Hyundai Velosterproblems, repair costs and recalls
Problems reported across 2012–2022. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
21 documented issues across all years, most serious first.
Engine knock and connecting rod bearing failure
- What you'll notice
- A knocking or tapping sound from the engine that gets louder with speed, often with a flashing or steady check engine light (code P1326). It can end with the engine losing power or seizing.
- Why it happens
- The 1.6L direct-injection engine in these years is prone to wear of the connecting rod bearings. Once a bearing wears, the engine knocks and can fail. Hyundai's engine class settlement extended the powertrain warranty on these engines to 15 years or 150,000 miles for bearing damage, provided the free knock-sensor software update (KSDS) was installed.
- What to do
- If you hear knocking, stop driving hard and have a Hyundai dealer check it right away. Ask whether your VIN is covered by the extended engine warranty before paying for any repair.
Connecting rod bearings may wear early (recall)
- What you'll notice
- Engine knocking, a check engine light, or the engine stalling. In bad cases oil can leak onto hot parts.
- Why it happens
- Hyundai recalled these 1.6L engines because the connecting rod bearings can wear too soon, which can damage the engine, stall it while driving, or start a fire.
- What to do
- Check your VIN for recall 20V-746. The dealer inspects the engine and installs knock-sensing software, and replaces the engine if it is damaged, at no cost.
Free under recall 20V-746.
Turbo engine damage from pre-ignition (recall)
- What you'll notice
- Usually no warning before damage. Afterward you may notice knocking, loss of power, oil use or a check engine light.
- Why it happens
- The original engine software on the 2013 Veloster Turbo could let fuel ignite too early under load (pre-ignition). That can crack pistons and damage the engine.
- What to do
- Check your VIN for recall 19V-204. The dealer updates the engine software and inspects the engine for damage for free.
Free under recall 19V-204.
Panoramic sunroof glass may break (recall)
- What you'll notice
- A loud bang followed by broken glass from the roof, usually while driving.
- Why it happens
- On some early 2012 cars the panoramic sunroof assembly was weakened when it was installed at the factory, so the glass could shatter while driving.
- What to do
- Check your VIN for recalls 12V-568 and 13V-051. The dealer inspects and repairs the sunroof for free.
Parking brake may not hold or release (recall)
- What you'll notice
- On manual-transmission cars the parking brake may not hold the car, or it may stay partly applied after you release it.
- Why it happens
- Moisture and road grime could make parts of the rear parking brake mechanism stick.
- What to do
- Check your VIN for recall 12V-567 and use a wheel chock on hills until it is fixed.
Rear parking sensor module can short and catch fire (recall)
- What you'll notice
- Parking sensor warnings, constant beeping or a blown fuse. A burning smell near the rear bumper is a warning sign.
- Why it happens
- Water can get into the rear parking-assist circuit board and cause a short, which can lead to a fire even when the car is parked.
- What to do
- Check your VIN for recall 23V-132 and get it done promptly. If you smell burning, park outside away from buildings.
ABS module can leak and start a fire (recall)
- What you'll notice
- The ABS warning light may come on. In rare cases smoke or a burning smell comes from the engine bay, even with the car off.
- Why it happens
- Brake fluid can leak inside the anti-lock brake (ABS) control unit and cause an electrical short, which can start a fire.
- What to do
- Check your VIN for recall 23V-651. Park outside and away from buildings until the dealer installs the new fuse.
Driver door can open in a side crash (recall)
- What you'll notice
- No symptom in daily driving. Some owners notice the driver door is hard to open.
- Why it happens
- The lower window channel can damage the driver's door latch housing and lock cable in certain side impacts, letting the door open.
- What to do
- Check your VIN for recall 19V-311. The dealer replaces the latch and channel parts for free.
Engine damage from faulty piston oil rings (recall)
- What you'll notice
- Knocking, oil burning, low oil, a flashing check engine light, loss of power, or the engine stalling. Oil may leak onto hot parts.
- Why it happens
- Some oil control rings in the 2.0L engine were not heat-treated correctly. They can break and scratch the cylinder walls, which leads to oil burning and engine damage.
- What to do
- Check your VIN for recall 21V-301. The dealer installs engine-noise monitoring software and replaces the engine if it is damaged, at no cost.
Free under recall 21V-301.
High-pressure fuel pump wear can cause power loss (recall)
- What you'll notice
- Sudden loss of power, rough idle, a loud misfire, and a check engine light, often at low speed.
- Why it happens
- A valve inside the Veloster N's high-pressure fuel pump can wear and let too much fuel through, making the engine run very rich and lose power.
- What to do
- Check your VIN for recall 24V-528. The dealer updates the engine software and replaces the pump if needed, free.
Free under recall 24V-528.
Dual-clutch oil pump fault can cut drive power (recall)
- What you'll notice
- Warning lights and a fail-safe message, then after about 20–30 seconds the car loses drive power, even at speed.
- Why it happens
- The high-pressure electric oil pump inside the 8-speed wet dual-clutch transmission can fault. The fail-safe logic then disengages the clutches.
- What to do
- Check your VIN for recall 22V-746. The dealer inspects the transmission, replaces it if needed, and updates the software for free.
Free under recall 22V-746.
Dual-clutch hesitation, jerking or limp mode
- What you'll notice
- On cars with the automatic dual-clutch transmission, the car hesitates or jerks when pulling away, shifts roughly at low speed, or drops into a reduced-power limp mode with a warning light.
- Why it happens
- The dual-clutch automatic works like two computer-controlled manual clutches. Clutch wear and control software calibration cause hesitation and shudder, especially in stop-and-go traffic. Hyundai issued software updates for the transmission.
- What to do
- Ask a Hyundai dealer to check for transmission software updates and stored codes. If the shudder keeps getting worse, the clutch pack may need replacing.
Panoramic sunroof glass shatters
- What you'll notice
- The sunroof glass suddenly breaks with a loud pop, sometimes when parked and sometimes while driving.
- Why it happens
- Owners have reported the moving glass panel of the panoramic sunroof shattering on its own. Hyundai extended the warranty on that glass to 10 years or 120,000 miles.
- What to do
- Keep the sunshade closed if glass has cracked and get it replaced. Ask a Hyundai dealer whether the extended sunroof glass warranty covers your car.
Airbag light, dead horn or steering buttons from a failed clock spring
- What you'll notice
- The airbag warning light comes on, the horn stops working, or the steering-wheel buttons stop responding.
- Why it happens
- The clock spring is a coiled ribbon cable behind the steering wheel that carries power to the airbag, horn and buttons. It can break over time. Hyundai extended its warranty to 15 years with unlimited miles.
- What to do
- Have the airbag codes read soon, since the driver airbag may not work while the light is on. Ask a dealer about the extended clock spring warranty.
Check engine light for low fuel pressure
- What you'll notice
- A check engine light with code P0087 (low fuel pressure), sometimes with hesitation or weak power.
- Why it happens
- Hyundai found that the fuel feed tube can restrict fuel flow to the high-pressure fuel system. The fix is a replacement tube.
- What to do
- Have the code read and ask the dealer about bulletin 15-01-023. Don't let a low fuel pressure problem go, since it can cause stalling.
12-volt power outlet can overheat (recall)
- What you'll notice
- Usually no warning. In rare cases a burning smell or heat around the accessory outlet.
- Why it happens
- The 12-volt outlet may have been overtightened at the factory, which can disable its thermal fuse and let it overheat.
- What to do
- Avoid using the outlet until the recall work (20V-393) is done at a Hyundai dealer.
Key-start cars are easy to steal
- What you'll notice
- Signs of theft attempts such as a broken steering column cover or a damaged ignition lock, or the car being stolen.
- Why it happens
- Veloster models started with a metal key have no engine immobilizer, and a widely shared method lets thieves start them quickly. Hyundai offers a free software upgrade that stops the engine starting unless the key fob unlocked the car.
- What to do
- Have a Hyundai dealer install the free anti-theft software upgrade, and consider a steering wheel lock.
The software upgrade is free. Repairing a damaged ignition lock after a theft attempt costs extra.
Turbo boost problems from the electric wastegate actuator
- What you'll notice
- A check engine light, boost that surges or drops, a noise from the turbocharger, or reduced power.
- Why it happens
- The 1.6L turbo uses an electric actuator to control boost. When it or its linkage faults, boost goes out of range and the engine limits power. Hyundai issued diagnostic bulletins for it.
- What to do
- Have the codes read and ask the dealer to follow the wastegate actuator bulletin before replacing the whole turbo.
Clunk or click in the steering wheel
- What you'll notice
- A clunk, click or knocking felt in the steering wheel when turning, especially at low speed or over bumps.
- Why it happens
- The electric power steering motor connects to the steering shaft through a small rubber coupler. The coupler wears out and leaves play, which you feel and hear as a clunk.
- What to do
- This is not usually dangerous, but have it checked. Replacing the rubber coupler is a fairly cheap fix compared with replacing the steering column.
Check engine light from cold-start misfire or thermostat code
- What you'll notice
- A check engine light with misfire codes after a cold start, or code P0128 (engine slow to warm up).
- Why it happens
- Hyundai released engine computer updates for these codes, which could set even when no part had failed.
- What to do
- Ask the dealer whether the engine software update for your car has been done before replacing parts.
Blind spot warning gives false alerts
- What you'll notice
- The blind spot light stays on or flashes with no car beside you, or misses cars that are there.
- Why it happens
- Owners of the Veloster N report false or missed blind spot alerts, often after changing tires. Hyundai issued a software bulletin for the N's blind spot system.
- What to do
- Ask the dealer for the blind spot software update. Always check over your shoulder before changing lanes.
Repair prices for your Hyundai Veloster
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine long block
- Replace dual-clutch assembly and relearn
- Replace panoramic sunroof moving glass
- Replace power steering motor rubber coupler
- Replace steering wheel clock spring
- Replace fuel feed tube
- Replace electric wastegate actuator
- Engine computer software update
- Blind spot radar software update and calibration
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect engine, install knock-sensing software, replace engine if damagedNo charge if your vehicle is included
- Update engine software, inspect engine and repair if damagedNo charge if your vehicle is included
- Inspect and repair panoramic sunroofNo charge if your vehicle is included
- Inspect and repair rear parking brake mechanismNo charge if your vehicle is included
- Inspect and replace 12-volt accessory outletNo charge if your vehicle is included
- Repair rear parking-assist sensor circuitNo charge if your vehicle is included
- Install new ABS fuse per recallNo charge if your vehicle is included
- Install anti-theft software upgradeNo charge if your vehicle is included
- Replace driver door latch and window channelNo charge if your vehicle is included
- Install engine-noise software, inspect and replace engine if damagedNo charge if your vehicle is included
- Update engine software and replace high-pressure fuel pump if neededNo charge if your vehicle is included
- Inspect transmission, replace if needed, update softwareNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.