Your 2019 Hyundai Ioniqproblems, repair costs and recalls
What we've documented about the 2019 Hyundai Ioniq: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2019 Hyundai Ioniq
15 documented issues apply to 2019, most serious first.
Reduced power or creeping forward from a bad charger ground (recall)
- What you'll notice
- The car suddenly enters a low-power mode, or keeps moving forward briefly after you lift off the accelerator.
- Why it happens
- A poor electrical ground at the onboard charging module can upset the drive system, putting the car into fail-safe mode.
- What to do
- Have a dealer check the VIN and perform the recall repair. Until then, be ready to brake firmly if the car behaves oddly.
Rear lug nuts may be loose (recall)
- What you'll notice
- A clicking or clunking from a rear wheel, vibration, or in the worst case a wheel coming off.
- Why it happens
- Right-side rear lug nuts on some cars were not tightened enough at the factory.
- What to do
- If you hear clicking from a wheel, stop and check the nuts. Have a dealer inspect and torque them under the recall.
Braking feels uneven when switching from regenerative to friction brakes
- What you'll notice
- Brake force changes without pedal input, the car lurches, or stopping power drops for a second, especially on wet roads when ABS engages.
- Why it happens
- These cars blend regenerative braking with the normal hydraulic brakes. Owners report rough or incomplete handoffs between the two, and Hyundai issued a software update for brake pedal sensitivity on 2019 models.
- What to do
- Have a dealer check for brake system software updates and inspect the brakes. Leave extra following distance until it is resolved.
Car won't start or shuts down from a weak 12V battery
- What you'll notice
- The car won't power on, locks itself, or the electrical system shuts down; the instrument cluster may go blank.
- Why it happens
- The small 12-volt system can be drained by a fault or simply wear out. On the hybrid the 12V lithium battery is built into the hybrid battery pack and has a reset button on the dash; the Electric uses a conventional 12V battery.
- What to do
- On the hybrid, press the 12V BATT RESET button. If it keeps happening, have the 12V battery tested and a drain test done.
Jerky or hesitant low-speed shifts from the dual-clutch transmission
- What you'll notice
- Lurching, jerking or hesitation when pulling away, at very low speed, or when the transmission downshifts during regenerative braking.
- Why it happens
- The Ioniq hybrid and plug-in use a 6-speed dual-clutch automatic, which can engage roughly at low speed. Some owners also report a sudden jerk when releasing the brake in Drive.
- What to do
- Ask a dealer to check for software updates for the transmission and hybrid control unit. If the shifts are getting worse or come with a warning light, have it diagnosed.
Electronic parking brake and Auto Hold warnings
- What you'll notice
- The EPB and Auto Hold lights come on with a chime, Auto Hold stops working, or the parking brake won't apply or release. The lights often clear after a restart and then return.
- Why it happens
- Hyundai issued bulletins for parking brake motor fault codes C2416/C2417, including ones set by vibration. Causes include a software issue, wiring shorts and failing rear caliper motors.
- What to do
- Use the regular brake firmly when stopped and do not rely on the parking brake until it is fixed. Ask a dealer about the parking brake software update and wiring checks.
Hybrid warning lights from motor or control unit faults
- What you'll notice
- A hybrid system or check engine warning, sudden loss of power, or the car slowing hard on a hill.
- Why it happens
- Hyundai issued bulletins for hidden fault codes in the hybrid control unit and DC converter on 2019-2021 hybrids, fixed by a software update, and for traction motor fault codes.
- What to do
- Have the codes read at a Hyundai dealer and ask about the hybrid control unit software update.
High-voltage battery precharge fault code
- What you'll notice
- A hybrid warning light and code P1B77; the car may not go into Ready mode.
- Why it happens
- The battery management software could log a precharge fault. Hyundai released a service campaign with updated software.
- What to do
- Ask a dealer whether the battery management software campaign was done.
Electric water pump leak or overheating
- What you'll notice
- Coolant loss, overheating warnings, or warning lights; some owners report the car shutting down.
- Why it happens
- Hyundai ran a service campaign to inspect the electric water pump assembly, and owners report pumps leaking.
- What to do
- Check the coolant level and have the dealer confirm the water pump campaign. Stop driving if the car overheats.
Check engine light from a tiny EVAP leak code
- What you'll notice
- Check engine light with code P0456, usually with no change in how the car drives.
- Why it happens
- Hyundai issued bulletins and a service campaign to add an air filter kit to the evaporative emissions system, which can falsely detect a small leak, especially in coastal areas.
- What to do
- Make sure the fuel cap clicks shut. Ask a dealer whether the EVAP filter campaign applies to your VIN.
Clunk or rattle from the steering column
- What you'll notice
- A knock, rattle or clunk felt in the steering wheel over bumps or when turning at low speed.
- Why it happens
- The bearing for the worm shaft in the electric power steering column wears. Hyundai issued several bulletins to replace the worm shaft bearing or assembly.
- What to do
- Have a dealer check for the steering column bulletins. It is mainly a noise problem but should be fixed.
Check engine light for coolant temperature code P0128
- What you'll notice
- Check engine light with code P0128, with no drivability problem.
- Why it happens
- The engine computer's monitoring logic could set this code. Hyundai issued an ECM software update.
- What to do
- Ask a dealer for the engine computer update.
Blind spot warning system fault
- What you'll notice
- Blind-spot or rear cross-traffic warnings stop working, sometimes with a warning message.
- Why it happens
- Hyundai issued a bulletin for fault codes in the rear bumper radar sensors.
- What to do
- Have the radar sensors checked and recalibrated if needed. Keep checking your mirrors in the meantime.
Wireless phone charger won't charge
- What you'll notice
- Your phone does not charge on the wireless pad.
- Why it happens
- Hyundai issued a bulletin with a diagnostic procedure for some charging pads not charging.
- What to do
- Try removing the phone case. If it still fails, have the pad diagnosed.
Condensation inside headlights or taillights
- What you'll notice
- Fog or droplets inside the headlights, taillights or fog lamps.
- Why it happens
- Hyundai issued information bulletins on moisture in vented lamps; light fog can be normal, but pooled water is not.
- What to do
- If water collects or stays, have the lamp inspected for a damaged seal or crack.
Repair prices for your 2019 Hyundai Ioniq
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Test 12V system and find drain or replace 12V battery
- Diagnose and update transmission and hybrid software
- Install EVAP air filter kit (campaign)
- Update parking brake software or replace rear caliper motor
- Replace steering column worm shaft bearing
- Brake system software update and inspection
- Update hybrid control unit and DC converter software
- Battery management software update (campaign)
- Inspect or replace electric water pump
- ECM software update
- Diagnose and recalibrate blind spot radar
- Diagnose or replace wireless charging pad
- Reseal or replace lamp assembly
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…