no spark.
- Why it happens
- The ignition module (igniter) and coil sit inside the distributor and can fail with heat and age. When the igniter fails, spark stops completely.
- What to do
- Have spark checked while the problem is happening. Because the igniter is built into the distributor, many shops replace the whole unit.
Ignition switch can wear and stall the engine (recall)
- What you'll notice
- The engine suddenly cuts out while driving, sometimes with dash lights flickering.
- Why it happens
- Contacts inside the ignition switch wear from high current and can briefly lose connection.
- What to do
- Check the VIN for recall 02V-120 and have the switch replaced. Stalling in traffic is a crash risk.
Free at a Honda dealer under recall 02V-120 if it was never done.
Key can be removed without the car in Park (recall)
- What you'll notice
- The key comes out of the ignition even though the shifter is not in Park, so the car can roll away.
- Why it happens
- The ignition interlock lever on automatic cars can fail to block the key.
- What to do
- Check the VIN for recall 05V-025 and have the redesigned lever installed. Always set the parking brake.
Free at a Honda dealer under recall 05V-025 if it was never done.
Distributor wear causing misfires and power loss
- What you'll notice
- Rough idle, misfires, hesitation, loss of power, and worse fuel economy, sometimes with a check engine light.
- Why it happens
- Worn shaft bushings in the distributor let the rotor wobble, which upsets the spark timing and strength.
- What to do
- Rule out spark plugs, wires, cap and rotor first, then have the distributor tested. A replacement distributor usually fixes it.
Warped front brake rotors
- What you'll notice
- The steering wheel shakes or the brake pedal pulses when stopping, especially from highway speed.
- Why it happens
- The front rotors on the Prelude are known to warp, which RepairPal lists among the model's common problems.
- What to do
- Have the rotors measured. They can sometimes be machined, but new rotors with new pads are usually the better fix.
Oil leak at the distributor
- What you'll notice
- Oil wetting the end of the cylinder head and the distributor base, or a burning oil smell. If oil gets inside the distributor, misfires follow.
- Why it happens
- The O-ring and shaft seal where the distributor plugs into the cylinder head harden and leak with age.
- What to do
- Replace the O-ring early; it is cheap. If oil is inside the distributor cap, the internal seal is leaking and the distributor may need rebuilding.
Repair prices for your 1999 Honda Prelude
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace piston rings and valve seals (engine rebuild)
- Replace timing belt, tensioner and water pump (preventive)
- Replace distributor assembly
- Replace igniter/ignition coil or distributor
- Replace distributor O-ring
- Replace front brake pads and rotors
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…