Your 2010 Infiniti FX / QX70problems, repair costs and recalls
What we've documented about the 2010 Infiniti FX / QX70: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Infiniti FX / QX70
9 documented issues apply to 2010, most serious first.
Wheel bearing hum or growl
- What you'll notice
- A humming, growling or roaring noise that rises with speed and may change when you steer left or right. In bad cases the ABS light can come on or the wheel feels loose.
- Why it happens
- Wheel bearings on the FX wear out early. They are the most-reported repair on these SUVs in owner surveys, especially at the front.
- What to do
- Have the wheels checked for play and noise. A worn bearing gets louder and can eventually fail, so do not leave it for long.
Stalling from a failing cam or crank sensor
- What you'll notice
- The engine stalls, cuts out, runs rough or cranks without starting, often with a check engine light.
- Why it happens
- Camshaft and crankshaft position sensors on these V6 and V8 engines fail with age and are a known repair on the FX.
- What to do
- Have the codes read. Sensors are fairly cheap to replace, and a stall in traffic is dangerous.
Worn control arm bushings
- What you'll notice
- Clunks over bumps, a loose or wandering feel, shaking when braking, or uneven tire wear.
- Why it happens
- The rubber bushings in the control arms and tension struts wear out, letting the suspension move more than it should.
- What to do
- Have the front suspension inspected. Worn arms are usually replaced in pairs, followed by an alignment.
Worn tie rod ends
- What you'll notice
- Steering feels loose, the SUV wanders, there is a knock over bumps, or the front tires wear on the edges.
- Why it happens
- The tie rod ends that connect the steering rack to the wheels wear out over time and are among the common FX repairs.
- What to do
- Get the steering checked. Replace worn tie rod ends and get an alignment, since a failed one can affect control.
Sticking brake caliper
- What you'll notice
- The SUV pulls to one side, a burning smell or heat from one wheel, or brake pads wearing out unevenly.
- Why it happens
- A brake caliper can seize or its slide pins can stick, so the pads keep dragging on the rotor. Calipers are a frequent repair on the FX.
- What to do
- If one wheel is much hotter than the others after driving, have the brakes checked soon. Replace the caliper and service the pins.
Harsh or erratic shifting
- What you'll notice
- Rough, late or jerky shifts, especially at low speeds or between the lower gears.
- Why it happens
- Owners of second-generation FX models report shift quality problems with the 7-speed automatic. A software update (reflash) from the dealer usually fixes it.
- What to do
- Ask a dealer to check for transmission software updates before replacing parts. Also check the fluid condition.
Exhaust rattle or leak
- What you'll notice
- A metallic rattle from underneath at idle or low speeds, or a louder exhaust note.
- Why it happens
- Exhaust heat shields rust and loosen, and the flex pipe and mid pipe can crack and leak.
- What to do
- Have the exhaust looked at on a lift. Loose shields can often be clamped; a leaking flex pipe should be replaced.
Exterior door handle breaks
- What you'll notice
- An outside door handle feels loose, snaps or stops opening the door.
- Why it happens
- The exterior door handles on the FX are a known weak point and break with use.
- What to do
- Replace the handle. It is a simple repair, but paint-matched handles cost more.
Door lock actuator fails
- What you'll notice
- One door will not lock or unlock with the remote or the switch, or the lock makes a buzzing noise.
- Why it happens
- The electric lock actuator inside the door wears out.
- What to do
- Replace the actuator in the affected door.
Repair prices for your 2010 Infiniti FX / QX70
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front wheel hub and bearing assembly (one side)
- Replace camshaft or crankshaft position sensor
- Replace front lower control arms or tension struts (pair) and align
- Replace outer tie rod ends (pair) and align
- Replace one brake caliper and bleed brakes
- Repair heat shields or replace exhaust flex pipe
- Replace exterior door handle
- Replace door lock actuator
- Transmission software update and fluid check
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…