Your 2003 Hyundai XG300 / XG350problems, repair costs and recalls
What we've documented about the 2003 Hyundai XG300 / XG350: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Hyundai XG300 / XG350
11 documented issues apply to 2003, most serious first.
Front subframe rusts through (recall)
- What you'll notice
- Clunks or creaks from the front end, the steering pulling to one side, uneven tire wear, or visible rust holes near the front lower control arms.
- Why it happens
- In states that salt their roads, the front subframe rusts from the inside. If it gets bad enough, the lower control arm mount can tear loose, letting the wheel shift into the fender and cutting drive power. Hyundai recalled about 188,000 Sonatas and XGs for this in 2009.
- What to do
- Have the subframe inspected right away if you live in the salt belt. Check the VIN for recall 09V-124; the dealer measures the metal and either replaces the subframe or drills drain holes and rust-proofs it for free. A car with a rotted subframe is unsafe to drive.
Fuel tank valve may leak in a rollover (recall)
- What you'll notice
- No symptoms in normal driving.
- Why it happens
- A valve on the fuel tank may not close fully, so fuel could spill if the car rolls over.
- What to do
- Check the VIN for recall 04V-178. The dealer adds a second fuel tank valve for free.
Engine surges or car lunges forward
- What you'll notice
- The engine speeds up on its own, surges when you press the brake, or the car lunges forward while stopped with your foot on the brake.
- Why it happens
- Most NHTSA engine complaints for these cars are filed under speed control. Hyundai issued several updates for the electronic throttle system on these cars, but no single cause has been confirmed.
- What to do
- If it happens, press the brake firmly and shift to Neutral. Have a dealer scan for throttle codes, check for throttle-system bulletins and file a report with NHTSA.
Harsh, delayed or erratic automatic shifting
- What you'll notice
- Hard or late shifts, the car lurching when you put it in Drive, slipping, or the transmission getting stuck in one gear.
- Why it happens
- Many complaints trace back to old transmission computer software, the wrong fluid, or adaptive settings that need a relearn; worn clutches cause the rest. Hyundai issued bulletins for software, relearning and solenoid codes.
- What to do
- Have the codes read and the fluid level and type checked. Ask for a software check and adaptive relearn before agreeing to a rebuild.
Timing belt wear and slipped timing
- What you'll notice
- Usually no warning. A belt that is old, slipped or broken can cause a rough run, a no-start, or the engine stopping suddenly.
- Why it happens
- These V6 engines use a rubber timing belt that must be replaced on schedule. If it breaks or jumps a tooth the valves can hit the pistons; mechanics also report belts slipping after a poor installation.
- What to do
- Check your records. If there is no proof of a belt change within the owner's manual interval, replace the belt, tensioner and usually the water pump together at a shop that has done this engine before.
Airbag warning light stays on
- What you'll notice
- The airbag (SRS) light comes on at start-up and stays on, or comes and goes. Moving a front seat can trigger it.
- Why it happens
- The most common cause is a loose or strained wiring connector under a front seat, where the harness stretches as the seat moves. Owners also report failed airbag sensors, clock-springs and harnesses.
- What to do
- Get the airbag codes read; the airbags may not work while the light is on. Ask the shop to check the connectors under both front seats first, since that is often the cheapest fix.
Check engine light for lean codes P0171 / P0174
- What you'll notice
- Check engine light, sometimes with a rough idle or hesitation.
- Why it happens
- Both sides of the V6 are running lean, usually from an air leak at the intake or vacuum hoses, a dirty airflow sensor, or weak fuel delivery. Hyundai issued a bulletin for these codes on 2001–2005 XG300 and XG350.
- What to do
- Have a shop smoke-test the intake for leaks and check the airflow sensor and fuel pressure before replacing parts.
Cranks but won't start (crank sensor or reluctor)
- What you'll notice
- The engine cranks normally but will not start, often with no codes.
- Why it happens
- A failed crankshaft position sensor is a common cause. After timing belt work, the sensor's reluctor (trigger wheel) on the crank sprocket can slip and throw off spark timing.
- What to do
- Have a shop check spark and the crank sensor signal before replacing parts, especially if the timing belt was just done.
Clunk or grinding from torn CV axle boots
- What you'll notice
- Clicking when turning, a clunk when pulling away, or grease sprayed inside the wheel.
- Why it happens
- The rubber boot on a front axle can split, letting grease out and dirt in, which wears out the CV joint.
- What to do
- Have the boots inspected. Replacing a torn boot early costs much less than replacing the axle.
Gas pump keeps clicking off or fuel spits back
- What you'll notice
- The pump nozzle shuts off over and over, so you can only add a little fuel at a time, or fuel splashes back out of the filler.
- Why it happens
- Owners link this to a restricted fuel tank vent or filler neck; the exact cause varies from car to car.
- What to do
- Fill slowly with the nozzle at a lower flow setting. Have a shop check the filler neck, tank vent valves and the charcoal (EVAP) canister if it keeps happening.
Rough idle from faulty EGR switching valve
- What you'll notice
- The idle is rough or unsteady, on and off.
- Why it happens
- A faulty exhaust gas recirculation (EGR) switching valve can let exhaust into the intake at the wrong time. Hyundai issued an EGR diagnosis bulletin.
- What to do
- Have the EGR switching valve and its hoses tested. It is an inexpensive part.
Repair prices for your 2003 Hyundai XG300 / XG350
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose airbag light and repair under-seat connectors or replace failed sensor
- Diagnose and repair fuel filler neck or tank vent (EVAP) parts
- Diagnose throttle and idle control system
- Smoke-test intake and repair vacuum leak
- Replace EGR switching (control) solenoid valve
- Transmission software check, adaptive relearn and fluid change
- Replace timing belt and tensioner (often with water pump)
- Replace crankshaft position sensor
- Replace CV axle boot
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…