Your 2003 Hyundai Tiburonproblems, repair costs and recalls
What we've documented about the 2003 Hyundai Tiburon: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Hyundai Tiburon
14 documented issues apply to 2003, most serious first.
Clutch slipping or wearing out early
- What you'll notice
- The engine revs climb but the car doesn't speed up to match, especially in higher gears or on hills. Some owners notice grinding, shudder, a burning smell or a clutch that suddenly stops working.
- Why it happens
- Clutch and flywheel wear is the most-reported problem on the second-generation Tiburon, with many manual-transmission cars needing a clutch well before 50,000 miles. Some cars needed more than one clutch.
- What to do
- Have the clutch checked as soon as it slips; slipping gets worse quickly and can damage the flywheel. Ask for a clutch kit and flywheel inspection or replacement at the same time.
Timing belt due or broken
- What you'll notice
- Usually no warning. A worn belt may squeal or tick; if it breaks, the engine stalls and won't restart.
- Why it happens
- Every Tiburon engine uses a rubber timing belt with a set replacement interval. When it breaks, the engine stops and can suffer valve damage.
- What to do
- If there's no record of a belt change in the last 60,000 to 100,000 miles, have it done now, along with the tensioner and water pump. Don't keep driving if you suspect the belt is failing.
Seat belt buckle wiring can stop the airbag from working (recall)
- What you'll notice
- The airbag light may be on, or there may be no warning at all.
- Why it happens
- The driver seat height adjuster can pinch and damage the seat belt buckle wiring, which can keep the airbag from deploying in a crash.
- What to do
- Check the VIN for open recalls and have a dealer inspect and repair the wiring free of charge.
Passenger airbag may not open properly (recall)
- What you'll notice
- No symptoms. You may have received a recall letter about the passenger airbag.
- Why it happens
- The instrument panel on some 2003 cars was not torn in the right pattern for the passenger airbag to deploy as designed.
- What to do
- Confirm with a dealer that the recall was done.
Rear brake lines can rub through and leak (recall)
- What you'll notice
- A soft or sinking brake pedal, a brake warning light, or brake fluid on the ground.
- Why it happens
- Rear brake tubes could contact steering gearbox brackets and wear through, leaking brake fluid and reducing braking.
- What to do
- If the pedal is soft, stop driving. Have a dealer check the VIN and reroute or replace the lines under the recall.
Fuel tank valve may leak fuel in a rollover (recall)
- What you'll notice
- No symptoms in normal driving.
- Why it happens
- A valve in the fuel tank may not close completely, so fuel could spill in a rollover crash and start a fire.
- What to do
- Ask a dealer to confirm the fuel tank valve recalls were completed.
Front lower control arms rust through (recall)
- What you'll notice
- Clunks from the front end, a wheel that tilts or shifts, or the car hopping when braking.
- Why it happens
- In road-salt states the front lower control arms can corrode and crack. Owners report failures even after the recall inspection.
- What to do
- Have the control arms inspected for rust and the recall checked. Replace any arm that shows perforation.
If the recall has already been done and the arm rusts again, you will pay for a new arm plus an alignment.
Melted climate control switch or wiring
- What you'll notice
- A burning plastic smell, smoke from the dash, or the fan and climate controls stop working.
- Why it happens
- Owners report melted climate-control switches, connectors and harness wiring, sometimes more than once.
- What to do
- Stop using the fan and have the wiring inspected right away if you smell burning. Replace damaged connectors, not just the switch.
Clutch pedal sticks or won't go into gear from a hydraulic leak
- What you'll notice
- The clutch pedal feels soft, sinks to the floor, or sticks down, and the car grinds or refuses to go into gear.
- Why it happens
- The clutch master or slave cylinder leaks internally or externally, so the clutch no longer fully releases.
- What to do
- Check the clutch fluid reservoir (it shares fluid with the brakes on many cars) and look for wetness near the pedal or transmission. Replace the leaking cylinder and bleed the system.
Airbag warning light stays on
- What you'll notice
- The airbag (SRS) light stays lit or comes and goes, sometimes with a seat belt chime.
- Why it happens
- Damaged wiring at the seat belt buckle under the seat, a faulty buckle sensor, or a failed airbag control module are common causes reported by owners.
- What to do
- Have the SRS codes read. Airbags may not work properly while the light is on, so get it fixed rather than just reset.
Turn signals or hazards stuck on from a failed body control module
- What you'll notice
- Turn signals or hazard lights stay on, won't cancel or stop working. Sunroof, headlight or door lock problems can show up at the same time.
- Why it happens
- A relay inside the body control module fails, according to many owner reports.
- What to do
- Have the electrical system diagnosed. A replacement body control module, programmed to the car, is the usual fix.
Gas pump clicks off early or fuel smell after filling
- What you'll notice
- The pump keeps shutting off after a gallon or so, filling takes a long time, fuel overflows, or there's a gas smell and a check engine light.
- Why it happens
- The evaporative emissions system (charcoal canister and vent valves) clogs or fails, so air can't escape the tank while filling.
- What to do
- Have the EVAP system tested. The canister, vent valve or filler neck may need replacement.
Harsh or erratic automatic shifts
- What you'll notice
- Rough, late or jerky automatic shifts.
- Why it happens
- Hyundai's guidance is to confirm the transmission computer has the latest software and that the correct transmission fluid is used, since the wrong fluid or old software hurts shift quality.
- What to do
- Ask a dealer to check for transmission software updates before replacing the fluid with the correct type. Avoid shops that use universal fluid.
Power windows stop working
- What you'll notice
- A window won't go up or down, or works only sometimes.
- Why it happens
- Window motors and wiring fail, and some owners report repeat failures.
- What to do
- Have the window motor and switch checked. Close the window first if possible to keep weather out.
Repair prices for your 2003 Hyundai Tiburon
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace clutch kit and resurface or replace flywheel
- Replace clutch master or slave cylinder and bleed
- Replace timing belt, tensioner and water pump
- Repair seat belt buckle wiring or replace buckle sensor
- Replace body control module
- Replace climate control switch and damaged connectors
- Replace EVAP charcoal canister and vent valve
- Replace window motor/regulator
- Update transmission software and change fluid
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
- Inspect and replace front lower control arms under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…